ECU GMC SIERRA 1994 Owner's Manual
[x] Cancel search | Manufacturer: GMC, Model Year: 1994, Model line: SIERRA, Model: GMC SIERRA 1994Pages: 404, PDF Size: 20.91 MB
Page 300 of 404

Wheel Nut Torque
For vehicle with dual wheels, wnen the vehicle, wheel or Tasteners are new,
have the torque set at
the first 100, 1,000 and 6,000 miles (1 60, 1600 and
9600 km). Use the torque specified
in the appropriate Specification Chart
later
in this section.
Single Belt Accessory Drive
If your new vehicle uses a serpentine belt, it is lighter and more durable than
systems with several belts.
The belt runs over or around the pulleys on the engine.
A tensioner may be
used
to keep the belt tight at all times. The tensioner also makes replacing
the belt easier.
If you need to replace the belt, be sure to get the correct
replacement belt. Your dealership or parts supplier can help you with this.
The Accessory Drive belt Routing label on your vehicle will show
you how
to route
the belt your vehicle uses.
Windshield Wiper Blade Inserts
To replace the
windshield wiper
blade insert, lift the
wiper arm and rotate
the blade until
it is
facing away from the
windshield.
Unlatch
the end of the insert from the holding clips. Remove the insert and
slide a new
one in place. Make sure the blade is secured in the clips.
Air Conditioning
Every now and then have your dealership check your air conditioning
system
to be sure it has not lost any cooling ability. If you think the system
is not working properly, have your dealership check it out as soon as
possible.
The air conditioning
will not work when the temperature is below 40°F
(4°C).
6-50
ProCarManuals.com
Page 316 of 404

A CAUTION:
In the case of a sudden stop or collision, things carried in the bed
of your truck could shift forward and come into the passenger
area, injuring you and others.
If you put things in the bed of
your truck, you should make sure they are properly secured.
A CAUTION:
Do not load your vehicle any heavier than the GVWR or the
maximum front and rear
GAWRs. If you do, parts on your
vehicle-can break, or it can change the way your vehicle handles.
These could cause you to lose control. Also, overloading can
shorten the Iife
of your vehicle.
Using heavier suspension components to get added durability might not
change your weight ratings.
Ask your dealer to help you load your vehicle
the right
way.
NOTICE:
Your warranty does not cover parts or components that fail
because
of overloading.
If you put things inside your vehicle-like suitcases, tools, packages, or
anything else-they
go as fast as the vehicle goes. If you have to stop or
turn quickly, or if there is a crash, they’ll keep going.
6-66
ProCarManuals.com
Page 329 of 404

NOTICE:
The wrong wheel can also cause problems with bearing life,
brake cooling, speedometer/odometer calibration, headlight aim,
bumper height, vehicle ground clearance, and tire or tire chain
clearance to the body and chassis.
Used Replacement Wheels
Tire Chains
NOTICE:
If your vehicle has dual wheels or LT26Y75R16 size tires, don’t
use tire chains; they can damage your vehicle.
If you don’t have
dual wheels or
if you have a tire size other than LT265/75R16,
use tire chains only where legal and only when you must. Use
only SAE Class “S” type chains that are the proper size for your
tires. Install them on the tires of the rear axle. Tighten them as
tightly
as possible with the ends securely fastened. Drive slowly
and follow the chain manufacturer’s instructions.
If you can
hear the chains contacting your vehicle, stop and retighten them.
If the contact continues, slow down until it stops. Driving too
fast with chains on will damage your vehicle.
6-79
ProCarManuals.com