dashboard HONDA ACCORD SEDAN 2006 (in English) User Guide

Use the mode control buttons or
icons to select the vents the air f lows
f rom. Some air f lows f rom the
dashboard corner vents in all modes.Air flows from the center
and corner vents in the dashboard.
Air f lows f rom the f loor
vents.
Air f lows f rom the def roster
vents at the base of the windshield. When you select or ,
the system automatically switches to
Fresh Air mode and turns on the
A/C. In these modes, the A/C stays
on with the indicator off.
When you select , the system
automatically switches to f resh air
mode.
Airf low is divided between
the vents in the dashboard and the
f loor vents.
Airf low is divided between
the f loor vents and the def roster
vents at the base of the windshield. The f low-through ventilation system
draws in outside air, circulates it
through the interior, then exhausts it
through vents near the rear window.
Each time you press the MODE
button, the display shows the mode
selected.
Press the A/C button to view the
display, then touch any of the mode
icons on the display. The system automatically
turns on the A/C, selects ,
and switches to recirculation mode.
Each indicator above the button is on
when the MAX A/C is turned on.
Set the temperature to the lower
limit.
Make sure the A/C is of f .
Select and fresh air mode.
Set the f an to the desired speed.
1.
2.
3.
4.
EX-L and EX-V6 without Navigation
System
EX-L and EX-V6 with NavigationSystem U.S. VP, SE, EX and LX-V6
Canadian DX-G, SE and SE-V6
Mode Control MAX A/C Button
Ventilation
Vents, Heating, and A/C
106
 — — y y
( y 
 y

Û
Ý
Without Navigation System:
With Navigation System:
For Vehicles with Navigation System
EX-L and EX-V6Set the
desired temperature by turning
the Temperature Control dial. You
will see AUTO in the system’s
display. Press the AUTO button.
Set the
desired temperature by pressing
the to raise the temperature or to lower the temperature. The
selected temperature will show in
the upper display.
The automatic climate control
system adjusts the f an speed and
airflow levels to maintain the interior
temperature you select.
In the AUTO mode, the vehicle’s
interior temperature is
independently regulated f or the
driver and passenger. If the driver’s
side of the vehicle is getting too
much sun, the system will adjust to a
lower temperature.
Select . The system
automatically switches to f resh air
mode and turns on the A/C. The
A/C indicator does not come on if
it was previously off.
Select .
Set the f an and temperature
controls to maximum level.
To clear the windows f aster, you can
close the dashboard corner vents by
rotating the wheel below each vent.
This sends more warm air to the
windshield def roster vents. Once the
windshield is clear, select f resh air
mode to avoid f ogging the windows.
For your saf ety, make sure you have
a clear view through all the windows
bef ore driving. 1.
2.
3.
Vents, Heating, and A/C
Automatic Climate Control
T o Remove Exterior Frost or Ice
From the Windows
Features
109
 — — y y
( y 

y

Theclimatecontrolsystemhastwo
sensors. A sunlight sensor is in the
top of the dashboard, and a
temperature sensor is next to the
steering column. Do not cover the
sensors or spill any liquid on them.
If your vehicle has a climate controlsystem
Sunlight Sensor/T emperature
Sensor
Climat e Cont rol Sensors
Features
113
SUNLIGHT SENSOR TEMPERATURE SENSOR
 — — y y
( y 

y

The security system automatically
sets 15 seconds after you lock the
doors, hood, and trunk. For the
system to activate, you must lock the
doors from the outside with the key,
lock tab, door lock switch, or remote
transmitter. The security system
light on the instrument panel starts
blinking immediately to show you
the system is setting itself. Once
the security system is set,
opening any door (without using the
key or the remote transmitter), the
hood, or the trunk will cause it to
sound. It also sounds if the radio is
removed from the dashboard or the
wiring is cut. The
security system will not set if
the hood, trunk, or any door is not
f ully closed. If the system will not set,
check the Door Monitor on the
instrument panel (see page ), to
see if the doors and trunk are f ully
closed. Since it is not part of the
monitor display, manually check the
hood.
Do not attempt to alter this system
or add other devices to it.
The security system helps to protect
your vehicle and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lashes if
someone attempts to break into your
vehicleorremovetheradio.This
alarm continues f or two minutes,
then the system resets. To reset an
alarming system before the two
minutes have elapsed, unlock either
f ront door with the key or the
remote transmitter.
With the system set, you can still
open the trunk with the remote
transmitter without triggering the
alarm. The alarm will sound if the
trunk lock is f orced, or the trunk is
opened with the trunk release lever
or the emergency trunk opener.
60
U.S. EX, EX-L, LX-V6 and EX-V6Canadian SE, EX-L, SE-V6 and EX-V6
Security System
144
SECURITY SYSTEM INDICATOR
 — — y y
( y 
y

To Open the Hood:
Park the vehicle, and set the
parking brake. Pull the hood
release handle located under the
lower left corner of the dashboard.
The hood will pop up slightly. Put
your fingers under the front
edge of the hood near the center.
Slide your hand to the left until
you feel the hood latch handle.
Push this handle up to release it.
Li ft up the hood.
If the hood latch handle moves stiffly,
or if you can open the hood without
lifting the handle, the mechanism
should be cleaned and lubricated.
Screw
the fuel fill cap back on
until it clicks at least once. If you
do not properly tighten the cap,
maycomeon(seepage ).You
will also see a ‘‘CHECK FUEL
CAP’’ message on the odometer/
outside temperature display.
Push the f uel f ill door closed until
it latches.
1. 2.
5.
6.
251
Opening and Closing the Hood
Service Station Procedure
Bef ore Driving
157
HOOD RELEASE HANDLE
LATCH
 — — y

y
( y 
 y
the malf unction indicator lamp

Removing parts f rom your vehicle,
or replacing components with
af termarket components could
seriously af f ect your vehicle’s
handling, stability, and reliability.
Some examples are:Lowering the vehicle with an
aftermarket suspension kit that
signif icantly reduces ground
clearance can allow the
undercarriage to hit speed bumps
or other raised objects, which
could cause the airbags to deploy.
Raising your vehicle with an
aftermarket suspension kit can
af f ect the handling and stability.
Non-Honda wheels, because they
are a universal design, can cause
excessive stress on suspension
components. Larger or smaller wheels and tires
can interf ere with the operation of
your vehicle’s anti-lock brakes and
other systems.
If you plan to modif y your vehicle,
consult your dealer. Any object
attached to or placed on the covers
marked ‘‘SRS AIRBAG’’ in the
center of the steering wheel and
on top of the dashboard, could
interf ere with the proper operation
of the airbags. Or, if the airbags
inf late, the objects could be
propelled inside the vehicle and
hurt someone. If a side airbag
or a side curtain airbag inf lates, a
cupholderorotherhardobject
attached on or near the door could
be propelled inside the vehicle and
hurt someone.
This could prevent the
airbag from inflating properly.
Modif ying your steering wheel or
any other part of your vehicle’s
safety features can make the
systems inef f ective.
Modif ying Your Vehicle
Additional Saf ety Precautions
Do not at t ach or place object s onthe f ront airbag covers. Do not at t ach hard object s on or
near a f ront door.
Do not place any object s over orreplacetheoutsideedgeof afrontseat-back.
A ccessories and Modif ications
Bef ore Driving
163
 — — y 
y
( y 
y

The Vehicle Identif ication Number
(VIN) is the 17-digit number your
Honda dealer uses to register your
vehicle f or warranty purposes. It is
also necessary f or licensing and
insuring your vehicle. The easiest
placetofindtheVINisonaplate
fastened to the top of the dashboard.
Youcanseeitbylookingthrough
the windshield on the driver’s side. It
is also on the Certification label
attached to the driver’s doorjamb,
and is stamped on the engine
compartment bulkhead. The VIN is
also provided in bar code on the
Certif ication label. Your vehicle has several identif ying
numbers in various places.
Identif ication Numbers
264
VEHICLE IDENTIFICATION NUMBERCERTIFICATION LABEL
 — — y y
( y y

ÎÎ
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ µ
µ
µ
Î
Î
Î
CONTINUED
Specifications
T echnical Inf ormat ion
267
Lights Battery
Fuses
12
V 60 W (HB3)
12 V 51 W (HB4)
12 V 24/2.2 CP
12 V 21 W
Headlights
Front
turn signal/
Front parking lights
Rear turn signal lights
Back-up lights
License plate light
Ceiling light
Spotlights
Spotlights/Front ceiling lights
Trunk light
Door courtesy light
Vanity mirror lights 12
V
12 V
12 V
12 V
12 V
12 V
12 V
12 V 21
W
3CP
8W
8W
8W
5W
2CP
1.1 W Capacity
12 V
12 V
12 V 36
AH/5 HR
38 AH/5 HR
52 AH/5 HR
Interior
Under-hood See
page 261 or the fuse label
attached to the inside of the fuse
box door on each side of the
dashboard.
See page 260 or the fuse box
cover.
High
Low
4-cylinder
6-cylinder
U.S. LX, SE and LX-V6
Canadian SE and SE-V6
U.S. EX, EX-L and EX-V6
Canadian EX-L and EX-V6
Except U.S. VP and Canadian DX-G
1:
2:
3:
1
2
3
 — — y 
y
( y  y