Torque head HONDA CIVIC 2003 7.G Workshop Manual

HONDA CIVIC 2003 7.G Workshop Manual CIVIC 2003 7.G HONDA HONDA https://www.carmanualsonline.info/img/13/5744/w960_5744-0.png HONDA CIVIC 2003 7.G Workshop Manual

Page 54 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Spark Plug Inspection
1.Inspect the electrodes and ceramic insulator.
Burned or worn electrodes may be caused by:. Advanced ignition timing. Loose spark plug
. Plug heat range too hot.Insufficientcool

Page 107 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Cylinder Head
Crankshaft Pulley Removal and
Installation (contdl
Installation
1. Clean the crankshaft pulley (A), crankshaft (B), bolt(C). and washer (D). Lubricate as shown below.
. .: Clean
O; Lubr

Page 120 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Installation:
1. Install the VTC actuator and exhaust camshaft
sprocket.
2. Apply engine oil to the th reads of the VTC actuato r
mounting bolt and exhaust camshaft mounting bolt,
then install them.
3

Page 124 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Gamshaft Inspection
NOTE: Do not rotate the camshaft during inspection.
1. Remove the rocker arm assembly (see page 6-26).
and disassemble it (see page 6-27).
2. Put the rocker shaft holders, camshaft

Page 125 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Cylinder Head
Camshaft Inspection (contdl
1.
9.
Unscrew the camshaft holder bolts two turns at a
time, in a crisscross pattern. Then remove the
camshaft holders from the cylinder head.
Lift the camsh

Page 133 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Cylinder Head
Rocker Arm Assembly Installation
:,ean and dry the No. 5 rocker shaft holder mating
surfaces.
eeassemble the rocker arm assembly (see page 6-
21 t.
Apply liquid gasket, P/N 08718-0009, e

Page 135 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Cylinder Head
8.
Cylinder Head lnstallation (contd)
7.Apply engine oil to the bolt threads and under thebolt heads of all the cylinder head bolts.
Tighten the cylinder head bolts in sequence to 39N.m

Page 552 of 1139

HONDA CIVIC 2003 7.G Workshop Manual 30, Retighten the 12 mm flange bolts (A) to the
soecified toroue value.
After tightening the 12 mm flange bolts, install a
new stop plate (B) over one of the bolt heads. Be
sure the tabs (C) of the st

Page 554 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Steering Gearbox Installation
2.
1.Before installing the steering gearbox, slide the
rack all the way to the passengers side (right
direction).
Pass the right side of the steering gearbox together
w

Page 555 of 1139

HONDA CIVIC 2003 7.G Workshop Manual EPS Components
Steering Gearbox Installation (contd)
7. Installthe body stiffener (A), and torque the
mounting bolts to the specified torque.
8 x 1.25 mm29 N.m {3.0 kgf.m,22lbf.ftl
LInstall the heate
Page:   1-10 11-20 next >