buttons GMC C-SERIES 1999 Owners Manual

yellowblue
3-5
OFF
Press this button to turn the air conditioning/heating
system off. Pressing OFF will erase the present mode of
operation from the system's memory. Outside air will
still come out of the heater outlet whenever the vehicle
is moving forward.
If the OFF button is pressed, you must press A/C,
MAX or one of the BLEND buttons to turn the system
back on.
Air Conditioning
When you first turn on your vehicle's air conditioning,
open the windows long enough to clear the vehicle of
hot air, then close them. Using the MAX button can also
help. See ªMAX Buttonº earlier in this section for
more information.
For normal cooling on hot days, use A/C with the
temperature selector toward C.
When you press the A/C button to turn the air
conditioner off, the system will operate in the vent
mode. When you turn the air conditioner back on, the
system will operate in the mode you last selected unless
the OFF button was pressed.If your air conditioner develops high system pressure, it
will automatically go into the MAX mode and REC will
light on your display. The A/C system will remain in the
MAX mode, even if you press the MAX button, until
system pressure returns to a normal level.
Heating
On cold days, use HEATER with the temperature
selector all the way toward H. When the inside of the
vehicle has reached a comfortable temperature, maintain
it by using the temperature selector bar.
If your vehicle is equipped with a diesel engine, and the
engine has been idling for a long time when it's cold
outside, your heater may blow out cool air. This is
normal. When you increase the engine speed under load,
your heater should blow out warmer air. If it doesn't,
your coolant level may be low. See ªEngine Coolantº in
the Index to check your coolant level.
While idling your diesel engine, you can use the MAX
button to recirculate the air in the cab to help maintain
interior heat. This will preserve engine coolant temperature
and cab heat when idling cannot be avoided.
Using the MAX button while driving is not recommended
because interior window fogging can result.
ProCarManuals.com

yellowblue
3-8 AM-FM Stereo
Playing the Radio
ON
-OFF: Press the round button to turn the radio on.
Press it again to turn the radio off.
VOLUME: Slide the VOLUME lever to the right to
increase volume or to the left to decrease volume.
CALL: Press this button to display the clock for
a few seconds when the radio is on. To change what is
normally shown on the display (station or time), press
this button and the SET button.Finding a Station
AM/FM: Press this button to switch between AM and
FM. The display shows your selection.
TUNE: Press UP to increase the frequency of a radio
station and DOWN to decrease the frequency of a radio
station. If you press and hold the UP or DOWN button
for more than half a second, the radio will tune rapidly
in that direction.
SEEK: Press SEEK to tune the radio to the next higher
station and stay there.
SCAN: Press SCAN to listen to the next higher
radio station for a few seconds. Press SCAN again
to stop scanning.
PUSHBUTTONS: The six numbered pushbuttons
let you return to your favorite stations. You can set up to
12 stations (six AM and six FM). Just:
1. Turn the radio on.
2. Press AM/FM to select a band.
3. Tune in the desired station.
4. Press SET. (SET will appear on the display and will
blink for about eight seconds.)
ProCarManuals.com

yellowblue
3-9
5. Press one of the six pushbuttons within eight
seconds. In the display, SET will stop blinking
indicating the preset is set. Whenever you press that
numbered button, the station you set will return.
6. Repeat the steps for each pushbutton.
Also, you can use the automatic memory SET button
to set the pushbuttons. You can set up to 12 stations
(six AM and six FM). Just:
1. Press AM/FM to select a band.
2. Press and hold SET. (SET will appear on the display
and will blink.)
3. While pressing the SET button, press the SEEK
button. Release both switches. The radio will
automatically search the band and select radio
stations, up to six, which have good signal strength.Setting the Tone
BAS: Slide this lever left or right to decrease or increase
the bass.
TRE: Slide this lever left or right to decrease or
increase the treble. If a station is weak or noisy, you may
want to decrease the treble.
LOUD: To increase bass and treble at low volumes,
press this button. LOUD will appear in the display. Press
this button again to turn LOUD off.
Adjusting the Speakers
BAL: Slide this lever to the left or right to adjust
the speaker balance between the left and right speakers.
The middle position balances the sound between
the speakers.
FAD: Slide this lever to the left or right to adjust
the speaker balance between the front and rear speakers.
The middle position balances the sound between
the speakers.
ProCarManuals.com