brake sensor GENESIS G90 2023 Owners Manual

3-31
03
Pre-active Safety Seat (PSS) (if
equipped)
When Pre-active Safety Seat detects
a collision or hazardous situation, it
provides safety by repositioning the seat
as follows:

[Seatback (power passenger seat and
rear seat): Raises the seatback when
reclined.

[Seat cushion (power rear seat): If
the cushion height is low, raises the
cushion.
WARNING
Pre-active Safety Seat is a
supplementary device. The driver
should keep their eyes on the road and
verify that there are no obstructions
ahead. If there are no passengers or the
seatbelts are not fastened, the system
will not function.
System operation

[Pre-active Safety Seat limits
passenger’s movement and helps
decrease the chance of injury by
raising the seatback right before
collision to tighten the seatbelt.
The system may operate under the
following situations:
- The brake pedal was depressed
abruptly.
- The vehicle is difficult to control.
- Collision risk is considered high by
the vehicle distance sensor.
[Pre-active Safety Seat helps prevent
the passenger from leaning forward
or to the side by raising the seatback
during sudden braking or rapid
turning to tighten the seatbelt.
The system may operate under the
following situations:
- The upper body is leaned forward
due to sudden braking.
- The upper body is leaned to the side
due to rapid turning.
- Driving on a slippery icy road.
- There is high risk of a rollover.
System pause
If the passenger adjusts the seat
manually, the system stops immediately.
However, it restarts to operate after 5
seconds when the hazardous situation
continues.
System malfunction
If the Pre-active Safety Seat system does
not operate properly, have the vehicle
inspected by an authorized retailer of
Genesis Branded products.

3-77
03
ORS031082L
Just before impact, drivers often brake
heavily. Such heavy braking lowers the
front portion of the vehicle causing it
to “ride” under a vehicle with a higher
ground clearance. Air bags may not
inflate in this “underride” situation
because deceleration forces that are
detected by sensors may be significantly
reduced by such “underride” collisions.
ORS031083
Front air bags may not inflate in
rollover accidents because front air bag
deployment would not provide additional
occupant protection.
Information
With rollover sensor
The side and curtain air bags and the
front center side air bag may inflate in a
rollover situation, when it is detected by
the rollover sensor.
ORS031084L
Air bags may not inflate if the vehicle
collides with objects such as utility poles
or trees, where the point of impact is
concentrated and the collision energy is
absorbed by the vehicle structure.

5-104
Convenience Features
EXTERIOR LIGHTS
Lighting Control
To operate the lights, turn the knob at
the end of the control lever to one of the
following positions:
OJX1059057
M OFF
N AUTO headlight
O Parking lamp
P Headlight
Daytime Running Light (DRL)
The Daytime Running Lights (DRL) can
make it easier for others to see the front
of your vehicle during the day, especially
after dawn and before sunset.
The DRL system will turn the dedicated
lamp OFF when:

[The headlights are ON.

[The parking brake is applied.

[The vehicle is turned off.
$872KHDGOLJKW
ORS051076
The parking lamp and headlight will
be turned ON or OFF automatically
depending on the amount of daylight as
measured by the ambient light sensor M
at the upper end of the windshield glass.
Even with the AUTO headlight feature
in operation, it is recommended to
manually turn ON the headlights when
driving at night or in a fog, driving in the
rain, or when you enter dark areas, such
as tunnels and parking facilities.
NOTICE

[Do not cover or spill anything on the
sensor M located at the upper end of
the windshield glass.

[Do not clean the sensor using
a window cleaner, the cleanser
may leave a light film which could
interfere with sensor operation.

[If your vehicle window is tinted or
other types of metallic coating are
on the front windshield, the AUTO
headlight system may not work
properly.

6-49
06
Idle Stop and Go helps reduce fuel
consumption by automatically shutting
down the engine, when the vehicle is
at a standstill (for example, red stop
light, stop sign, and traffic jam) subject
to certain prerequisite conditions being
satisfied as listed below.
The engine is automatically started upon
satisfying the starting conditions.
ISG system is always active, when the
engine is running.
Information
When the engine is automatically started
by ISG system, warning lights (for
example, ABS, ESC, ESC OFF, MDPS,
and parking brake warning light) may
illuminate for a few seconds due to low
battery voltage.
However, it does not indicate a
malfunction with ISG system.
ISG System Operation
Prerequisite for activation
ISG system operates in the following
situations.

[The driver's seatbelt is fastened

[The driver's door and hood are closed

[The battery sensor is activated and
the battery is sufficiently charged

[Outside temperature is not too low or
too high

[The vehicle is driven over a constant
speed and stops

[The climate control system satisfies
the conditions

[The vehicle is sufficiently warmed up

[ISG related parts are working properly

[The incline is gradual

[The steering wheel is turned less than
180 degrees and then the vehicle
stops
Information
ORS062070C
ISG system is not activated, when the
prerequisites to activate the ISG system
are unsatisfied.
Auto stop
When ISG is on the engine will be
stopped automatically when both of the
following occurs:
1. Vehicle speed decreases to 0mph (0
km/h) full stop condition.
2. Brake pedal is depressed and gear is
in D (Drive) or N (Neutral).
The Auto Stop (
) indicator illuminates
in green on the instrument cluster, when
the engine stops.
The gasoline 3.5 turbo 48 V electric
supercharger vehicle may automatically
shut down the engine when the vehicle
speed is below 16 mph (25 km/h) with
the brake pedal depressed. At this time,
the ISG indicator lights up in green on
the instrument cluster.
Information
Idle stop cannot reoccur again until the
vehicle speed goes above 3 mph (5 km/h)
and then returns again to the automatic
stop conditions as previously mentioned.
,'/(6723$1'*2

6-53
06
Calibrating the Battery Sensor
If the AGM battery is reconnected or
replaced, ISG system will not operate
immediately. If you want to use the
system, the battery sensor needs to
be calibrated following the below
procedure.
ORS061023LA : Battery sensor
1. Turn off the engine.
2. Disconnect all electronic devices
that were additionally installed after
the vehicle was delivered, such as
navigation, dashcam, etc.
3. After 4 hours with the engine off, turn
the engine on and off 3 to 4 times.
Information
The ISG system may not operate in the
following situations.
-There is a malfunction with the ISG
system.
-The battery is weak.
-The brake vacuum pressure is low.
If this occurs, have the ISG system
checked by an authorized retailer of
Genesis Branded products.
NOTICE

[Use only a genuine Genesis ISG
battery for replacement. If not,
the ISG system may not properly
operate.

[Do not recharge the ISG battery with
a general battery charger. It may
damage or explode the ISG battery.

[Do not remove the battery cap. The
battery electrolyte, which is harmful
to the human body, may leak out.

7-36
Driver Assistance System
ORS071042
When you are driving forward out of a
parking space, if Blind-Spot Collision-
Avoidance Assist judges that there is
a collision risk with an approaching
vehicle in the blind spot, it can help avoid
collision by applying the brake.
Detecting sensor
ORS071001
ORS072292
ORS072003N
M: Front view camera,
N: Front radar,
O: Front corner radar,
P: Rear corner radar
Refer to the picture above for the
detailed location of the detecting
sensors.

7-90
Driver Assistance System

[Driving on an inclined road
ORS071067
During uphill or downhill driving,
Smart Cruise Control may not detect
a moving vehicle in your lane, and
cause your vehicle to accelerate to
the set speed. Also, vehicle speed will
rapidly decrease when the vehicle
ahead is detected suddenly.
Select the appropriate set speed on
inclines and apply the brake pedal or
accelerator pedal according to the
road and driving conditions ahead.
[Changing lanes
ORS071194 A: Your vehicle,
B: Lane changing vehicle
When a vehicle moves into your lane
from an adjacent lane, it cannot be
detected by the sensor until it is in the
sensor's detection range. Smart Cruise
Control may not immediately detect
the vehicle when the vehicle changes
lanes abruptly. In this case, you must
maintain a safe braking distance, and
if necessary, depress the brake pedal
to reduce your driving speed in order
to maintain a safe distance.

7-91
07

[Situations when detecting are limited
ORS071046
ORS071047
In the following cases, some vehicles,
pedestrians or animals in your lane
cannot be detected by the sensor:
- Vehicles offset to one side
- Slow-moving vehicles or sudden-
decelerating vehicles
- Vehicles with higher ground
clearance or vehicles carrying loads
that stick out of the back of the
vehicle
- Vehicles that has the front lifted
dueto heavy loads
- Vehicles within approximately 6 ft.
(2m) from your vehicle
- Oncoming vehicles
- Stopped vehicles - Vehicles with small rear profile, such
as trailers
- Narrow vehicles, such as
motorcycles or bicycles
- Special vehicles
- Animals and pedestrians
Adjust your vehicle speed by
depressing the brake pedal according
to the road and driving conditions
ahead.
In the following cases, the vehicle
in front cannot be detected by the
sensor:
- You are steering your vehicle
- Driving on narrow or sharply curved
roads

7-142
Driver Assistance System
3DUNLQJ&ROOLVLRQ$YRLGDQFH
Assist Operation
Operating conditions
Select ‘Rear Safety’ from the ‘Parking
Safety’ menu of the infotainment system.
Parking Collision-Avoidance Assist is
enabled when the following conditions
are satisfied:
Rear Safety

[The trunk and door are closed

[The Electronic Parking Brake (EPB) is
released

[A trailer is not connected

[The gear is shifted to R (Reverse)

[Vehicle speed is below 6 mph (10
km/h) (detecting pedestrians)

[Vehicle speed is below 2 mph (4 km/h)
(detecting objects)

[Parking Collision-Avoidance Assist
components such as the wide-rear
view camera and the rear ultrasonic
sensors are in normal conditions
)URQW6LGH6DIHW\

[The trunk and door are closed

[The Electronic Parking Brake (EPB) is
released

[A trailer is not connected

[The gear is shifted to R (Reverse) or D
(Drive)

[Vehicle speed is below 2 mph (4 km/h)
(for pedestrians, objects)

[Parking Collision-Avoidance Assist
components such as the wide-rear
view camera and the rear ultrasonic
sensors are in normal conditionsWhen Parking Collision-Avoidance Assist
activates, a line appears behind the
vehicle image in the instrument cluster.

[Rear Safety: Behind the vehicle image

[Front/Side Safety: In front of vehicle
image
ORS071131
Information
3DUNLQJ&ROOLVLRQ$YRLGDQFH$VVLVW
RSHUDWHVRQO\RQFHDIWHUVKLIWLQJWKHJHDU
to R (Reverse) or D (Drive). To reactivate
3DUNLQJ&ROOLVLRQ$YRLGDQFH$VVLVWVKLIW
the gear from another gear to R (Reverse)
or D (Drive).

7-146
Driver Assistance System

[Problems with the surroundings
- The surrounding is very bright or
very dark
- Outside temperature is very high or
very low
- The wind is either strong (above
12 mph (20 km/h)) or blowing
perpendicular to the bumper
- Objects generating excessive
noise, such as vehicle horns, loud
motorcycle engines or truck air
brakes, are near your vehicle
- An ultrasonic sensor with similar
frequency is near your vehicle
- The road is slippery or inclined
- The image of the pedestrian
in the front view camera is
indistinguishable from the
background
[Problems with pedestrian or object
- The pedestrians are difficult to
detect
- There is ground height difference
between the vehicle and the
pedestrian
- The pedestrian is near the edge of
the vehicle
- The pedestrian is not standing
upright
- The pedestrian is either very short
or very tall to detect
- The pedestrian is wearing clothing
that easily blends into the
background, making it difficult to
detect
- The pedestrian is wearing clothing
that does not reflect ultrasonic
waves well
- Size, thickness, height, or shape
of the object does not reflect
ultrasonic waves well (for example,
low object, narrow object, circular
pillar, small pillar, corners of a
square pillar, bush, curbs, carts,
edge of a wall, etc.)
- The pedestrian or the object is
moving
- The pedestrian or the object is very
close to the vehicle
- There is a large object such as a
wall is behind the pedestrian or the
object
- The object is not located at the front
or rear center of your vehicle
- The object is not parallel to the
bumper
- The pedestrians or objects are close
to the left/right side of the vehicle
- The sensors cannot detect the
pedestrians and objects