navigation system HONDA ACCORD COUPE 2010 8.G User Guide

When you set the temperature to its
lower limit ( ) or its upper limit
( ), the system runs at f ull
cooling or heating only. It does not
regulate the interior temperature.
When you adjust a f an control, the
f an is taken out of AUTO mode.
In AUTO mode, the vehicle’s interior
temperature is independently
regulated f or the driver and f ront
passenger according to each
adjusted temperature. The system
also regulates each temperature
basedontheinformationof thesun
light sensor and the sun’s position
which is updated automatically by
the navigation’s global positioning
system (GPS). If one side of the
vehicle is getting too much sun, the
system lowers the temperature only
on that side.
When you press this button, the
indicator in the button comes on, and
the passenger’s side temperature is
synchronized to the driver’s side set
temperature. Changing the
passenger’s side temperature makes
the indicator go off and takes the
system out of SYNC mode.
Each time you press this button, the
climate control system switches
betweenonandoff.Turningonthe
system with this button selects your
last climate control selection.
To turn the system completely of f ,
press the ON/OFF button.
Keep the system completely of f
f or short periods only.
To keep stale air and mustiness
f rom collecting, you should have
the f an running at all times.On models with navigation system
Climate Control System
To Turn Everything OffSYNC Button
ON/OFF Button
Features
127
——
y
y
)y
y
2010 Accord Sedan

Û
Ý
When the indicator in the button is
on, air f rom the vehicle’s interior is
sent through the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
The outside air intakes f or the
climate control system are at the
base of the windshield. Keep this
area clear of leaves and other debris.
You can manually select various
f unctions of the climate control
system when it is in f ully automatic
mode. All other f eatures remain
automatically controlled. Making any
manual selection causes the word
AUTO in the display to go out.
Push the switch up to increase the
fanspeedandairflow.Pushthe
switch down to decrease them.
This button turns the air
conditioningonandoff.Youwillsee
A/C ON or A/C OFF in the display.
When you turn the A/C of f , the
system cannot regulate the inside
temperature if you set the
temperature control below the
outside temperature.
Press the side of the bar to
increase the f an speed and airf low.
Press the side of the bar to
decrease them.
On models without navigation system
On models with navigation system
Recirculat ion But t onA ir Condit ioning (A /C) But t onSemi-automatic Operation
Fan Control
Climate Control System
128
——
y

y
)y
y
2010 Accord Sedan

Your vehicle has two temperature
control switches, one f or the driver,
and one f or the f ront passenger.
The temperatures of the driver’s side
and the front passenger’s side are
controlled independently.
Climate Control System
Dual Temperature ControlWithout navigation system
With navigation system
130
PASSENGER’S SIDE TEMPERATURECONTROL SWITCH
DRIVER’S SIDETEMPERATURECONTROL SWITCH
PASSENGER’S SIDETEMPERATURECONTROL SWITCH
DRIVER’S SIDETEMPERATURECONTROL SWITCH
SYNC BUTTON
SYNC BUTTON
09/07/08 21:38:22 31TA5620_135
2010 Accord Sedan

The selected temperatures appear in
the display (in the center display on
models with navigation system).
When the indicator in the SYNC
button is on, you can adjust both
sides to the same temperature by
pushing the driver’s side
temperature control switch up or
down.
When you set the temperature to its
upper or lower limit, it is displayed as
or .
Climate Control System
Synchronized Cont rol
Features
131
DRIVER’S SIDEPASSENGER’S SIDE
U.S. model is shown.
——
y

y
)y
y
2010 Accord Sedan

An audio system is standard on all
models. Read the appropriate pages
(as shown below) to use your
vehicle’s audio system.
On models with navigation system,
see pages through .
On EX and EX V6 models, and EX-L
and EX-L V6 models without
navigation system, see pages
through .
On LX model (including LX-P), see
pages through .
149 173
174 205
148134
Audio System
Features
133
With navigation system
U.S. models are shown.
LX and LX-PEX and EX V6
EX-L and EX-L V6 without navigation system
——
y

y
)y
y
2010 Accord Sedan

Most audio system f unctions can be
controlled by standard buttons, bars,
and knobs. In addition, you can
access some f unctions by using the
selector knob on the audio system.
The knob turns lef t and right. Use it
to scroll through lists, or to make
selections or adjustments to a list or
menu item on the display. When you
make a selection, push the center of
the selector (ENTER) to go to that
selection.
When the audio system is in XM
Radio mode or playing discs, pushing
the selector (ENTER) knob switches
the display between the normal
display and the extended display.
The extended display has three
segments to display the detailed
inf ormation.
To select any setting such as the
clock, sound adjusting, or the
compass (if equipped), press the
MENU button. To use any audio
system f unction, the ignition switch
must be in the ACCESSORY (I) or
ON (II) position. You can select the
item by turning the selector knob.
To go back to the previous display,
press the RETURN button.
Pressing the MENU button again
will also cancel the menu display
mode.
Audio System (EX, EX-L and V6 models without navigation system)
Selector K nobMenu Display
Features
149
SELECTOR KNOBMENUBUTTONRETURNBUTTON
——
y

y
)y
y
2010 Accord Sedan

Playing the FM/AM Radio (EX, EX-L and V6 models without navigation system)
Without XMRadioWith XMRadio
150
SKIP BAR
SELECTOR KNOB
PRESETBUTTONS
RETURN BUTTON
A.SEL (AUTOSELECT) BUTTON
SCANBUTTON
MENU BUTTON
SKIP BAR
SELECTORKNOB
PRESETBUTTONS
RETURN BUTTON
CATEGORYBARA.SEL (AUTOSELECT) BUTTON
TITLEBUTTONTITLEBUTTON
MENU BUTTON
FMBUTTON
SCAN BUTTON
FOLDER BAR
POWER/ VOLUMEKNOB
AM BUTTON
POWER/VOLUMEKNOB
AM BUTTON
FM BUTTON
U.S. models are shown.
——
y
y
)y
y
2010 Accord Sedan

µ
µ
µ
The band and f requency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
On the AM band, AM noise
reduction turns on automatically.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM or
FM button. Adjust the volume by
turning the power/volume knob.
You can use any of f ive methods to
f ind radio stations on the selected
band: tune, skip, scan, the preset
buttons, and auto select.
The skip f unction searches
up and down f rom the current
f requency to f ind a station with a
strong signal. To activate it, press
and hold the or side of the
SKIP bar until you hear a beep, then
release it.
On the FM band, you can also use
the f eatures provided by the radio
data system (RDS). For more
inf ormation on the RDS, see page
.
Use the selector knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency.
Each time you press and release
either side of the SKIP bar, the radio
f requency changes in small
increments.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.
153
CONT INUED
To Select a StationTo Play the Radio
SK IP
TUNE
SCAN
Playing the FM/AM Radio (EX, EX-L and V6 models without navigation system)
Features
151
——
y

y
)y
y
2010 Accord Sedan

µµEach preset button can
store one f requency on AM and two
f requencies on FM.
If you are
traveling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if auto
select cannot f ind a strong station f or
that preset button.
If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons as previously described.
,pressthe
A. SEL (auto select) button. This
restores the presets you originally
set.
Press the A. SEL button. ‘‘A-SEL’’
f lashes in the display, and the system
goes into scan mode f or several
seconds. It stores the f requencies of
six AM and twelve FM stations in
the preset buttons.
For inf ormation on FM/AM radio
f requencies and reception, see page
.
Select the desired band, AM or
FM. FM1 and FM2 let you store
six stations each.
Usethetune,skip,scan,orRDS
function to tune the radio to a
desired station.
Pick a preset button, and hold it
until you hear a beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
1.
2.
3.
4.
209
To turn of f auto selectPresetA UT O SEL ECT
Playing the FM/AM Radio (EX, EX-L and V6 models without navigation system)
152
——
y
y
)y
y
2010 Accord Sedan

On the FM band, you can select a
favorite station and display the
program service name provided by
the radio data system (RDS).
The RDS inf ormation display
f unction shows the name of the RDS
station you are listening to. With the
audio system on and the FM band
selected, you can turn this f unction
on or of f .
To switch the function between on
and off, press and release the TITLE
button. With the system on, you will
see the ‘‘RDS INFO ON’’ message on
the display. If the station you are
listening to is an RDS station, the
displayed f requency switches to the
station name.
If the station you are listening to is
not an RDS station, the display
continues to show the f requency
with the RDS inf ormation display
f unction on.
When you turn of f this f unction by
pressing the TITLE button, the
display shows ‘‘RDS INFO OFF.’’
CONT INUED
Playing the FM/AM Radio (EX, EX-L and V6 models without navigation system)
Radio Data System (RDS)
RDS INFO DisplayFeatures
153
RDS INFO DISPLAY ON
09/07/08 21:38:42 31TA5620_158
2010 Accord Sedan