reset HONDA CIVIC HYBRID 2008 8.G Owners Manual
[x] Cancel search | Manufacturer: HONDA, Model Year: 2008, Model line: CIVIC HYBRID, Model: HONDA CIVIC HYBRID 2008 8.GPages: 300, PDF Size: 6.16 MB
Page 7 of 300
Î
Î
Î
ÎÎ
Î
Only on vehicles equipped with navigation system. Ref er to the navigation system manual.
To use the horn, press the center pad of the steering wheel.
Canadian model only
1:
2:
3:
Your Vehicle at a Glance
4
WINDSHIELD WIPERS/WASHERS
CRUISE CONTROL BUTTONS
(P.74)
(P.73)
INSTRUMENT PANEL
BRIGHTNESS BUTTONS (P.72)
DISPLAY CHANGE
BUTTON
(P.65)
SEL/RESET
BUTTON
(P.64)
REMOTE AUDIO
CONTROLS
HOOD RELEASE
HANDLE
STEERING WHEEL
ADJUSTMENT PASSENGER AIRBAG OFF
INDICATOR
(P.31)
HAZARD WARNING BUTTON
REAR WINDOW DEFOGGER
(P.75)
HEADLIGHTS/TURN SIGNAL
(P.167)
VOICE CONTROL
SWITCHES
(P.176) (P.76) (P.96)
HEATED MIRRORS
(P.75)
HORN
Vehicle with navigation system is shown (P.170)
3 2
1
\f—\f—\fy
\fy
(#\fy\f\f\fy
2008 Civic Hybrid
Page 64 of 300
When the indicator comes on, there
is about 0.9 US gal (3.5
)of fuel
remaining in the tank bef ore the
reading reaches E. There is a small
reserve of f uel remaining in the tank
when the reading does reach E.
This indicator comes on as a
reminder that you must ref uel soon.
This indicator goes of f when your
dealer resets it after completing the
required maintenance service.
This indicator reminds you that it is
time to take your vehicle in for
scheduled maintenance. The
maintenance main items and sub
items will be displayed in the
inf ormation display. See page f or
more inf ormation on the
maintenance minder.
This indicator comes on when you
turn on the cruise control system by
pressing the CRUISE button (see
page ).
This indicator comes on when you
set the cruise control. See page
f or inf ormation on operating the
cruise control.
This indicator comes on when the
washer f luid level is low. Add washer
fluidwhenyouseethisindicator
come on (see page ).
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
If this indicator comes on and stays
on at any other time, or if it does not
come on when you turn the ignition
switch to the ON (II) position, there
is a problem with the TPMS. With
this indicator on, the low tire
pressure indicator will not come on
when a tire loses pressure. Take the
vehicle to your dealer to have the
system checked.
170
170
220 207
Canadian models only
U.S. models only
Instrument Panel Indicators
Low Fuel Indicator
Maintenance Minder
Indicator
Cruise Main Indicator
Cruise Control Indicator
Washer Level Indicator
Tire Pressure Monitoring
System (T PMS) Indicator
Inst rument s and Cont rols
61
\f—\f—\fy
y
(#\fy\f\fy
2008 Civic Hybrid
Page 66 of 300
If you turn the steering wheel to the
f ull lef t or right position repeatedly
while stopping or driving at very low
speed, you may f eel slightly harder
steering due to overheating of the
steering gearbox.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. When the brake system
indicator (amber) is on, there is the
problem with the Cooperative
Control with regenerative brake,
Creep Aid System or Brake Assist
(the normal brake operates properly).
Have your vehicle checked by your
dealer.
For more inf ormation, see page .
Continuously driving under those
conditions could damage the power
steering system.
This indicator normally comes on
when you turn the ignition switch to
the ON (II) position and goes of f
af ter the engine starts. If it comes on
at any other time, there is a problem
in the electric power steering system.
If this happens, stop the vehicle in a
saf e place, and turn of f the engine.
Reset the system by restarting the
engine. The indicator will not turn
of f immediately. If it does not go of f
after driving a short distance, or
comes back on again while driving,
take the vehicle to your dealer to
have it checked. With the indicator
on, the EPS may be of f , making the
vehicle harder to steer.
199
Electric Power Steering
(EPS) Indicator
Brake System
Indicator
(A mber)
Instrument Panel Indicators
Inst rument s and Cont rols
63
U.S. Canada
\f—\f—\fy
y
(#\fy\f\fy
2008 Civic Hybrid
Page 67 of 300
To switch the information display
between the odometer, trip meter,
outside temperature, and engine oil
lif e and maintenance item code(s),
press the SEL/RESET button
repeatedly.
The odometer shows the total
distance your vehicle has been
driven. It measures in miles or
kilometers. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.
Gauges
Odometer
64
TRIP METER
SEL/RESET BUTTON DISPLAY CHANGE BUTTON TACHOMETER
INSTRUMENT PANEL BRIGHTNESS CONTROL BUTTONS INFORMATION
DISPLAYFUEL GAUGE
ODOMETER/OUTSIDE
TEMPERATURE INDICATOR
CURRENT FUEL MILEAGE/
TEMPERATURE GAUGE SPEEDOMETER
\f—\f—\fy
\f
y
(#\fy\f\fy
2008 Civic Hybrid
Page 69 of 300
When either of the trip meters (trip
A or trip B) is displayed, your
vehicle’s average fuel mileage since
you last reset that trip meter can be
shownontheinformationdisplay
(mpg or l/100km). This number is
updated once per 10 seconds. To see
the average f uel mileage, press and
release the SEL/RESET button
repeatedly.This shows how much f uel you have.
It may show slightly more or less
than the actual amount.
The average f uel mileage will be
reset when you reset the trip meter,
or if the vehicle’s battery goes dead
or is disconnected.
This meter shows the number of
miles or kilometers driven since you
last reset it.
There are two trip meters: TRIP A
and TRIP B. Switch between these
displays by pressing the SEL/
RESET button repeatedly.
Each trip meter works independently,
so you can keep track of two
dif f erent distances.
To reset a trip meter, display it, and
then press and hold the SEL/RESET
button until the number resets to
‘‘0.0.’’ A verage Fuel Mileage Fuel Gauge
Trip Meter
Gauges
66
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
\f—\f—\fy
y
(#\fy\f\f
y
2008 Civic Hybrid
Page 70 of 300
¶¶µ
µµµµ µµµ
If the outside temperature is
incorrectly displayed, you can adjust
it up to 5°F ( 3°C) warmer or
cooler.
NOTE: The temperature must be
stabilized bef ore doing this
procedure.
Select the outside temperature
display, then press and hold the
SEL/RESET button f or 10 seconds.
The f ollowing sequence will appear
for1secondeach:0,1,2,3,4,5, 5,
4, 3, 2, 1, 0 (U.S.) or 0, 1, 2,
3, 3, 2, 1, 0 (Canada).
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
When it reaches the desired value,
release the SEL/RESET button. You
should see the new outside
temperature displayed.
This indicator displays the outside
temperature in Fahrenheit (U.S.
models) or Centigrade (Canadian
models). To see the outside
temperature, press and release the
SEL/RESET button until the
temperature is shown on the
inf ormation display.
The temperature sensor is in the
f ront bumper. Theref ore, the
temperature reading can be af f ected
by heat ref lection f rom the road
surf ace, engine heat, and the
exhaust f rom surrounding traf f ic.
This can cause an incorrect
temperature reading when your
speed is under 19 mph (30 km/h).
The sensor delays the display update
until it reaches the correct outside
temperature. This may take several
minutes.
Gauges
Outside Temperature Indicator
Inst rument s and Cont rols
67
\f—\f—\fy
y
(#\fy\f\fy
2008 Civic Hybrid
Page 71 of 300
The inf ormation display in the
instrument panel shows you the
engine oil lif e and maintenance
service items when the ignition
switch is in the ON (II) position. This
inf ormation helps to keep you aware
of the periodic maintenance your
vehicle needs f or continued trouble-
f ree driving. Ref er to page f or
more inf ormation.
Your vehicle’s onboard diagnostic
system will detect a loose or missing
f uel f ill cap as an evaporative system
leak. The f irst time a leak is detected
a ‘‘CHECK FUEL CAP’’ message
appears on the information display.
Turn the engine of f , and conf irm the
f uel f ill cap is installed. If it is, loosen
it, then retighten it until it clicks at
least once. The message should go
off after several days of normal
driving once you tighten or replace
the f uel f ill cap. To scroll to another
display, press the SEL/RESET
button. The ‘‘CHECK FUEL CAP’’
message will appear each time you
restart the engine until the system
turns the message of f . If the system still detects a leak in
the vehicle’s evaporative emissions
system, the malf unction indicator
lamp (MIL) comes on. If the f uel f ill
cap was not already tightened, turn
the engine of f , and check or
retighten the f uel f ill cap until it
clicks at least once. The MIL should
go off after several days of normal
driving once the cap is tightened or
replaced. If the MIL does not go of f ,
have your vehicle inspected by a
dealer. For more inf ormation, see
page .
255 207
Gauges
Maintenance Minder
Check Fuel Cap Message
68
\f—\f—\fy
\fy
(#\fy\f\fy
2008 Civic Hybrid
Page 74 of 300
Î
Î
Î
Î
Î
Î
Only on vehicles equipped with navigation system. Ref er to the navigation system manual.
To use the horn, press the center pad of the steering wheel.
Canadian model only
1:
2:
3:
Controls Near the Steering Wheel
Inst rument s and Cont rols
71
REAR WINDOW
DEFOGGER
(P.31)
PASSENGER AIRBAG
OFF INDICATOR
(P.75)
CRUISE CONTROL BUTTONS (P.96)
HEATED MIRRORS
HAZARD WARNING
BUTTON
SEL/RESET BUTTON
DISPLAY CHANGE BUTTON
(P.65)
REMOTE AUDIO CONTROLS (P.74)
(P.64) (P.73)
INSTRUMENT PANEL BRIGHTNESS
HOOD RELEASE HANDLE WINDSHIELD WIPERS/WASHERS
(P.72)
STEERING WHEEL
ADJUSTMENT
HEADLIGHTS/TURN
SIGNAL
(P.167)
(P.176)
VOICE CONTROL
SWITCHES HORN
(P.76)
Vehicle with navigation system is shown. (P.170)(P.75)
2
3
1
\f—\f—\fy
\fy
(#\fy\f\fy
2008 Civic Hybrid
Page 113 of 300
Audio System (Models without navigation system)
110
AM
BUTTON
SCAN
BUTTON FM
BUTTONAUTO SELECT BUTTON
TUNE/SOUND KNOB
PWR/VOL KNOB
PRESET BUTTONSSEEK BUTTON
\f—\f—\fy
\f\fy
(#\fy\f
y
2008 Civic Hybrid
Page 114 of 300
µ
µ
µ µ
µ
CONT INUED
If you do nothing, the system will
then scan f or the next strong station
andplayitfor10seconds.Whenit
plays a station you want to listen to,
press the SCAN button again.
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency.
The seek f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press the or side of the
SEEK bar, then release it.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan f or a station
with a strong signal. When it f inds
one, it will stop and play that station
f or about 10 seconds.
You can use any of f ive methods to
find radio stations on the selected
band: tune, seek, scan, the preset
bars, and auto select.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Turn the system on by
pushing the PWR/VOL knob, or the
AM or FM button. Adjust the volume
by turning the PWR/VOL knob.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is broad-
castinginstereo.Stereo
reproduction on AM is not available. Each side of the buttons
(1 through 6) can store one
f requency on AM, and two
f requencies on FM.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Pick a preset number (1 6), and
hold it until you hear a beep.
Usethetune,seek,orscan
function to tune the radio to a
desired station.
Select the desired band, AM or
FM. FM1 and FM2 let you store
twelve stations.
1.
2.
3.
4.
To Play the Radio
To Select a Station
TUNE
SEEK
SCAN
Preset
Audio System (Models without navigation system)
Features
111
\f—\f—\fy
\f
y
(#\fy\f
y
2008 Civic Hybrid