reset GMC YUKON 2006 Get To Know Guide

7
Entertainment Systems —
Radio/CD
Set the time on radios
withouta
Radio Data System (RDS)
• Press and hold the HR or MIN arrow
for two seconds.
• Press the HR (down) arrow until the
correct hour appears on the display.
•Press and hold the MIN (up) arrow
until the correct minute appears on
the display.
Set the time on radios withaRadio
Data System (RDS)
Your radio may have a button marked
“H” or “HR” to represent hours and an
“M” or “MIN” to represent minutes.
• Press and hold the hour button until
the correct hour appears on the
display.
• Press and hold the minute button
until the correct minute appears on
the display.
Program radio station presets
• Turn the radio on.
•Press BAND to select the band
(AM/FM1/FM2/XM1/XM2).
•Use the seek button or tune knob to
tune in the desired station.
• Press AUTO EQ or AUTO TONE (as
applicable to your radio) to select the
equalization that best suits the type of
station selected.
• Press and hold one of the six num
bered buttons until a beep sounds;
release the button.
•Repeat these steps for each station
preset, using a different numbered
button for each station.
Access one of the two available XM
Satellite Radio bands (if equipped)
• Press the BAND button until XM1 or
XM2 appears on the display.
Note:The time may be set with the
ignition on or off.
Note:Requires subscription to XM
Radio.
To use the rear seat controls, the front
fan control knob must be in the AUX
position.
On the rear seat control panel, press the
mode button ( ) and select AUTO if
you want the system to regulate airflow.
See Section 3 of your Owner Manual.
YukonYukonDenali 06 Beta3 5/19/05 10:03 AM Page 7

Getting to Know YourYukon/Yukon Denali10
Sunroof (if equipped)
The sunroof controls are located in the
overhead console.
Open sunroof to fully opened position
• Press the rear portion of the button
(“A”).
Close the sunroof
• Hold the front portion of the button
(“B”) down until the sunroof motor
stops. The sunroof will tilt up slightly
to seal. This is normal.
Open sunroof to vent position
• Press and hold the front portion of
button (“B”) when the sunroof is
closed.
See Section 2 of your Owner Manual.
A
B
Steering Wheel Controls
(OnStar®/ Radio) (if equipped)
(OnStar/Voice Recognition):
This
button will activate OnStar®for use. If
your vehicle is not equipped with the
OnStar
®system, pressing this button will
mute the radio.
PROG:This button will cycle through
the radio presets.
:Selects AM, FM, XM Satellite
Radio (if equipped), cassette or CD.
:Seeks radio stations.
:Adjusts radio volume.
See Sections 2 and 3 of your Owner Manual.
Note:For additional OnStar®features
information, including Personal Calling
and Virtual Advisor, see the OnStar
®
section of your Owner Manual.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 10

Activate the automatic headlamp
system
• Turn the exterior lamps knob to
AUTO. The automatic headlamp
system will turn on the front and
rear lamps.
Manually illuminate the parking
lamps, sidemarker lamps, taillamps,
instrument panel/radio lights, license
plate lamps and roof marker lamps
(if equipped)
• Turn the exterior lamps knob to the
parking lamp position ().
Manually activate the headlamps, all
exterior tail/sidemarker lamps and
the instrument panel/radio lights
• Turn the exterior lamps knob to this
position ( ).
Turn the fog lamps
(if equipped) on
or off
• Press the fog lamp
button located on
the left side of the
instrument panel.
An indicator lamp will illuminate when
the fog lamps are on.
See Section 3 of your Owner Manual.
Getting to Know YourYukon/Yukon Denali12
Automatic Headlamp Controls
Turn off Daytime Running Lamps
(DRL) and automatic headlamps
• Turn the exterior lamps knob (located
to the left of the steering wheel) to
Off ( ) and release.
Power Folding Mirrors
(if equipped)
Fold mirrors
• Move the
selector switch
located above
the mirror
control (“A”
right) to
the center
position.
• Press the right
side of the
fourway control pad (“B” above)
to fold in the mirrors.
• Press the left side of the fourway
control pad to fold out the mirrors.
If the mirrors have been folded manual
ly, they must be moved through the
power folding cycle three times to reset
them in their tracks.
See Section 2 of your Owner Manual.
A
B
Note:Your DRLs or automatic head
lamps will reengage at the next key
cycle.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 12

15
•Headlamp Delay: 3 Min
•Headlamp Delay: Off
Perimeter Lights
(The headlamps and backup lamps will
come on for 40 seconds, if it is dark
enough, when unlocking the vehicle with
the Remote Keyless Entry transmitter.)
•Perimeter Lights: On
•Perimeter Lights: Off
Easy Exit Seat
(The driver’s seat moves to the exit
position when the key is removed from
the ignition.)
•Easy Exit Seat: Off
•Easy Exit Seat: On
Curb View
(The outside rearview mirror(s) tilt down
when the vehicle is shifted into
Reverse.)
•Curb View: Off
•Curb View: Passenger
•Curb View: Driver
•Curb View: Both
Alarm Warning
(The feedback received when the alarm
is active.)
•Alarm Warning: Both
•Alarm Warning: Off
•Alarm Warning: Horn
•Alarm Warning: Lamps
Language
(The Driver Information Center display
language.)
•Language: English
•Language: Français (French)
•Language: Español (Spanish)
Display Units
(The units in which all information will be
displayed.)
•Display Units: English
•Display Units: Metric
See Section 3 of your Owner Manual.
Odometer/Trip Settings
(if equipped)
Press the trip information button
to scroll through the Odometer,Trip A,
Trip B, Tire Pressures, Timer and
Engine Hours choices on the Driver
Information Center.
Odometer
This mode shows the total distance the
vehicle has been driven in either miles
or kilometers. Pressing the reset stem
located on the instrument cluster with
the vehicle off will also display the
odometer.
Trip A
This mode shows the current distance
traveled since the last reset for TRIP A
in either miles or kilometers.
Trip B
This mode shows the current distance
traveled since the last reset for TRIP B
in either miles or kilometers.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 15

Getting to Know YourYukon/Yukon Denali16
Fuel Information (if equipped)
Press the fuel information button
to scroll through the Fuel Range, Fuel
Used, Average Economy and Engine Oil
Life selections on the Driver Information
Center.
Fuel Range
This mode shows the range in miles that
the vehicle can travel with the current
amount of fuel.
Fuel Used
This mode shows the current amount of
fuel used in gallons since the last reset
for Fuel Used. This mode should be
reset after every fuel tank fillup.
Average Economy
This mode shows the average fuel econ
omy in miles per gallon since the last
reset for Average Economy.
Engine Oil Life
This mode shows the percentage of oil
life left until it is recommended to
change the engine oil. An oil and filter
change should be performed within 600
miles of the Change Oil message being
displayed.
See Section 3 of your Owner Manual.
Reset Trip Information
To reset TRIP A or TRIP B information,
press and hold the Select button ( )
for one second while in one of the trip
modes. This will reset the information for
TRIP A or TRIP B. You can also reset
TRIP A or TRIP B while they are dis
played by pressing the reset stem on
the cluster. If you press and hold the
reset stem or for four seconds, the
display will show the distance traveled
since the last ignition cycle for TRIP A
or TRIP B.
Timer
The DIC can be used as a timer. Press
while TIMER is displayed to start
the timer. The display will show the
amount of time that has passed since
the timer was last reset, not including
time the ignition is off, up to 99 hours,
59 minutes and 59 seconds (99:59:59).
Engine Hours
This mode shows the total number of
hours the engine has run. Pressing and
holding the reset stem located on the
instrument cluster for about four sec
onds will also display the engine hours
after the odometer is displayed when the
vehicle is off.
See Section 2 of your Owner Manual.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 16