HONDA ACCORD 2005 CL7 / 7.G Manual PDF

µµ
µ
µ
The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III). If the f ront wheels are turned, the
anti-theft lock may make it difficult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can insert or
remove the key only in this position.
To turn the key, push it in slightly. If
your vehicle has an automatic
transmission, the shif t lever must
also be in park. You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
the driver’s door. Remove the key to
turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
You can
operate the audio system and the
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom ACCESSORY
(I) to ON (II).
Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
Ignition Switch
LOCK (0) A CCESSORY (I)
ON (II)
ST A RT (III)
Inst rument s and Cont rols
75
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control.
Remove the key from the
ignition switch only whenparked.
 — — y
 y
(% y  y

Youcanopenorclosethewindows
by using the key in the driver’s door
(see page ).
To unlock only the driver’s door
f rom the outside, turn the key and
releaseit.If youturnitagain,both
doors unlock.
The lock tab on the passenger’s door
locks and unlocks only that door.
Pulling up on the driver’s door lock
tab only unlocks the driver’s door.
Pushing the bottom of either master
door lock switch will unlock both
doors. To lock the passenger’s door when
getting out of the vehicle, push the
lock tab down and close the door. To
lock the driver’s door, remove the
key f rom the ignition switch and
push the lock tab down or push the
top of the master switch, then close
the door.
With the driver’s door open and the
key in the ignition, both master door
lock switches are disabled. They are
not disabled if the driver’s door is
closed. Pushing the top of the switch
on the open passenger’s door will
lock both doors.
To lock the doors, push the top of
the master door lock switch on
either door, press the lock tab down
on the driver’s door, or use the key
on the outside lock on the driver’s
door.
91
Power Door L ocks
L ockout Prevent ion
76
MASTER DOOR LOCK SWITCH LOCK TAB
 — — y
  y
(% y  y

µµ
µ
µ
CONT INUED
Press this button once to
lock both doors. Some exterior lights
will f lash once. When you push
LOCK twice within 5 seconds, you
will hear a beep to verify that the
doors are locked and (if equipped)
that the security system has set. You
cannot lock the doors if either door
is not f ully closed or the key is in the
ignition switch. You can also open both power
windows from outside the vehicle
with the remote transmitter (see
page ).
Press this
button f or about 1 second to open
the trunk. You cannot open the trunk
if the key is in the ignition switch.
Pressthisbuttonfor
about 2 seconds to attract attention:
thehornwillsoundandtheexterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to ON (II).
Press this button once
to unlock the driver’s door. Push it
twice to unlock the passenger’s door.
Some exterior lights will f lash twice
each time you push the button.
The ceiling light (if the ceiling light
switch is in the center position) and
the spotlights (if the switch is in the
Door position) will come on when
you press the UNLOCK button. If
you do not open either door within
30 seconds, the lights f ade out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the lights will go of f
immediately.
If you do not open either door within
30 seconds, the doors automatically
relock, and the security system sets
(except f or 4-cylinder LX model).
You cannot unlock it if the key is in
the ignition switch. 90
Remote Transmitter
LOCK
T RUNK REL EA SE
PA NIC
UNL OCK
Inst rument s and Cont rols
77
UNLOCK
BUTTON
LOCK
BUTTON
TRUNK
RELEASE
BUTTON
PANIC
BUTTON LED
 — — y
 
y
(% y   y

Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
To replace the battery:
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR1616 Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover.
Separate the transmitter by prying
its middle seam with your
f ingernail.
1. 2. 3.
Remote Transmitter
Remote Transmitter CareReplacing the Transmitter
Battery
78
SCREW
TAB
BATTERY
 — — y
 y
(% y  
y

´
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to the
f ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept any
interf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing two
conditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may cause
undesired operation of the device.Remove the old battery from the
back of the inner cover, and insert
a new battery into the back of the
cover with the side f acing down.
Install the parts in reverse order.
4. 5.
Remote Transmitter
Inst rument s and Cont rols
79
 — — y
 y
(% y  y

Keep the trunk lid closed at all times
while driving to avoid damaging the
lid, and to prevent exhaust gas f rom
getting into the interior. Seeon page .
To protect items in the trunk when
you need to give the key to someone
else: Lock the trunk release handle
with the master key.
Give the person the valet key. As a saf ety f eature, your vehicle has
a release lever on the trunk latch so
the trunk can be opened f rom the
inside. To open the trunk, push the
release lever to the lef t.
Parents should decide if their
children should be shown how to use
this f eature. For more inf ormation
about child saf ety, see page .
Youcanopenthetrunkintwoways:
Pull the trunk release handle to
the lef t of the driver’s seat.
Press and hold the trunk release
button on the remote transmitter.
To close the trunk, press down on
the trunk lid. 1. 2. 35
49
Trunk
Carbon
Monoxide Hazard Emergency T runk Opener
80
Pull
TRUNK RELEASE HANDLE MASTER
KEY
 — — y
 y
(% y  y

µ
The 4-cylinder EX model has a
power seat bottom height
adjustment. All other driver’s seat
adjustmentsinthismodelare
manual.
The 4-cylinder LX model has manual
driver’s seat adjustments (see next
column).
The f ront passenger’s seat in all
models adjusts manually.To adjust the seat forward and
backward, pull up on the bar under
the seat cushion’s f ront edge. Move
the seat to the desired position and
releasethebar.Trytomovetheseat
to make sure it is locked in position.
Make all seat adjustments bef ore
you start driving.
All V6 models and the 4-cylinder EX
with Leather models have a power
adjustable driver’s seat.
To change the seat-back angle of the
f ront seat, pull up on the lever on the
outside of the seat bottom.
See pages f or important saf etyinf ormation and warnings about how toproperly position the seats and seat-
backs. 11 13
Seats
Manual Seat Adjustments
Inst rument s and Cont rols
81
 — — y
  y
(% y  y

The height of your driver’s seat is
adjustable. To raise the seat bottom,
repeatedly pull up the lever on the
outside of the seat cushion. To lower
the seat, push the lever down
repeatedly.
Make all seat adjustments bef ore
you start driving.Make sure to pull the lever upward
or downward to its f ull range.
The height of your driver’s seat is
power adjustable. Pull up on the
switch to raise the seat. Push it down
to lower the seat.
Make all seat adjustments bef ore
you start driving.
On 4-cylinder EX model
On 4-cylinder LX model
Seats
Driver’s Seat Manual Height
Adjustment Driver’s Seat Power Height
Adjustment
82
 — — y
 
y
(% y  y

µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-
backs. 11 13
On all V6 models, and the 4-cylinder EX
with Leather model
The controls f or the adjustable
driver’s power seat are on the
outside edge of the seat bottom. You
can adjust the power seat with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving.
Moving the long horizontal switch
adjusts the seat bottom in several
directions. The seat bottom adjusts
in the direction you move the switch.
The short vertical switch adjusts the
seat-back angle. Raises or lowers the
seat.
Adjusts the seat-
back angle f orward
or backward.
Moves the f ront of
the seat up or down
and the rear of the
seat up or down.
Moves the seat
forward and
backward.
Seats
Power Seat A djustments
Inst rument s and Cont rols
83
 — — y
 y
(% y  y

To change the lumbar support, move
the lever on the right side of the
seat-back forward or backward.
Keep moving the lever f orward or
backward until you f ind a suitable
position.To use the console lid as an armrest,
slide it to the desired position.
Make sure the passenger’s hands or
fingersareawayfromthearmrest
bef ore moving it.
To get into the rear seat on the
driver’s side, open the door and pull
the release lever up on the side of
the seat-back. The seat-back will tilt
f orward to allow easier entry to the
rear seat.
On all EX and EX-V6 models
On all V6 models and 4-cylinder EX with
Leather model
Seats
Driver’s L umbar Support A rmrest Rear Seat A ccess
Driver’s Side
84
RELEASE LEVER
 — — y
 y
(% y  y