tires GMC C-SERIES 1999 User Guide
[x] Cancel search | Manufacturer: GMC, Model Year: 1999, Model line: C-SERIES, Model: GMC C-SERIES 1999Pages: 328, PDF Size: 2.41 MB
Page 152 of 328
yellowblue
4-28
If you have a diesel engine, you may have to run it at a
higher speed to get enough heat. Then, shut the engine
off and close the window almost all the way to preserve
the heat. Start the engine again and repeat this only
when you feel really uncomfortable from the cold. But
do it as little as possible. Preserve the fuel as long as you
can. To help keep warm, you can get out of the vehicle
and do some fairly vigorous exercises every half hour or
so until help comes.Loading Your Vehicle
The GVW/Tire Information label is found on the rear
edge of the driver's door. The label shows the size of
your original tires and the inflation pressures needed to
obtain the gross weight capacity of your vehicle.
This is called the Gross Vehicle Weight Rating
(GVWR). The GVWR includes the weight of the
vehicle, all occupants, fuel and cargo.
ProCarManuals.com
Page 190 of 328
yellowblue
5-34
If a Tire Goes Flat
It's unusual for a tire to ªblow outº while you're driving,
especially if you maintain your tires properly. If air goes
out of a tire, it's much more likely to leak out slowly.
But if you should ever have a ªblowout,º here are a few
tips about what to expect and what to do:
If a front tire fails, the flat tire will create a drag that
pulls the vehicle toward that side. Take your foot off the
accelerator pedal and grip the steering wheel firmly.
Steer to maintain lane position, and then gently brake to
a stop well out of the traffic lane.
A rear blowout, particularly on a curve, acts much like a
skid and may require the same correction you'd use in a
skid. In any rear blowout, remove your foot from the
accelerator pedal. Get the vehicle under control by
steering the way you want the vehicle to go. It may be
very bumpy and noisy, but you can still steer. Gently
brake to a stop
-- well off the road if possible.
If a tire goes flat, the next part tells you what to do.
Changing a Flat Tire
A flat or damaged tire can be a major roadside problem.
You're very likely to have to go for help. Few drivers of
these vehicles have the necessary equipment aboard to
be able to change a flat tire safely. For example, youhave to have a truck jack that can lift several thousand
pounds and a torque wrench that can generate several
hundred foot
-pounds (newton-meters) of twisting force.
So if you're stopped somewhere by a flat or damaged
tire or wheel, you should get expert help right then.
If the correct equipment is available, though, here is the
procedure to follow.
Does the tire still seem to have air under pressure in
it? If so, stand to the side and look at the wheel. See
if it looks like another wheel on the vehicle. If so, go
on to the next step. If it doesn't, or even if you can't
be sure, stop and get expert help.
CAUTION:
Tire-rim assemblies can explode. If you work on
a pressurized tire mounted on a damaged wheel,
the assembly can expand with explosive force
without warning. You and others nearby can be
badly injured. Don't work around a tire that has
air under pressure in it when its wheel is or might
be damaged.
ProCarManuals.com
Page 191 of 328
yellowblue
5-35
If the wheel looks normal, see if the wheel has side
rings and a lock ring around the wheel rim. If so,
they must be seated properly. You can compare with
another wheel on the vehicle as you check for this.
For dual wheels, you have to look between the tires
to make this check. You may not be able to tell
if the side rings or lock rings are seated properly
by looking. If you can't be sure, stop and get
expert help.
CAUTION:
If you work on a pressurized tire mounted on a
damaged wheel, the assembly can expand with
explosive force without warning. You and others
nearby can be badly injured. Don't work around
a tire that has air under pressure in it when its
lock ring or side ring might not be
properly seated.
CAUTION:
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after a time. The wheel could come
off and cause an accident. When you change a
wheel, remove any rust or dirt from the places
where the wheel attaches to the vehicle. In an
emergency, you can use a cloth or a paper towel
to do this; but be sure to use a scraper or wire
brush later, if you need to, to get all the rust or
dirt off.
If the lock ring and side rings seem to be seated
properly (or if the wheel doesn't have these), let the
air out of the tire. You can do this by taking out the
valve core.
If the flat or damaged tire is one of a dual set, let the
air out of both tires of the dual before you take off
the damaged tire and rim assembly.
If you have the correct equipment, put on the spare
wheel and tire assembly.
ProCarManuals.com
Page 192 of 328
yellowblue
5-36
CAUTION:
Never use oil or grease on studs or nuts. If you
do, the nuts might come loose. Your wheel could
fall off, causing a serious accident.
CAUTION:
There are many ways to be hurt badly, or
be killed, while you are trying to change a
truck tire and rim. Follow all of the safety
precautions on the truck jack and
other equipment.
CAUTION: (Continued)
CAUTION: (Continued)
If you try to put air back into a tire that has
run flat, or even a tire that was quite low on
air, without first finding out why it was low
or flat, the tire can have a sudden air
-out.
This could cause you to lose control of the
vehicle and have a serious crash. Don't
refill a flat or very low tire with air without
first having the tire taken off the wheel and
checked for damage.
Use a clip-on chuck and hose extension when you
add air to your tires. You'll need an accurate truck
tire pressure gage. Stand to one side and add the air.
Be sure you don't go over the top inflation pressure
for the tire.
ProCarManuals.com
Page 193 of 328
yellowblue
5-37
CAUTION:
Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel to become loose
and even come off. This could lead to an accident.
Be sure to use the correct wheel nuts. If you have
to replace them, be sure to get new GM original
equipment wheel nuts.
Stop somewhere as soon as you can and have the
nuts tightened with a torque wrench.
See ªTightening the Wheel Nutsº in the Index for
the proper torque for your particular wheel.
NOTICE:
Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage. To avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper
torque specification.
If You're Stuck: In Sand, Mud,
Ice or Snow
In order to free your vehicle when it is stuck, you will
need to spin the wheels, but you don't want to spin your
wheels too fast. The method known as ªrockingº can
help you get out when you're stuck, but you must
use caution.
CAUTION:
If you let your tires spin at high speed, they can
explode, and you or others could be injured. And,
the transmission or other parts of the vehicle can
overheat. That could cause an engine
compartment fire or other damage. When you're
stuck, spin the wheels as little as possible. Don't
spin the wheels above 35 mph (55 km/h) as shown
on the speedometer.
ProCarManuals.com
Page 194 of 328
yellowblue
5-38
NOTICE:
Spinning your wheels can destroy parts of your
vehicle as well as the tires. If you spin the wheels
too fast while shifting your transmission back
and forth, you can destroy your transmission.
Rocking Your Vehicle To Get It Out
First, turn your steering wheel left and right. That will
clear the area around your front wheels. Then shift back
and forth between REVERSE (R) and a forward gear
(or with a manual transmission, between FIRST (1) or
SECOND (2) and REVERSE (R)), spinning the wheels
as little as possible. Release the accelerator pedal while
you shift, and press lightly on the accelerator pedal
when the transmission is in gear. By slowly spinning
your wheels in the forward and reverse directions, you
will cause a rocking motion that may free your vehicle.
If that doesn't get you out after a few tries, you may
need to be towed out. If you do need to be towed out,
see ªTowing Your Vehicleº in the Index.
ProCarManuals.com
Page 199 of 328
6-
yellowblue
6-1
Section 6 Service and Appearance Care
Here you will find information about the care of your vehicle. This section begins with service and fuel information,
and then it shows how to check important fluid and lubricant levels. There is also technical information about your
vehicle, and a part devoted to its appearance care.
6
-2 Service
6
-4 Fuel (Gasoline Engine)
6
-5 Diesel Fuel Requirements and Fuel System
6
-6 Fuels in Foreign Countries (Gasoline Engines)
6
-7 Filling Your Tank
6
-8 Filling a Portable Fuel Container
6
-9 Checking Things Under the Hood
6
-11 Noise Control System
6
-13 Engine Oil (Gasoline Engine)
6
-17 Engine Oil (Caterpillar Diesel Engine)
6
-17 Engine Air Cleaner/Filter
6
-18 Automatic Transmission Fluid
6
-19 Manual Transmission Fluid
6
-20 Rear Axle
6
-20 Rear Axle Shift Motor (Option)
6
-21 Radiator Pressure Cap (Gasoline Engines)
6
-22 Surge Tank Pressure Cap (Diesel Engines)
6
-22 Thermostat6
-23 Engine Coolant (Gasoline Engine)
6
-27 Engine Coolant (Caterpillar Diesel Engine)
6
-28 Power Steering Fluid
6
-29 Windshield Washer Fluid
6
-30 Brakes
6
-36 Electric/Hydraulic Parking Brake Fluid
6
-42 Battery
6
-44 Other Service Items
6
-48 Tires
6
-59 Appearance Care
6
-59 Cleaning the Inside of Your Vehicle
6
-63 Cleaning the Outside Your Vehicle
6
-66 GM Vehicle Care/Appearance Materials
6
-67 Vehicle Identification Number (VIN)
6
-67 Service Parts Identification Label
6
-68 Electrical System
6
-74 Capacities and Specifications
6
-77 Air Conditioning Refrigerants
ProCarManuals.com
Page 231 of 328
yellowblue
6-33 Four-Wheel and Six-Wheel Drum Brakes
(Air Only)
The brake drums should be removed and inspected each
time the tires are removed for rotation or changing.
When you have the front brakes replaced, have the rear
brakes inspected, too.
Brake linings should always be replaced as complete
axle sets.
Brake Pedal Travel
See your dealer if the brake pedal does not return to
normal height, or if there is a rapid increase in pedal
travel. This could be a sign of brake trouble.
Brake Adjustment
Every time you make a brake stop, your brakes adjust
for wear.
Air Brake Systems (If Equipped)
If you have air brakes, it is important to get rid of
moisture in the system. Moisture will damage your
system if it isn't removed daily.There are two ways to do this. One is automatic if your
air
-brake vehicle has the optional moisture ejector. If
your vehicle doesn't have that option, however, you
must drain the air reservoirs every day.
Drain them at full system
pressure. To be sure you're
at full pressure, check
your air pressure gage.
It should read at least
100 psi (692 kPa).
Moisture Ejector (Option)
If you have air brakes with a moisture ejector, the valve
automatically ejects moisture from the reserve tank
when the air compressor cycles.
ProCarManuals.com
Page 246 of 328
yellowblue
6-48 Muffler/Catalytic Converter Assemblies
(Diesel Engines)
Some vehicles equipped with a Caterpillar diesel engine
utilize a catalytic converter
-muffler assembly. If your
vehicle is equipped with a catalytic converter
-muffler,
some special procedures may need to be followed when
servicing your vehicle. Consult your GM Truck dealer
who is an authorized Caterpillar
engine dealer
for service.
To determine your vehicle's muffler type, examine the
muffler outer housing. If your system is a catalytic
converter
-muffler type, the housing will be stamped
with the CAT logo.
Tires
Your new vehicle comes with high-quality tires made by
a leading tire manufacturer. If you ever have questions
about your tire warranty and where to obtain service, see
your GM Warranty booklet for details.
CAUTION:
Poorly maintained and improperly used tires
are dangerous.
Overloading your tires can cause
overheating as a result of too much friction.
You could have an air
-out and a serious
accident. See ªLoading Your Vehicleº in
the Index.
Underinflated tires pose the same danger as
overloaded tires. The resulting accident
could cause serious injury. Check all tires
frequently to maintain the recommended
pressure. Tire pressure should be checked
when your tires are cold.
Overinflated tires are more likely to be cut,
punctured or broken by a sudden
impact
-- such as when you hit a pothole.
Keep tires at the recommended pressure.
Worn, old tires can cause accidents. If your
tread is badly worn, or if your tires have
been damaged, replace them.
ProCarManuals.com
Page 247 of 328
yellowblue
6-49 Inflation -- Tire Pressure
The Certification/Tire label, which is on the driver's
door, shows the correct inflation pressures for your tires
when they're cold. ªColdº means your vehicle has been
sitting for at least three hours or driven no more than
1 mile (1.6 km).
NOTICE:
Don't let anyone tell you that underinflation or
overinflation is all right. It's not. If your tires
don't have enough air (underinflation), you can
get the following:
Too much flexing
Too much heat
Tire overloading
Bad wear
Bad handling
Bad fuel economy.
NOTICE: (Continued)
NOTICE: (Continued)
If your tires have too much air (overinflation),
you can get the following:
Unusual wear
Bad handling
Rough ride
Needless damage from road hazards.
When to Check
Check your tires once a month or more. Also, check the
tire pressure of the spare tire.
How to Check
Use a good quality pocket
-type gage to check tire
pressure. You can't tell if your tires are properly inflated
simply by looking at them. Radial tires may look
properly inflated even when they're underinflated.
Be sure to put the valve caps back on the valve stems.
They help prevent leaks by keeping out dirt
and moisture.
ProCarManuals.com