steering HONDA ACCORD SEDAN 2003 (in English) Service Manual

µ
µ
Ø
Ø Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ì
Ì
Î
Î
Ì
Î
Î
6-cylinder Models
Maint enance258
Canadian Owners U.S. Owners A, B, C, D, E
AB
C
D E
Use the Maintenance Schedule for Severe Conditions.
Refer to page to determine which schedule to use.
3,750 mi/6,000 km
7,500 mi/12,000 km
11,250 mi/18,000 km
15,000 mi/24,000 km/1 yr
18,750 mi/30,000 km
22,500 mi/36,000 km
26,250 mi/42,000 km
30,000 mi/48,000 km/2 yrs
33,750 mi/54,000 km
37,500 mi/60,000 km
41,250 mi/66,000 km
3yrs
45,000 mi/72,000 km/3 yrs
48,750 mi/78,000 km
52,500 mi/84,000 km
56,250 mi/90,000 km
60,000 mi/96,000 km/4 yrs
60,000 mi/96,000 km/4 yrs,
then replace every 30,000mi/
48,000 km/2 yrs
63,750 mi/102,000 km
67,500 mi/108,000 km
71,250 mi/114,000 km
75,000 mi/120,000 km/5 yrs
78,750 mi/126,000 km Do item in A.
Do items in A, E.
Do item in A.
DoitemsinA,B,E.
Do item in A.
Do items in A, E.
Do item in A.
DoitemsinA,B,D,E.
Do item in A.
Do items in A, E.
Do item in A.
Replace brake fluid (independent of mileage).
DoitemsinA,B,E.
Do item in A.
Do items in A, E.
Do item in A.
DoitemsinA,B,D,E. Replace automatic transmission fluid.
Do item in A.
Do items in A, E.
Do item in A.
DoitemsinA,B,E.
Do item in A. Replace engine oil and oil filter.
Replace air cleaner element.
Lubricate all hinges, locks, and latches.
Check parking brake adjustment.
Inspect brake hoses and lines (including ABS).
Check all fluid levels, condition of fluids, and check
for leaks.
Inspect exhaust system.
Inspect fuel lines and connections.
Check all lights.
Inspect the underbody.
Replace spark plugs.
Inspect valve clearance. Replace timing belt and inspect water pump.
Inspect drive belt.
Replace dust and pollen filter .
Inspect front and rear brakes.
Rotate tires (follow pattern on page 306).
Inspect tie rod ends, steering gear box, and boots.
Inspect suspension components.
Inspect drive shaft boots.
Service at the indicated distance or time, whichever comes first. Do the items in
as required for each distance/time interval.
248
See information on maintenance and emissions warranty, last
column, page .
See timing belt on page for replacement information under
special driving conditions.
See dust and pollen filter on page for replacement
information under special driving conditions.
Check engine oil and coolant at each fuel stop.
Check and adjust valve clearance, cold engine, only if noisy.
NOTE: :
1:
2: 249
302
300
1
2
Maintenance Schedule for Severe Conditions (listed by distance/time)

4-cylinder Models
Maint enance
Fluid Locations
266
BRAKE FLUID
(Gray cap)
ENGINE OIL DIPSTICK
(Orange handle)
WASHER FLUID
(Blue cap)
POWER STEERING
FLUID (Red cap)
RADIATOR CAPCLUTCH FLUID
(5-speed Manual
Transmission only)
(Light gray cap)
ENGINE OIL
FILL CAP
AUTOMATIC
TRANSMISSION
FLUID DIPSTICK
(Yellow loop)
COOLANT
RESERVOIR

6-cylinder Models
Fluid Locations
Maint enance267
ENGINE OIL FILL CAPBRAKE FLUID
(Gray cap)
AUTOMATIC
TRANSMISSION
FLUID DIPSTICK
(Yellow loop)
COOLANT
RESERVOIR
RADIATOR CAP
POWER STEERING
FLUID (Red cap) WASHER FLUID
(Blue cap) ENGINE OIL DIPSTICK
(Orange loop)

The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If it is not, add
brake f luid to bring it up to that level.
Use the same fluid specified for the
brake system.
Low f luid level can indicate a leak in
the clutch system. Have this system
inspected as soon as possible.Check the level when the engine is
cold. Look at the side of the
reservoir. The f luid should be
between the UPPER LEVEL and
LOWER LEVEL. If it is below the
LOWER LEVEL, add power steering
f luid to the UPPER LEVEL.
CONT INUED
Clutch System
Power Steering
Brake and Clutch Fluid, Power Steering
Maint enance285
MAX
MIN UPPER LEVEL
4-cylinder models LOWER LEVEL LOWER LEVELUPPER LEVEL
6-cylinder models

The air cleaner element should be
cleaned or replaced according to the
time and distance recommendations
in the maintenance schedule.
Clean the air cleaner element by
blowing compressed air through it in
the opposite direction to normal air
f low. If you do not have access to
compressed air (such as a service
station), ask your Honda dealer to do
this service.
Follow the replacement procedure
for removal and reinstallation.
Always use Honda Power Steering
Fluid. If it is not available, you may
use another power steering f luid as
an emergency replacement.
However, continued use can cause
increased wear and poor steering in
cold weather. Have the power
steering system f lushed and ref illed
with Honda PSF as soon as possible.
A low power steering f luid level can
indicate a leak in the system. Check
the f luid level f requently and have
the system inspected as soon as
possible.
A ir Cleaner Element
Cleaning (Severe Condit ions)
Power Steering, A ir Cleaner Element
Maint enance286
T urning the steering wheel to f ull lef t
or right lock and holding it there can
damage the power steering pump.

When shopping f or replacement
tires, you may find that some tires
are ‘‘directional.’’ This means they
are designed to rotate only in one
direction. If you use directional tires,they should be rotated only front-to-
back.
Make sure the installer balances the
wheels when you have new tires
installed. This increases riding
comf ort and tire lif e. Your car’s
original tires were dynamic or ‘‘spin’’
balanced at the f actory. For best
results, have the installer perf orm a
dynamic balance. The tires that came with your car
were selected to match the perform-
ance capabilities of the car while
providing the best combination of
handling, ride comf ort, and long lif e.
Youshouldreplacethemwithradial
tires of the same size, load range,
speed rating, and maximum cold tire
pressure rating (as shown on the
tire’s sidewall). Mixing radial and
bias-ply tires on your car can reduce
its braking ability, traction, and
steering accuracy.
To help increase tire lif e and
distribute wear more evenly, you
should have the tires rotated every
10,000 miles (16,000 km). Move the
tires to the positions shown in the
chart each time they are rotated.
(U.S. LX, EX and EX-V6 models) Tire Rotation
Replacing T ires and Wheels
Maint enance
Tires
306
(For Non-directional
Tires and Wheels)Front Front
(For Directional
Tires and Wheels)Improper wheel weights can damage
your car’s aluminum wheels. Use only
Honda wheel weights f or balancing.

Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
new bulb.
Reinstall the air intake cover.
Reinstall the two fasteners and
secure them by pushing on the
heads until they lock.Use a f lat-tipped screwdriver to
remove the two holding clips f rom
the inner f ender.Pull the inner f ender cover away
f rom the f ender and bumper.
(Passenger’s side) Remove the electrical connector
fromthebulbbysqueezingthe
connector to unlock the tab, then
slide the connector of f the bulb. Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
If you are changing the bulb on
the passenger’s side, start the
engine, turn the steering wheel all
the way to the left, and turn off the
engine. If you are changing the
bulb on the driver’s side, turn the
steering wheel to the right.
6.
7. 5.
3.
4.
5.
1.
2.
L ow Beam Headlight
Lights
Maint enance314
HOLDING CLIPS
TAB BULB
6-cylinder models

Turn on the headlights to test the
new bulb. Push the electrical connector back
onto the bulb. Make sure it is on
all the way. Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Put the inner f ender cover in place.
Install the two holding clips. Lock
each one in place by pushing on
the center.If you are changing the bulb on
the passenger’s side, start the
engine, turn the steering wheel all
the way to the left, and turn off the
engine. If you are changing the
bulb on the driver’s side, turn the
steering wheel to the right.
Use a f lat-tipped screwdriver to
remove the holding clips f rom the
inner f ender.Pull the inner f ender cover away
f rom the f ender and bumper.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
1.
3.
2. 4.
9. 8. 7.
6.
CONT INUED
Replacing a Front T urn Signal/
Parking L ight Bulbs
Lights
Maint enance315
HOLDING CLIPS

If you decide to tow your car with all
f our wheels on the ground, make
sure you use a properly-designed and
attached tow bar. Prepare the car for
towing as described above, and leave
the ignition switch in Accessory (I)
so the steering wheel does not lock.
Make sure the radio and any items
plugged into the accessory power
socket are turned of f so they do not
rundownthebattery.
Emergency T owing
T aking Care of t he Unexpect ed359
The steering system can be damaged if
the steering wheel is locked. Leave the
ignition switch in Accessory (I), and
make sure the steering wheel turns
f reely bef ore you begin towing.Trying to lif t or tow your car by the
bumpers will cause serious damage.
The bumpers are not designed to
support the car’s weight.

CONT INUED
Battery......
Charging System Light . 58,348
............................
Jump Starting .342
..............................
Maintenance .294
............................
Specif ications .365
..............................
Bef ore Driving .203
..........................................
Belts, Seat .8
.........................
Beverage Holders .104
...................................
Body Repair .332
Brakes ...........
Anti-lock System (ABS) . 230
.............
Break-in, New Linings . 204
....................
Bulb Replacement .317
...........................................
Fluid .284
.......................................
Parking .102 .........................
System Indicator .58
........................
Wear Indicators .229
.............................
Braking System .229
........................
Break-in, New Car .204
..
Brightness Control, Instruments . 69
........................
Brights, Headlights .68
Bulb Replacement ..........................
Back-up Lights .318
..............................
Brake Lights .317
..............................
Ceiling Light .320
................
Door Courtesy Light . 321
................
Front Parking Lights . 315
.................................
Headlights .312
.........
High-mount Brake Light . 319
...................
License Plate Light . 319
............................
Specif ications .365
...................................
Spotlights .321
...............................
Trunk Light .322
....................
Turn Signal Lights . 315
................
Vanity Mirror Lights . 321
..............................
Bulbs, Halogen .312
...
Accessories and Modif ications . 212
................................
Accessories .212
.
Additional Safety Precautions . 213
............................
Modif ications .213
ACCESSORY (Ignition Key .......................................
Position) .78
.............
Accessory Power Socket . 107
....................
Additives, Engine Oil . 270
.....................................
Airbag (SRS) .9
.....................
Air Cleaner Element .286
............................
Air Conditioning .112
..............................
Maintenance .299
.........................................
Usage .112
.......................
Air Pressure, Tires .304
.......................
Alcohol in Gasoline .369
......................................
Antif reeze .273
Anti-lock Brakes (ABS) ................................
Description .230
...............................
Indicator .57, 231
...................................
Operation .230
.
Anti-thef t Steering Column Lock . 77
..........................
Appearance Care .325
..........................................
Armrest .103
................
Audio System . 134,150,169 .............
Automatic Speed Control . 195
..............
Automatic Transmission . 222
..........................
Capacity, Fluid .364
.......
Checking Fluid Level . 280,281
.......................................
Shif ting .223
.
Shif t Lever Position Indicator . 223
................
Shif t Lever Positions . 223
....................
Shif t Lock Release . 226
Index
A
B
I