Extension HONDA ACCORD 2003 CL7 / 7.G Owners Manual

Touseavanitymirroronthebackof
the sun visor, pull up the cover.
The lights beside the mirror come
on when you pull up the cover.
In this position, the sun visor can be
adjusted by moving it on its slider.
All models except the DX have
lighted vanity mirrors.
To use the sun visor, pull it down.
You can also use the sun visor at the
side window. Remove the support
rod f rom the clip and swing the sun
visor toward the side window. In this
position, the sun visor can be
extended by sliding out the
extension (all models except DX and
those with side curtain airbags).
Do not use the sun visor extension
over the rear view mirror. Make sure you put the sun visor
back in place when you are getting
into or out of the car.
On EX-V6 models with side curtain
airbagsSun Visor Vanity Mirror
Sun Visor, Vanit y Mirror
Inst rument s and Cont rols106
EXTENSION
——yy
(y
y

CONT INUED
Use the extension and wheel
wrench as shown to raise the car
until the f lat tire is of f the ground.
Do not attempt to forcibly pry the
wheel cover of f with a screwdriver
or other tool. The wheel cover
cannot be removed without f irst
removing the wheel nuts.Remove the wheel nuts and f lat
tire. Temporarily place the f lat tire
on the ground with the outside
surf ace of the wheel f acing up.
You could scratch the wheel if you
putitfacedown.
Locate the jacking point nearest
thetireyouneedtochange.Place
the jack under the jacking point.
Turn the end bracket clockwise
until the top of the jack contacts
the jacking point. Make sure the
jacking point tab is resting in the
jack notch.
9.
10.
11.
U.S. DX and LX models:
Changing a Flat T ire
T aking Care of t he Unexpect ed337
JACKING POINT WHEEL WRENCH
EXTENSION
——y
y
(yy