remove seats GMC SAVANA 2003 Owner's Manual

Rear Seats
Rear Seat Operation
Removing the Rear Seat
1. Disconnect the quick
release latch plates
for the lap shoulder
belts on the bench seat
to be removed. To do
this, press the tip of a
key into the release
hole of the safety belt
buckle while pulling up
on the safety belt.
There are two pins located on the inboard sides of
the rear seats. If the vehicle has floor mats, the
pins will be located under a flap that has been cut
into the mat. The driver’s side pin will have a black
cap with an “L” marked on it and will look like this:
1-5
2003 - Savana OM

•The passenger’s side pin will have a white cap
with an“R”marked on it and will look like this:
2. Pull the pin handle up which will loosen the pin
from the retaining clip.
3. Once the black or white pin is disengaged, pull the
pin completely out.4. Repeat this procedure for the pin on the other
seat base.
5. Pull the seat rearward about two inches (5 cm) and
then lift the seat from thefloor rails.
6. Remove the seat from the vehicle.
7. For thefirst rear seat,
stow the safety belt latch
by attaching the clip
on the safety belt latch to
the trim just inside the
side door. For the
remaining rear seats,
stow the safety belt latch
plate on the clip at the
window trim.
1-6
2003 - Savana OM

Rear Window Defogger
Press this button to turn the rear window defogger on or
off. Be sure to clear as much snow from the window
as possible.
The rear window defogger uses a warming grid to
remove fog or frost from the rear window and will only
work when the ignition is RUN.
The rear window defogger will turn off several minutes
after the button is pressed. If turned on again, the
defogger will run for several more minutes before turning
off. The defogger can also be turned off by pressing
the button again or by turning off the engine.
Notice:Don’t use a razor blade or something else
sharp on the inside of the rear window. If you
do, you could cut or damage the defogger and the
repairs would not be covered by your warranty.
Do not attach a temporary vehicle license, tape,
a decal or anything similar to the defogger grid.
Outlet Adjustment
Use the outlets located
near the center and on the
sides of the instrument
panel to change the
direction of airflow.
Operation Tips
•Clear away any ice, snow or leaves from the air
inlets at the base of the windshield that may
block theflow of air into your vehicle.
•Use of non-GM approved hood deflectors may
adversely affect the performance of the system.
•Keep the path under the front seats clear of objects
to help circulate the air inside of your vehicle more
effectively.
3-22
2003 - Savana OM