gearbox GREAT WALL HOVER 2006 Service Repair Manual

Manipulator cover assembly
gearbox assembly (one)
reverse lock assembly nut M8
bulbrubber cover
pin 740
master control lever assembly
bulb basebush
stop plate of main rodbush
bulb jacket
N m: specified torque
Used component which can not be used any more.
Pregummed component N
m: specified torque
Used component which can not be used any more.
bush
6
oil guiding plate
location pin
steel ball 7.
938
aluminum gasket
reverse lamp switch
gearbox
selection and shifting
shaft rubber choke plug
bleed plug assembly
bush
selection and shifting block
elastic cylindrical pin 622

5. Remove the reverse lamp switch M12×1.25
Caution: When install the reverse lamp switch M12×1.25, the
tightening torque is 26-36 N·m
6. Remove the gearbox
a.Use the wrench to remove the 5 M8×55 bolts, 1 M8×6 bolt and 2
M8×110 bolts
Caution: When install 5 M8×55 bolts, 1 M8×6 bolt and 2 M8×110
bolts. tightening torque is
b. Remove the gearbox assembly
7. Use the circlip pliers to remove the circlip for shaft
8. Remove the odometer drive gear

Transmission-33
10. Remove the high and low gear drive declutch shift shaft
11.Remove the second and fourth drive declutch shift shaft
12. Use the plastic hammer to knock out the rear output shaft
assembly, front output shaft assembly and chain out slightly
13. Remove the second/fourth shift block and high and low gear
shift fork
14. Remove the housing of transfer case
a. Use the wrench to remove 4 bolts M10
1.2535 and 2 nuts
M10
1.25 connected the gearbox and tranafer case housing
Caution: The tightening torque is 30
42 N•m when install
the connecting bolt of gearbox and housing of transfer case

b. Remove the housing of transfer case
15.Remove a location pin
For the disassembly of gearbox refer to “Disassembly of gearbox in
SC5M2D
C”