wiper blades GMC YUKON DENALI 2003 Owners Manual
[x] Cancel search | Manufacturer: GMC, Model Year: 2003, Model line: YUKON DENALI, Model: GMC YUKON DENALI 2003Pages: 447, PDF Size: 21.97 MB
Page 152 of 447
(High Speed): For high-speed wiping, turn the
band further, to the second solid band past the
delay settings.
0 (Off): To stop the wipers, move the band to off.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
worn or damaged, get new blades or blade inserts.
Windshield Washer
(Washer Fluid): There is a paddle marked with the
windshield washer symbol at the top
of the multifunction
lever. To spray washer fluid on the windshield, push
the paddle. The wipers will clear the window and then
either stop or return to your preset speed.
In
freezing weatt.-., dl_-.'t use your washer
until the windshield
is warmed. Otherwise the
washer fluid can form ice
on the windshield,
blocking your vision.
Rear Window WasherNViper
This knob is located on the
instrument panel to the left
of the steering wheel.
To turn the rear wiper on, turn the knob to either
1 or 2.
For long delayed wiping, turn the knob to 1. For short
delayed wiping, turn the knob
to 2
0 (Off): To turn the wiper off, turn the knob to this
symbol.
a (Washer Fluid): To wash the window, press the
knob with this symbol.
The rear window washer uses the same fluid bottle
as
the windshield washer. However, the rear window
washer will run out
of fluid before the windshield washer.
If you can wash your windshield but not your rear
windows, check the fluid level.
3-9
Page 263 of 447
The heavier the rain, the harder it is to see. Even if your
windshield wiper blades are in good shape, a heavy
rain can make it harder to see road signs and
traffic signals, pavement markings, the edge of the road
and even people walking.
It’s wise to keep your wiping equipment in good shape
and keep your windshield washer tank filled with
washer fluid. Replace your windshield wiper inserts
when they show signs of streaking or missing areas on
the windshield, or when strips of rubber start to
separate from the inserts. Driving too fast through large
water puddles or even
going through some car washes can cause problems,
too. The water may affect your brakes. Try to avoid
puddles. But
if you can’t, try to slow down before
you hit them.
Wet brakes can cause accidents. They won’t
work as well in a quick stop and may cause
pulling to one side. You could lose control
of
the vehicle.
After driving through a large puddle
of water
or a car wash, apply your brake pedal lightly
until your brakes work normally.
4-30
Page 267 of 447
Once you are moving on the freeway, make certain you
allow a reasonable following distance. Expect
to
move slightly slower at night.
When you want to leave the freeway, move
to the
proper lane well in advance.
If you miss your exit, do
not, under any circumstances,
stop and back up. Drive
on
to the next exit.
The exit ramp can be curved, sometimes quite sharply.
The exit speed is usually posted.
Reduce your speed according
to your speedometer, not
to your sense of motion. After driving for any distance
at higher speeds, you may tend to think you are
going slower than you actually are.
Before Leaving on a Long Trip
Make sure you’re ready. Try to be well rested. If you
must start when you’re not fresh
- such as after a day’s
work
- don’t plan to make too many miles that first
part of the journey. Wear comfortable clothing and shoes
you can easily drive in.
Is your vehicle ready for a long trip? If you keep it
serviced and maintained, it’s ready
to go. If it needs
service, have it done before starting out. Of course,
you’ll find experienced and able service experts
in dealerships all across North America. They’ll be
ready and willing
to help if you need it. dere
are some things you can check before a trip:
e
e
e
e e
e
e
Windshield Washer Fluid: Is the reservior full? Are
all windows clean inside and outside?
Wiper Blades: Are they in good shape?
Fuel, Engine Oil, Other Fluids: Have you checked
all levels?
Lamps: Are they all working? Are the lenses clean?
Tires: They are vitally important
to a safe,
trouble-free trip.
Is the tread good enough for
long-distance driving? Are the tires all inflated to the
recommended pressure?
Weather Forecasts: What’s the weather outlook
along your route? Should you delay your trip a
short time
to avoid a major storm system?
Maps:
Do you have up-to-date maps?
4-34
Page 343 of 447
Windshield Wiper Blade Replacement
Windshield wiper blades should be inspected at least
twice a year for wear and cracking. See Wiper
Blade Check under
At Least Twice a Year on page 6-10
for more information.
Replacement blades come in different types and are removed in different ways. For proper type and length,
see Normal Maintenance Replacement
Parts on
page 5-98. Here’s how to remove the shephard’s
hook type.
To replace the windshield wiper blade assembly do the
following:
1. Lift the wiper arm and turn the blade until it is
facing away from the windshield.
2. Push the release lever and slide the wiper assembly
3. Install a new blade by reversing Steps 1 and 2.
toward the driver’s side of the vehicle.
5-54
Page 371 of 447
Notice: Machine compounding or aggressive
polishing on
a basecoatklearcoat paint finish may
dull the finish or leave swirl marks.
Foreign materials such as calcium chloride and other
salts, ice melting agents, road oil and tar, tree sap, bird
droppings, chemicals from industrial chimneys, etc.,
can damage your vehicle’s finish
if they remain
on painted surfaces. Wash the vehicle as soon as
possible.
If necessary, use non-abrasive cleaners that
are marked safe for painted surfaces
to remove
foreign matter.
Exterior painted surfaces are subject
to aging, weather
and chemical fallout that can take their
toll over a
period of years. You can help
to keep the paint finish
looking new by keeping your vehicle garaged or covered
whenever possible.
Protecting Exterior Bright Metal Parts
Bright metal parts should be cleaned regularly to keep
their luster. Washing with water is all that is usually
needed. However, you may use chrome polish
on
chrome or stainless steel trim, if necessary. Use
special care with aluminum trim.
To avoid damaging
protective trim, never use auto or chrome polish,
steam or caustic soap
to clean aluminum. A coating of
wax, rubbed
to high polish, is recommended for all
bright metal parts.
Windshield, Backglass and Wiper
Blades
If the windshield is not clear after using the windshield
washer, or
if the wiper blade chatters when running,
wax, sap or other material may be on the blade or
windshield.
Clean the outside of the windshield with a full-strength
glass cleaning liquid. The windshield is clean
if beads do
not form when you rinse it with water.
Grime from the windshield will stick
to the wiper blades
and affect their performance. Clean the blade by
wiping vigorously with a cloth soaked in full-strength
windshield washer solvent. Then rinse the blade
with water.
Check the wiper blades and clean them as necessary; replace blades that look worn.
5-82
Page 387 of 447
Normal Maintenance Replacement Parts
Replacement part numbers listed in this section are based on the latest information available at the time of printing,
and are subject
to change. If a part listed in this manual is not the same as the part used in your vehicle when it was
built, or
if you have any questions, please contact your GM dealer.
These specifications are for information only.
If you have any questions, see the service manual.
I Part 1 Number I
Oil Filter
G F626"
Fuel Filter 41
-974*
/ PZTR5A15t
Spark Plugs cv2001
-c* PCV Valve" AI
51 8C*
Engine Air CleanedFilter P F44*
Wiper Blades (Front)
ITTA
Wiper Blade Tvpe (Front)
151 53642**
Wiper Blade Length (Front)
ITTA WiDer Blade Tvpe (Rear) 221
54396**
Wiper Blades (Rear) 22.0
inches (56.0 cm) a. I
Wiper Blade Length (Rear) 18.0 inches (45.0 cm)
*ACDelco@ Part
No.
**GM Part No.
tNGK
5-98
Page 398 of 447
Also look for any opened or broken air bag coverings,
and have them repaired or replaced. (The air bag
system does not need regular maintenance.)
Inspect wiper blades for wear or cracking. Replace
blade inserts that appear worn or damaged or that
streak or miss areas of the windshield.
Also see
Cleaning the Outside
of Your Vehicle on page 5-81.
Spare Tire Check
At least twice a year, after the monthly inflation check of
the spare tire determines that the spare is inflated
to
the correct tire inflation pressure, make sure that
the spare tire is stored securely. Push, pull, and then
try
to rotate or turn the tire. If it moves, use the wheel
wrenchhatchet
to tighten the cable. See Changing a Flat
Tire
on page 5-63.
Engine Air Cleaner Filter Restriction
Indicator Check
Your vehicle has an engine air cleaner filter restriction
indicator located on the air cleaner in the engine
compartment. The indicator lets you know when the air
cleaner filter is dirty and needs
to be changed. Check
the indicator at least twice a year or when your engine oil is changed,
whichever occurs first. See Engine Air
Cleaner/Filter
on page 5- 17 for more information. Inspect
your air cleaner filter restriction indicator more often
if
the vehicle is used in dusty areas or under off road
conditions.
Weatherstrip Lubrication
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth. During very cold,
damp weather more frequent application may be required. See
Part D: Recommended Fluids and
Lubricants
on page 6- 15.
Automatic Transmission Check
Check the transmission fluid level; add if needed. See
Automatic Transmission Fluid on page
5-20. A fluid loss
may indicate a problem. Check the system and repair
if needed.
At Least Once a Year
Key Lock Cylinders Service
Lubricate the key lock cylinders with the lubricant
specified in Part D.
Page 440 of 447
Warning Lights. Gages and Indicators ..... ... 3-28
Warnings DIC Warnings and Messages
..... ... 3-52
Other Warning Devices
.. ..... 3-6
Hazard
Warning Flashers
....... ..... 3-5
Safety and Symbols
... .... Ill
Vehicle Damage ........ .... ....... iv
...
Washing Your Vehicle .................................. 5-81
Weatherstrip Lubrication
................................... 6-1 1
Weight of the Trailer ........................................ 4-50
Weight of the Trailer Tongue
...... ............... 4-51
What Kind of Engine Oil
to Use ..... ... 5-1 5
What to Add ........................... ............... 5-37
What
to Do with Used Oil .. ................... 5-17
What to Use ........................
... 5-23, 5-34, 5-48
Wheels
Alignment and Tire Balance
.......................... 5-61
Replacement
............................................... 5-61
When
to Add Engine Oil .................................. 5-14
When to Change Engine Oil (GM Oil
Life System)
............................ ....... 5-16
When to Check
.................... ............... 5-56
When to Check and Change ............................ 5-20
When to Check Lubricant
................................. 5-48
When
to Check Power Steering Fluid ......... 5-34 When
You Are Ready
to Leave After
Where
to Put the Restraint ..........................
Why Safety Belts Work ...............................
Windows ..................................................
Power ...................................................
Windshield, Backglass and Wiper Blades ...
Windshield Washer .............................
Fluid ..............................................
Windshield Washer Fluid Level Check ....
Windshield Wiper
Parking on
a Hill .........................
Blade Replacement .................................
Fuses ...................................................
Windshield Wipers .................................
Winter
Driving ........ ...........
Wood Panels ......... ...........
Wiper Blade Check ..... ...........
X
XMTM Satellite Radio Antenna System ....
XMTM Satellite Radio Service ............
Y
Your Vehicle and the Environment . .
4-55
. 1-56
. 1-26
. 2-14
. 2-15
. 5-82
.. 3-9
. 5-34
. 6-10
. 5-54
. 5-a7
.. 3-8
. 4-37
. 6-1 1
. 5-80
..... 3-89
..... 3-87
.. 6-2
16