cruise control GMC JIMMY 1997 Owner's Manual

Cruise Control (If Equipped)
With cruise control, you can
maintain
a speed of about
25 mph (40 krn/h) or more
without keeping your foot
on the accelerator. This
can
really help on long trips.
Cruise control
does not
work at speeds below about
25 rnph (40 km/h).
If you have an automatic transmission and you apply
your brakes, the cruise control will shut
off.
If you have a manual transmission and you apply your
brakes or push the clutch pedal, the cruise control
will
shut off.
A CAUi ION:
I
Cruise control can be dangerous where you
can’t drive safely at
a steady speed. So,
don‘t use your cruise control on winding
roads or in heavy traffic.
slippery roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and you could lose control. Don’t
use cruise control on slippery roads.
Cruise control can be dangerous on

Setting Cruise Control
I
If you leave your cruise control switch on when
you’re not using cruise, you might hit a button
and
go into cruise when you don’t want to. You
could be startled and even lose control. Keep
the cruise control switch
OFF until you want to
use it.
1 - Move the cruise control switch to ON.
2. Get up to the speed you want.
3. Press in the SET button
at the end
of the lever
and release
it.
4. TLlke your foot oft’ the
accelerator pedal.
Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then
you apply the brake. This, of course, shuts off
the cruise control. But you don’t ne.ed to reset it.
Once. you’re going
about
25 mph (40 kmh) or nnore,
you can move the cruise
control switch from
ON
to R/A for about a half
a second.
You’ll go right back LIP to your chosen speed and
stay there.
Ren~ember. if you hold the switch at R/A longer than a
half a second, the vehicle will keep going faster until
you release the switch or apply the brake. You could be
startled and even lose control. So unless you want to go
faster. don‘t hold the switch at R/A.
2-43

Increasing Speed While Using Cruise Control
The.re are two ways to go to a higher speed:
Use the accelerator pedal to get to the higher speed.
Press the button at the
end of the lever, then release
the button and the accelerator pedal.
You'll now
cruise at the higher speed.
Move the cruise switch from ON to R/A. Hold it
there until you get up to the speed you want, and
then release the switch. (To increase yo~tr speed in
very snlall amounts, move the switch to R/A. Each
time you do
this, your vehicle will go about I mph
(1 -6 kdh) faster.)
Reducing Speed While Using Cruise Control
Press in the button at the end of the lever until you reach
the lower speed you want, then release
it.
To slow down in very small amounts. press the button
for less than
a half a second. Each time you do this.
you'll go 1 mph ( 1.6 kdhj slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot off the pedal, YOLII- vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
Ending Cruise Control
Erasing Speed Memory
2-44

Part C: Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed at least twice
a year (for instance. each
spring and fall). You should let
your GM dealer's
service department or other qualified service center
do
these jobs. Make sure any necessary repairs are
completed
at once.
Proper procedures to perform these services may be
found
in a GM service nnanual. See "Service and Owner
Publications"
in the Index.
Steering, Suspension and Front Drive Axle
Boot
and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged. loose or missing parts, signs
of
wear or lack of lubrication. Inspect the power steering
lines
and hoses for proper hook-up, binding, leaks,
cracks, chafing, etc. Clean and then inspect the drive
axle boot seals for damage, tears or leakage. Replace
seals
if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body
near the exhaust system. Look for broken, damaged,
missing or out-of-position parts
as well as open seams,
holes. loose connections
or other conditions which could
cause
a heat build-up in the floor pan or could let
exhaust fumes into the vehicle. See "Engine Exhaust"
in
the Index.
Radiator and Heater Hose Inspection
Inspect the hoses and have them replaced if they are
cracked. swollen or deteriorated. Inspect
all pipes,
fittings
and clamps; replace as needed.
Throttle Linkage Inspection
Inspect the throttle linkage for interference or binding,
and for damage or missing parts. Replace parts
as
needed. Replace any cables that have high effort or
excessi\.e wear.
Do not lubricate accelerator and cruise
control cables.
7-50

Clock . Setting ................................... 3-6
Clutch. Hydraulic
............................... 6- 19
Comfort Controls ................................ 3- I
Compact Disc Care ............................. 3-2 I
Compact Spare Tire 3-33
Control of a Vehicle .............................. 4-6
Convenience Net
............................... 2-57
Convex Outside Mirror
.......................... 2-50
Coolant ................................... 5- 14.6-23
Coolant Heater. Engine
.......................... 2- I7
Cruise Control ................................. 2-42
Customer Assistance Information
................... 8- I
Customer Satisfaction Procecture .................... 8-2
.. .............................
Courtesy Transportation ........................... 8-8
Damage
. Finish ............................... 6-56
Damage. Sheet Metal
............................ 6-55
Daytime Running Lamps Indicator Light ............ 2-80
Dead Battery
................................... 5-3
Defects. Reporting Safety ................... X- IO. 8- 1 1
Defensive Driving ............................... 3-2
Defogging ..................................... 3-5
Defrosting ..................................... 3-5
Dimensions . Vehicle ............................ 6-64
Dome Latmps
.................................. - 3-48
Door
Locks
....................................... 2-3
Storage ..................................... 2-56
Drive. Automatic Transmission
.................... 2-20
Daytime Running Lamps ......................... 2-36 Drive
Axlc Service ... ........................ 7-51
Driver Position
.................................
City ........................................ 4-32
Defensive
.................................... 4-2
Drunken
..................................... 4-3
Foreign Countries
.............................. 6-4
Guidelines
.................................. 4-14
Hill and Mountain Roads
....................... 4-35
In a Blizzard ................................. 4-39
Night
...................................... 4-28
Ofl-Road ................................... 4-15
On Curves ................................... 4-9
Rainy Conditions
............................. 3-29
Snowy and Icy Conditions ...................... 3-37
Through Deep Standing Water
................... 4-31
Wintet-
...................................... 4-37
With
a Trailer ................................ 4-50
Driving On Grades Whilc Towing :I Trailer ........... 3-52
Drunken Driving ................................ 3-3
F~KWLI~ .................................... 4-33
Wet Roads .................................. 1-29
Easy Entry scat ................................ 1-7
Electrical Equipmcnt
. Addin2 ................ 3-20, 6-58
Electrical System
............................... 6-58
Elnergency Releasc
........................... 2-11
EIldgate ....................................... 2-9
M;tIlLlal Rclc~~e
.............................. 2- IO
Re111ote Release .............................. 2-11
9-3