buttons HONDA CIVIC COUPE 2006 8.G Owners Manual

Î
Î
Î
Î
Î
Î Î
Î
Only on vehicles equipped with navigation system. Ref er to the navigation system manual.
To use the horn, press the center pad of the steering wheel.
If equipped.
1:
2:
3:
Your Vehicle at a Glance
4
HEADLIGHTS/TURN SIGNALS
MIRROR CONTROLS REAR WINDOW
DEFOGGER
WINDSHIELD WIPERS/WASHERS
INSTRUMENT PANEL
BRIGHTNESS
SEL/RESET BUTTON
(P.70)
(P.71)(P.64)
(P.63)
(P.100)
TILT/
TELESCOPIC
ADJUSTMENT
(P.73)(P.175) HAZARD WARNING
BUTTON
(P.72)
ACCESSORY POWER
SOCKET
PASSENGER AIRBAG OFF
INDICATOR
(P.29)
(P.72)
(P.101)
(P.104)
(P.69)
DISPLAY CHANGE
BUTTON
HEATED MIRRORS
(P.170) REMOTE
AUDIO
CONTROLS
VOICE CONTROL SWITCHES CRUISE
CONTROL
BUTTONS
HORN
3
3
1 3
2
——y

y
(+yy

Place the child seat on the vehicle
seat, then attach the seat to the
lower anchors according to the
child seat maker’s instructions.
Your vehicle is equipped with
LATCH (lower anchors and tethers
for children) at the outer rear seats.
Make sure there are no objects
near the anchors that could
prevent a secure connection
between the child seat and the
anchors. Move the seat belt buckle or
tongue away f rom the lower
anchors.
To install a LATCH-compatible child
seat:
Some LATCH-compatible seats
have a rigid-type connector as
shown above.
The lower anchors are located
between the seat-back and seat
bottom, and are to be used only with
a child seat designed f or use with
LATCH.
The location of each lower anchor is
indicated by a small button above the
anchor point.
1.
2.3.
CONT INUED
Installing a Child Seat with
LATCH
Installing a Child Seat
Driver and Passenger Saf ety
41
LOWER ANCHORS
Rigid type
BUTTONS
——y
y
(+yy

Î
Î
ÎÎ
Î Î
Î
To use the horn, press the center pad of the steering wheel.
If equipped.
1
2
Controls Near the Steering Wheel
68
REAR WINDOW
DEFOGGER
WINDSHIELD WIPERS/WASHERS
PASSENGER’S AIRBAG OFF INDICATOR
ACCESSORY POWER
SOCKET
MIRROR CONTROLS
(P.69)
(P.29)
(P.115)
(P.72) (P.101)
(P.100)
(P.71)
HAZARD WARNING
BUTTON
INSTRUMENT PANEL
BRIGHTNESS
HEADLIGHTS/ TURN SIGNALS
(P.70)
EX model without navigation system is shown. HORN
(P.175)
TILT/TELESCOPIC
ADJUSTMENT
(P.73)
(P.170)
(P.104)(P.
72)
HEATED MIRRORS
REMOTE AUDIO CONTROLS AUDIO SYSTEM
CRUISE CONTROL BUTTONS
1 2
2 2
2
——y
y
(+y
y

´µ
With the headlight switch of f or in
the position, the high beam
headlights and the high beam
indicator come on with reduced
brightness when you turn the
ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch of f , even if you
set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
The buttons under the lef t side vent
control the brightness of the
instrument panel. Push the or
button to adjust the brightness.
Separate adjustments can be made
when the headlights are on and of f .
There are six brightness levels.
When you push either button, the
inf ormation display indicates the
current level. You will hear a tone when you reach the maximum or
minimum brightness. The display
returns to the odometer 5 seconds
af ter you stop adjusting the
brightness.
To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to
or .
The center of each meter (upper and
lower) illuminates with reduced
brightness when you unlock and
open the driver’s door, and then goes
back to the selected brightness when
you turn the ignition switch to the
ON (II) position.
If you insert the key but do not turn
the ignition switch to the ON (II)
position, the illumination turns of f in
about 7 seconds.
Daytime Running L ights
Instrument Panel Brightness
Headlights, Instrument Panel Brightness
Inst rument s and Cont rols
71
CONTROL BUTTONS
——y

y
(+yy

The spotlights have a two-position
switch. In the DOOR position, the
lights come on when you open either
door. In the OFF position, the lights
do not come on.
The spotlights (with the switch in
the DOOR position) also come on
when you unlock the door with the
key or the remote transmitter, and
when you remove the key f rom the
ignition switch.The courtesy light between the
spotlights comes on when you turn
the parking lights on. To adjust its
brightness, push the instrument
panel brightness control buttons
under the driver’s side vent.OnEXandSimodels
OnEXandSimodels
Interior Lights
Courtesy L ight
Inst rument s and Cont rols
107
DOOR ACTIVATED OFF POSITION
SPOTLIGHT
COURTESY LIGHT
——y
y
(+y

y

Î
Î
Î
Î
Vents, Heating, and A/C
110
MODE BUTTONS
RECIRCULATION BUTTON REAR WINDOW
DEFOGGER BUTTON/
HEATED MIRRORS
FAN CONTROL DIAL
If equipped TEMPERATURE CONTROL
DIAL
MAX A/C BUTTON AIR CONDITIONING BUTTON
——y
y
(+y

y

Turn this dial to increase or decrease
the fan speed and airflow.
Turning this dial clockwise increases
the temperature of the airflow.
This button turns the air
conditioning on and of f . The
indicatorinthebuttonisonwhen
the A/C is on.This button turns the rear window
def ogger of f and on (see page ).
Air flows from the center
and corner vents in the dashboard.
Airf low is divided between
the vents in the dashboard and the
f loor vents.
When the recirculation indicator is
on, air f rom the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
The system automatically
turns on the A/C and switches to
recirculation mode. Air f lows f rom
the center and side vents in the
dashboard. Pressing the or A/C
button cancels MAX A/C. On some models, this button also
operates the heated outside mirrors
(see page ).
Use the mode control buttons to
select the vents air flows from. Some
air will f low f rom the dashboard
corner vents in all modes.
72
101
CONT INUED
If equipped
If equipped
Vents, Heating, and A/C
Fan Control Dial
T emperature Control Dial
Air Conditioning (A/C) Button Rear Window Def ogger Button
Recirculation Button
MAX A/C Button Mode Control
Features
111
——y
y
(+y

y

Audio System (Models without navigation system)
Playing the AM/FM Radio
Features
117
U.S. LX and all Canadian modelsSCAN
BUTTON AUTO SELECT
BUTTONU.S. EX and Si models
AM
BUTTON FM
BUTTON AM/FM BUTTON AUTO SELECT BUTTON
POWER/VOLUME
KNOB PRESET
BUTTONSSEEK
BUTTONTUNE KNOB SEEK
BUTTONTUNE KNOB
PRESET
BUTTONS
POWER/VOLUME
KNOB
——y
y
(+y
y

µ
µ µ
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM or
FM button (the AM/FM button on
models with XM radio available).
Adjust the volume by turning the
power/volume knob.
The band and f requency that the
radio was last turned to are displayed.
To change bands, press the AM or
FM button (AM/FM button on
models that are XM radio capable).
On the FM band, ST will be
displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available. You can use any of f ive methods to
f ind radio stations on the selected
band: the
preset buttons, and .
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob to the right to tune a
higher f requency, and turn it to the
lef t to tune a lower f requency.
The SEEK f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press the or side of the
SEEK button, then release it. The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan f or a station
with a strong signal. When it f inds
one, it will stop and play that station
f or about 10 seconds.
If you do nothing, the system will
then scan f or the next strong station
and play it f or 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
To Select a Station
TUNE,SEEK,SCAN, AUTO SELECT
TUNE
SEEK SCAN
To Play the AM/FM Radio
Audio System (Models without navigation system)
118
——y
y
(+y

y

µµ µ
Each side of the buttons
(1 through 6) can store one
f requency on AM, and two
f requencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each side of
the preset button.
Usethetune,seek,orscan
function to tune the radio to a
desired station.
Pick a preset number (1 6), and
hold it until you hear a beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM. If you are
traveling far from home and can no
longer receive your preset stations,
you can use the auto select feature to
find stations in the local area.
Press the A. SEL button. You will see
A. SEL f lashing in the display, and
the system goes into scan mode f or
several seconds. It stores the
f requencies of six AM, and twelve
FM stations in the preset buttons.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if auto
select cannot f ind a strong station f or
every preset button. If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons as previously described.
,pressthe
A. SEL button. This restores the
presets you originally set.
For inf ormation on AM/FM radio
f requencies and reception, see page .
1.
2.
3.
4. 167
To turn of f auto select
Preset
A UT O SEL ECT
Audio System (Models without navigation system)
Features
119
——y
y
(+y
y