camshaft HONDA CR-V 1998 RD1-RD3 / 1.G User Guide

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide CR-V 1998 RD1-RD3 / 1.G HONDA HONDA https://www.carmanualsonline.info/img/13/5778/w960_5778-0.png HONDA CR-V 1998 RD1-RD3 / 1.G User Guide

Page 133 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
Cylinder Head
Removal (contdl
Remove the timing belt (see page 6-10).
Remove the camshaft pulleys and back cover.2�t.
BACK COVER
6-20
22. Bemove the exhaust manifold
ing nuts.
97 - 98 U.S. modsls

Page 134 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
23. Remove the intake manifold mounting bolts and
water bvDass hose.
8 x 1.25 mm2,1 N.m 12.4 kgt.m,17 tbf.ft)
24. Loosen the locknuts and adjusting screws,
INTAKE
No.3 No.2 No. 1
No.3 No.2 No. 1
EXHA

Page 135 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
Camshafts
4.
Inspection
1.
7.
Loosen the adjusting screws.
Remove the camshaft holders.
Mark the rocker arms, then remove them.
Reinstall the camshaft and holders. Tighten the
camshaft holder bolts i

Page 139 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
Valve Guides
Replacement (contdl
5.
Working from the camshaft side, use the driver andan air hammer to drive the guide about 2 mm (O.l
in) towards the combustion chamber. This willknock off some of

Page 140 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
Cylinder Head
Reaming
NOTE: For new valve guides only.
1. Coat the reamer and the valve guide with cutting oil.
2. Rotate the reamer clockwise the full length of the
valve guide bore.
Continue to rot

Page 144 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
7.Place the rocker arms on the pivots and the valve
stems. Put the rocker arms in their original posi-
lrons.
lnstall the camshafts, then install the oil seals with
the open side (spring) facing in.

Page 145 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
Cylinder Head
Installation (contdl
13. Align the marks on the cylinder head plug to thecylinder head upper surface, then install the cylin
der head plug in the end of the cylinder head.
CYLINOER HE

Page 146 of 1395

HONDA CR-V 1998 RD1-RD3 / 1.G User Guide 
21.
22.
Check that the mating surfaces are clean and dry.
Apply liquid gasket, part No. 08718 - 0001 or 08718- 0003, to the head cover gasket at the eight corners
of the recesses.
NOTE:
. Do not inst
Page:   < prev 1-10 11-20