brake GMC YUKON 2004 Get To Know Guide

A. Air Outlets
B. Exterior Lamps Control
C. Turn Signal/Multifunction Lever
D. OnStar
®and Radio Steering
Wheel Control Buttons
E. Instrument Panel Cluster
F.Shift Lever/Tow/Haul Selector
Button
G. Audio System
H. Dome Lamp Override ButtonI. Rear Wiper Washer
J. Fog Lamps Button (if equipped)
K. Driver Information Center (DIC)
Buttons
L. Parking Brake Release
M. Tilt Wheel Lever
N. Comfort Control System
O. Storage Area (Denali models)P.Compact Disc Changer (Denali
models. Storage area (if equipped)
on Yukon models)
Q. Accessory Power Outlet
R. StabiliTrak
®Button (Denali location
shown. See “T” for Yukon models)
S. Glove Box
T.Automatic Transfer Case/
StabiliTrak®Mode Button (AWD
Vehicles)/Traction Assist System
(TAS) (Storage compartment on
Denali models)
Getting to Know YourYukon/Yukon Denali2
Instrument Panel
See Section 3 of your Owner Manual.(Denali Instrument Panel shown)

Arm the system
•Lock the doors using
the power door lock
switch or the Keyless
Entry System trans-
mitter. The alarm is
activated when the symbol shown
above illuminates in the instrument
panel cluster (approximately 30
seconds).
If your vehicle is equipped with a Driver
Information Center, you can program the
alarm to the following:
Manually activate the headlamps, all
exterior tail/marker lamps and the
instrument panel/radio lights
•Turn the exterior lamps knob to this
position ( ).
Turn the fog lamps (if equipped) on
or off
•Press the fog lamp
button located on
the left side of the
instrument panel.
An indicator lamp
will illuminate when
the fog lamps are on.
See Section 3 of your Owner Manual.11
Daytime Running Lamps (DRL)
Disable the DRL when idling
•Shift the vehicle into PARK, or
•Set the parking brake.
See Section 3 of your Owner Manual.
Content Theft-Deterrent System
(if equipped)
•Both Horn/Headlamps
•Horn only
•Lamps only
•Off
See Section 2 of your Owner Manual.
Note:Your vehicle’s factory default
setting is Horn and Lamps. See the
Personalizing Your Vehicle section of
this booklet for more information.
Tire Pressure Monitor
(if equipped)
This feature alerts you when a
substantial reduction in pressure occurs
in one of your vehicle’s tires. If this
occurs, a CHECK TIRE PRESSURE
message will appear in the instrument
panel cluster. This message will remain
on until you reset the system.
Reset the tire pressure monitor
•To reset the tire pressure message,
you must fill the tires with the correct
amount of air. The best time to check
your tire pressure is when the tires
are cold.
•Pressing the cluster stem button on
your instrument panel cluster or the
Select/Reset button ( ) on your
steering wheel (if equipped) will
temporarily eliminate the message.
However, at the next vehicle start-up,
the message will reappear. The tire
pressure must be corrected to
permanently eliminate the message.
See Section 5 of your Owner Manual.
Note:The Tire Pressure Monitor
can alert you about low tire pressure,
but it doesn’t replace normal tire
maintenance.
Note:Your DRLs will re-engage at the
next key cycle.

Getting to Know YourYukon/Yukon Denali12
Memory Positions for Driver’s
Seat, Mirrors, Pedals, Radio and
Climate Controls (if equipped)
Use the driver’s
door mounted con-
trols to:
•Adjust driver
seat, including
lumbar
adjustment
•Adjust gas and
brake pedals
•Adjust the outside rearview mirrors
•Set the radio presets and climate
control temperature (the temperature
setting will revert to the last tempera-
ture setting used)
•Press and hold Memory 1 or 2 until
two chimes sound (about four
seconds)
•To set up for another driver, repeat
the process with the other memory
button
These settings will be remembered after
they are programmed by pressing the
Memory 1 or 2
button on the
driver’s door
(shown above).
If you unlock the
vehicle with the
Remote Keyless
Entry (RKE)
transmitter, the
vehicle memory
settings will correspond to the number
on the RKE transmitter: 1 or 2.
See Section 2 of your Owner Manual.
Memory Settings for Your
Vehicle (Driver Information
Center) (if equipped)
Your vehicle may be programmed with
the features shown below. To cycle
through them, use the
Personalization/Menu button ( )
located on your steering wheel.
•Alarm Warning Type
•Automatic Locking/Unlocking
•Perimeter Lighting
•Delayed Locking
•Remote Lock/Unlock Feedback
•Seat Position Recall
•Headlamps On at Exit
•Easy Exit Driver Seat
•Display Units
•Display Language
•Curb View Assist (if equipped)
Selection Options
Use the Select button ( ) to choose
your desired setting. The last setting
remaining on the display will be
the selection of choice. Continue
cycling through the menu with the
Personalization/Menu button ( )
to set other preferences.
Alarm W
arning Type
1. Alarm Warning: Both (default)
2. Alarm Warning: Off
3. Alarm Warning: Horn
4. Alarm Warning: Lamps

Adjustable Pedals (if equipped)
Air Bag Readiness Light
Air Conditioning (A/C)
Antilock Brake System
Warning Light (if equipped)
Auxiliary Roof-Mounted Lamp
Switch (if equipped)
Battery Warning Light
Brake System Warning Light
Content Theft Deterrent
Cruise Control Set
Dome Lamps Override Button
Driver Information Center Trip
Information Button (on steering
wheel)
Driver Information Center Fuel
Information Button (on steering
wheel)
Driver Information Center
Personalization/Menu Button
(on steering wheel)
Driver Information Center
Select Button (on steering
wheel)
Fog Lamps
15
Vehicle Symbols Glossary
Four-Wheel Steer (if equipped)
Front and Side Window Defrost
Headlamps
Instrument Panel Brightness
Control
Malfunction Indicator Lamp
(Check Engine Light)
Off (for example, headlamp and
climate control)
Off/On (for example, inside
rearview mirror)
On (for example, cruise control
lever)
Parking Lamps
Driver and Front Passenger
Safety Belt Reminder Light
(if equipped)
Rear Door Security Locks
Rear Window Defogger
StabiliTrak
®System (if equipped)
Tow/Haul Mode Light
Traction Off Light Following are examples of symbols you may find on your vehicle. It is important to
become familiar with them, as they alert you to various vehicle operating conditions.