clock HONDA ACCORD 2005 CL7 / 7.G Owners Manual
[x] Cancel search | Manufacturer: HONDA, Model Year: 2005, Model line: ACCORD, Model: HONDA ACCORD 2005 CL7 / 7.GPages: 289, PDF Size: 8.32 MB
Page 1 of 289
Your Vehicle at a Glance
Your Vehicle at a Glance
3
POWER WINDOW
SWITCHES
MIRROR CONTROLS
AUDIO SYSTEM
POWER DOOR LOCK
MASTER SWITCH
HOOD RELEASE
HANDLE AUTOMATIC TRANSMISSION
MANUAL TRANSMISSION HEATING/COOLING
CONTROLS
CLIMATE CONTROL
SYSTEM
FUEL FILL DOOR/
TRUNK RELEASE HANDLE INSTRUMENT PANEL INDICATORS
GAUGES
ACCESSORY POWER SOCKETS FRONT PASSENGER
AIRBAG
DRIVER’S FRONT
AIRBAG
HAZARD WARNING BUTTON
(P.55)
(P.63)
(P.9, 22)
(P.93)
(P.76)
(P.89)
(P.161, 80) (P.162)
(P.99)(P.176)
(P.179)
(P.111)
(P.104) (P.9, 22)
(P.116)
(P.70)
CLOCK (P.150)
— — y
y
(% y y
Page 50 of 289
Control L ocations
54
MIRROR CONTROLS
POWER WINDOW
SWITCHESHOOD RELEASE
HANDLE AUDIO SYSTEM
POWER DOOR LOCK
MASTER SWITCH
CLIMATE CONTROL
SYSTEM
HEATING/COOLING
CONTROLS
HAZARD WARNING
BUTTON
INSTRUMENT PANEL INDICATORS
GAUGES
ACCESSORY
POWER SOCKETS
FUEL FILL
DOOR/
TRUNK
RELEASE
HANDLE
SEAT HEATER
SWITCH
(P.63)
(P.55)
(P.93)
(P.76)
(P.89)
(P.161, 80) (P.162) (P.88)
(P.99)(P.111)
(P.104)
(P.150)
(P.70)
(P.116)
CLOCK
— — y
y
(% y y
Page 83 of 289
CONT INUED
When storing cargo, you can move
therearcentershoulderbeltoutof
the way by removing the belt f rom
the guide.Do not put any heavy items on the
seat-back when it is folded.
To release the seat-back from inside
the trunk, pull the release under the
trunk panel. Push the seat-back
down, then let go of the release.
To lock the seat-back upright, push it
firmly against the trunk panel. Make
sure it is latched in place by pulling
on the top of the seat.
The left and right halves of the rear
seat can be folded separately from
inside the vehicle or inside the trunk.
To fold down the seat-back from
inside the vehicle, insert the master
keyinthelockontherearshelf.To
f old down the driver’s side, turn the
key clockwise, pull down the top of
the seat-back, then release the key.
To f old down the passenger’s side,
turn the key counterclockwise and
perf orm the same procedure.
Seats
Folding Rear Seat
Inst rument s and Cont rols
87
GUIDE
Pull
CENTER
SHOULDER BELT
MASTER KEY
— — y
y
(% y y
Page 87 of 289
To close the windows f urther, turn
andholdthekeyagain(within
10 seconds).
NOTE: If the window stops bef ore
the desired position, repeat steps 2
and 3.
Turnthekeyclockwiseagain,and
hold it. Both windows start to open.
To stop the windows, release thekey.
To open the windows f urther, turn
andholdthekeyagain(within
10 seconds).
NOTE: If the window stops bef ore
the desired position, repeat steps 2
and 3.
To close: Insert the key in the driver’s door
lock.
Turn the key counterclockwise
again, and hold it. Both windows
starttoclose.Tostopthewindows,
release the key.
Turn the key counterclockwise,
then release it.
Insert the key in the driver’s door
lock.
Turn the key clockwise, then
release it.
To open:
You can open and close the windows
with the key in the driver’s door lock.
1. 2.3.
4.
3.
4.
1.2.
Opening/Closing the Windows
with the Key
Power Windows
Inst rument s and Cont rols
91
UNLOCK BUTTON
Open
Close
— — y
y
(% y y
Page 101 of 289
ÛÝ
When the indicator in the DUAL
button is off, both sides adjust to the
same temperature.
Press the DUAL button to select
dual temperature control mode (see
page ).
This button turns the air
conditioning on and of f . The
indicator above the button is on
when the A/C is on.
On EX with Leather and EX-V6
models, see page f or automatic
climate control and semi-automatic
operation inf ormation.
Select the f an speed by pressing the
A/C button to view the display, then
press any of the f an control icons.
Turning this dial clockwise increases
the temperature of the airflow.
The driver and passenger can select
independent temperature settings.Press the DUAL button. The
indicator in the button will come on.
The driver and passenger can each
select the temperature control
buttons ( or ) to the
desired setting.
Turn this dial to increase or decrease
the fan speed and airflow.
Select the f an speed by pressing the
fan control buttons ( or ).
The f an speed is shown by vertical
bars in the display. Push the DUAL button. When the indicator in the button is on, turn the
dials to adjust the temperature. 113
111
Vehicles without navigation system
Vehicles with navigation system
Vehicles without navigation system Vehicles with navigation system
On all models except EX with Leather and EX-V6 models
On EX with Leather and EX-V6 models On all models except EX with Leather
and EX-V6 models
On EX with Leather and EX-V6 models On EX with Leather and EX-V6 models
On all models except EX with Leatherand EX-V6 models
Vents, Heating, and A/C
Dual Button
Air Conditioning (A/C) Button/ Icons
T emperature Control
Fan Control
106
— — y
y
(% y
y
Page 121 of 289
µ
µ µ
µ
The
seek/skip f unction selects the
various categories in XM, such as
Jazz/Blues, Rock, Classical, etc.
Push the to change the
category f orward. Push the to
change the category backward. To
search f or channels within a
category, turn the TUNE knob
clockwiseorpresstheTUNEbar .
Press and release this
button to change the display. The
display will change in the f ollowing
sequence: channel name, channel
number, category, artist name, and
music title. The scan f unction samples
all channels f or 5 seconds. To
activate the f unction, push the SCAN
button. Push it again to get out of the
sequence.
Each preset icon or each
side of the preset bar can store one
channel in XM1 and one in XM2.
Push the SAT button, you will see
XM1 or XM2.
Use the TUNE, SEEK or SCAN
function to tune the radio to a
desired channel.
Pick a preset icon or number and
hold it until you hear a beep. Once your XM channels are preset,
pressing either side of the CH/DISC
bar will select your preset channels.
Repeat steps 1 through 3 to store a
total of six stations on XM1 and
six on XM2.
1. 2. 3. 4.
Vehicles with navigation system Vehicles with navigation system
SEEK /SK IP (CA T EGORY)
DISPSCAN
Preset
Playing t he XMSatellite Radio
126
— — y
y
(% y
y
Page 145 of 289
The upper display shows the time
when the ignition switch is in the
ACCESSORY (I) or ON (II) position.
The navigation system receives
signals f rom the Global Positioning
System (GPS), and the displayed
time is updated automatically by the
GPS. Ref er to the navigation system
owner’s manual to set up the time.
If your vehicle’s battery is
disconnected or goes dead, you will
need to set the clock.
To set the time, press the clock set
button (SOUND) until you hear a
beep. The displayed time begins to
blink.
Press and hold the H (Preset 4) side
of the bar until the hour advances to
the desired time. Press and hold the
M (Preset 5) side of the bar until the
minutes advance to the desired time.
Press the clock set button (SOUND)
again to enter the set time.
You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, pressing the
clock set (SOUND) button until you
hear a beep, then pressing the R
(Preset 6) side of the bar sets the
clockbacktotheprevioushour.If
the displayed time is after the half
hour, the clock sets f orward to the
beginning of the next hour.
For example:
1:06 will reset to 1:00
1:53 will reset to 2:00
On models without navigation system
On models with navigation system
Setting the Clock
150
CLOCK SET BUTTON
PRESET BARS
CLOCK
EX with Leather and EX-V6 models
without navigation system
— — y
y
(% y
y
Page 210 of 289
When the radiator and engine are
cool, relieve any pressure in the
cooling system by turning the
radiator cap counterclockwise,
without pressing down.
Remove the radiator cap by
pushing down and turning
counterclockwise.The coolant level should be up to
the base of the f iller neck. Add
coolant if it is low.
Pour coolant into the reserve tank.
Fill it to half way between the MAX
and MIN marks. Put the cap back
on the reserve tank.
Put the radiator cap back on, and
tighten it fully.
Pourthecoolantslowlyand
caref ully so you do not spill. Clean
up any spill immediately; it could
damage components in the engine
compartment.
4. 5.
1. 2. 3.
Engine Coolant
218
RESERVE TANK
4-cylinder models 6-cylinder models 4-cylinder models
RADIATOR CAP
RADIATOR CAP
— — y
y
(% y
y
Page 221 of 289
Remove the electrical connector
f rom the bulb by squeezing the
connector to unlock the tab, then
slide the connector of f the bulb.
Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
Install the new bulb and turn it
one-quarter turn clockwise to lock
it in place.Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
new bulb.
(Passenger’s side)
Reinstall the air intake cover.
Reinstall the two fasteners and
secure them by pushing on the
heads until they lock.
3.
2. 4. 5. 6. 7.
CONT INUED
Lights
Maint enance
229
6-cylinder models
AIR INTAKE
COVER
FASTENERS
4-cylinder models 6-cylinder models
TAB BULB
TABBULB
— — y
y
(% y y
Page 222 of 289
Remove the electrical connector
fromthebulbbysqueezingthe
connector to unlock the tab, then
slide the connector of f the bulb.
Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
lef t, and turn of f the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Use a f lat-tipped screwdriver to
remove the two holding clips f rom
the inner f ender. Pull the inner f ender cover away
f rom the f ender and bumper.
To change the low beam headlight
bulb on the driver’s side, remove
the air intake duct. You can reach
the air intake duct f rom the back
side of the inner f ender.
6.
5.
4.
1. 2. 3.
On EX-V6 model with manual
transmission
Lights
L ow Beam Headlight
230
AIR INTAKE DUCT
EX-V6 with M/T
HOLDING CLIPS
— — y
y
(% y y