light GMC SIERRA 1993 Manual Online

Service & Appearance Care
This light also should come on when you start your engine, as\
a check. If it
doesn’t, have it fixed
so it will be there to let you know if you ever do get
water in your fuel.
If the light comes on at any other time, use this chart.
“WATER IN FUE
PROBLEM
Light comes on intermittently.
1) Temperatures above freezing.
Light stays on
2) Temperatures below freezing.
3) Immediately after refueling -
Large amounts of water
probably pumped into the
tank.
.” LIGHT CHART
RECOMMENDED ACTION
Drain water from fuel filter.
Drain fuel filter immediately.
If nc
water is drained and light stays on
-
replace fuel filter.
Drain fuel filter immediately.
If no
water can be drained
- water may be
frozen. Open air bleed
to check for
fuel pressure.
If no fuel pressure
replace filter.
Fuel tank purging required. See your
dealer for assistance.
1
iesitation or “flat” performance at high speed or hard acceleration may be an
ndication of premature fuel filter plugging due to dirty
or contaminated fuel.
The filter element may need
to be changed if this happens. See your dealer
or assistance.
f you drive when this warning light is on, you can damage your fuel I
njection system and your engine. If the light comes on right after you
efuel,
it means water was pumped into your fuel tank. Turn off your
mgine immediately. Then, have the water drained at once.
I
To drain water:
1. Remove the fuel tank cap.
2. Connect a hose going from the water drain valve to a fuel-resistant
container.
6-8
ProCarManuals.com

7
F
K2451
..
3. With the engine off, open the water drain valve 2 to 3 turns.
4. Start the engine and allow it to idle for 1 to 2 minutes, or until clear fuel
is observed.
5. Stop the engine and close the water drain valve.
6. Install the fuel tank cap.
If the
WATER IN FUEL light comes on again after driving a short distance or
the engine runs rough or stalls-a large amount of water has probably been
pumped into the fuel tank. The fuel tank should be purged.
~ CAUTION I
A Diesel fuel containing water is still flammable. You could h~ burmi.
If you eve:r try to drain water from your fuel, kee,p sparks mes d.
. smoking materials away from the mixture.
If there is water in your diesel fuel and the weather is warm or humid,
fungus and bacteria can grow in the fuel. They can damage your fuel
system. You'll need a diesel fuel biocide
to sterilize your fuel system. Your
dealer can advise you
if you ever need this.
If your fuel tank needs to be purged to remove water, see your dealer or
a qualified service technician. Improper purging can damage your fuel
system.
6-9
ProCarManuals.com

HOT
WEATHER
COLD
WEATHER
LA t
i SAE low-30
SAE SW-30
PREFERRED
IF NEiTHER SAE 5W-30 NOR SAE 1OW-30
GRADE OILS ARE AVAILABLE, SAE 30
GRADE MAY BE USED AT TEMPERATURES
ABOVE
40 DEGREES F (4 DEGREES C).
ANY OTHER GRADE
OIL NOT RECOMMENDED
DO
NOT USE
SAE 1OW-40, SAE 2OW-50 OR
PO344
SAE 5W-30
Vehicles with Light Duty Emissions (8500 GVWR or less).
As
shown in this chart, SAE 5W-30 is best for your vehicle. However,
you can use
SAE IOW-30 if it’s going to be 0°F (-18°C) or above.
6-23
ProCarManuals.com

These numbers on an oil container show its viscosity, or thickness.
Do not use other viscosity oils such as
SAE IOW-40 or SAE 2OW-50.
Energy Conserving II
Oils with these words on the container will help you save fuel.
This doughnut-shaped logo (symbol) is used on most oil containers to help
you select the correct oil.
You should look for this on the oil container, and use
only those oils that
display the logo.
GM Goodwrench@ oil (in Canada, GM Engine Oil) meets all the requirements
for your vehicle.
Engine Oil Additives:
Don’t add anything to your oil. Your GM dealer is ready to advise if you think
something should be added.
When to Change Engine Oil:
See if any one of these is true for you:
Most trips are less than 4 miles (6 km).
It’s below freezing outside and most trips are less than 10 miles
(16 km).
The engine is at low speed most of the time (as in door to door
delivery, or in stop-and-go traffic).
You tow a trailer often.
Most trips are through dusty places.
The vehicle is frequently operated off-road.
If any one of these is true for your vehicle, then you need to change your
oil and filter every 3,000 miles (5000 km) or 3 months-whichever comes
first.
Vehicles with Light Duty Emissions (8500 GVWR or less).
If none of them is true, change the oil every 7,500 miles (12 500 km) or 12
months-whichever comes first. Change the filter at the first oil change and at
every other oil change after that.
Vehicles with Heavy Duty Emissions (8501 GVWR or more).
If none of them is true, change the oil every 6,000 miles (10 000 km) or 12
months-whichever comes first. Change the filter at the first oil change and at
every other oil change after that
‘if mileage determines when you change your
oil.
If time determines when you change your oil, change the filter ea\
ch time
you change your oil.
6-25
ProCarManuals.com

How to Add Fluid:
Here’s how to add fluid. Refer to the Maintenance Schedule to determine
what kind of fluid to use. See “Recommended Fluids and Lubricants” in the
Index.
1. Remove the filler plug.
2. Add fluid at the filler plug hole. Add only enough fluid to \
bring the fluid
3. Install the filler plug. Be sure that the filler plug is full\
y seated.
level up
to the bottom
of the filler plug hole.
Hydraulic Clutch
112” to
K2376
The hydraulic clutch in your vehicle is self-adjusting. A slight amount of play
(112 inch to an inch) in the pedal is normal.
6-37
ProCarManuals.com

Service & Appearance ,Care
Engine Coolant
r
PO593
The following explains your cooling system and how to add cool\
ant when it is low.
If you have a problem with -engine overheating, see “Engine
Overheating” in the Index.
The proper coolant for your vehicle will:
Give freezing protection down to -34°F (-37°C).
Give boiling protection up to 258°F (125°C).
Protect against rust and corrosion:
Help keep the proper engine temperature.
Let the warning lights and gages work as thiy should.
What to Use:
Use a ,mixture of clean water (preferably distilled), and antifreeze that meets
“GM Specification 6038-M,” which won’t damage aluminum p\
arts.
Also use
GM Engine Coolant Supplement (sealer) with a complete coolant change. If
you use these, you don’t need to add anything else.
,
6-42
ProCarManuals.com

Service & Amearance Care
Adding Coolant
r
PO206
To Check Coolant: When your engine is cold, the coolant level should be at
COLD, or a little higher. When your engine is warm, the level should be up
to HOT, or a little higher.
LOW
COOLANT
K2327
If this light comes on, it means you're low on engine coolant.
To Add Coolant: If you need more coolant, add the proper mix at the
coolant recovery tank.
6-44
ProCarManuals.com

Other Maintenance Items
Front Suspension and Steering Linkage
Your maintenance schedule will tell you how often to lubricate the fittings. See
“Recommended Fluids and Lubricants’’ in the Index for the proper lubricant to
use.
Front Wheel Bearings
Your vehicle has front wheel bearings that must be cleaned and repa\
cked.
Your maintenance schedule will tell you how often this must be done.
Front Shock Absorbers
The front shock absorbers of your vehicle do many things. They help the
vehicle ride smoothly and also control the travel
of the suspension system.
When the shock absorbers are serviced, any replacement shock absorber\
s
must be the same as the original equipment shock absorbers in both
extended length and strength.
1 NOTICE
If you use shock absomers that are nor me same as the original shock
I absorbers, the shock absorbers or suspension system could be da\
maged.
Wheel Nut Torque
For vehicles with dual wheels, when the vehicle, wheel or fast\
eners are new,
have the torque set at the first
100, 1,000 and 6,000 miles (160, 1600 and
9600 km). Use the torque specified in the appropriate Specification \
Chart later
in this section.
Single Belt Accessory Drive
If your new vehicle uses a serpentine belt, it is lighter, and more durable
than systems with several belts.
The belt runs over or around the pulleys
on the engine. A tensioner is used
to keep the belt tight at all times. The tensioner also makes replacing the
belt easier.
If you need to replace the belt, be sure to get the correct
replacement belt. Your dealership
or parts supplier can help you with this.
The Accessory Drive Belt Routing label on your vehicle will sh\
ow you how to
route the belt your vehicle uses.
6-5 1
ProCarManuals.com

Accelerator cables and cruise control cables should not be lubr\
icated. Any
cables that are worn or are hard to pull should be replaced. \
Remove external deposits from injector pump face cam on 6.2L d\
iesel
engines, when the engine is cold.
Hood Latches and Hood Hinge
Your maintenance schedule will tell you how often to lubricate the \
hood latch
and hood hinge assembly. See “Recommended Fluids and Lubrican\
ts” in the
Index for the proper lubricant to use.
Propeller Shaft Slip Splines
See your maintenance. schedule to find out how often the slip \
splines must
be lubricated. See “Recommended Fluids and Lubricants” in \
the Index for the
proper lubricant to use.
Constant Velocity Joints
See your maintenance schedule to find out how often the consta\
nt velocity
joints must be lubricated. See “Recommended Fluids and .Lubri\
cants” in the
Index for the proper lubricant to use.
80dy
Normal use of your vehicle will cause metal to metal wear at some points on
the cab and body
if they are not lubricated.
For exposed surfaces, such as door checks, door lock bolts, lo\
ck striker
plates, dovetail bumper wedges, etc., a thin film of engine oil should be
applied.
The seat adjusters and seat track should be lubricated with chassis grease.
Door weather strips and rubber hood bumpers should be lightly coated with a
rubber lubricant.
Never use too much of any lubricant and be sure to wipe up any extra
lubricant when you are finished.
Your maintenance schedule
will tell you how often to lubricate these Ilems.
See “Recommended Fluids and Lubricants” in the Index for \
the proper
lubricant to use.
Lock Cylinders
To be sure your locks operate properly, they must be lubricated. \
Your vehicle’s
maintenance schedule
will tell you how often to lubricate them. See
“Recommended Fluids and Lubricants” in the Index for the proper lubricant to
use.
6-53
ProCarManuals.com

Service & Appearance Care
You should not use penetrating oils because they could wash out the factory
installed lubricant and cause the lock to bind. De-icers which contain alcohol
could also wash away the lubricant,
so be sure to lubricate the lock after
using a de-icer of this type.
Tailgate Handle
The tailgate handle pivot points on your vehicle should be lub\
ricated to keep
it working smoothly.
Your maintenance schedule will tell you how often to lubricate the handle.
See “Recommended Fluids and Lubricants” in the Index for the proper
lubricant to use.
Electrical System
Battery
Every new GM vehicle has a Delco Freedom@ battery. You never have to
add water to one of these. When it’s time for a new battery, we recomme\
nd
a Delco Freedom@ battery. Get one that has the catalog number \
shown on
the original battery’s label.
Vehicle Storage
If you’re not going to drive your vehicle for 25 days or more, take off the
black, negative
(-) cable from the battery. This will help keep your battery
from running down.
I - Batteries have acid that can burn you and gas that can explod\
e. You I
1 can be badly hurt if you aren’t careful. See “Jump Starting” in the
Index for tips on working around a battery without getting hur\
t.
Contact your dealer to learn how to prepare your vehicle for longer periods.
Bulb Replacement
Before you replace any bulbs, be sure that all the lights are off and the
engine isn’t running.
6-54
ProCarManuals.com