cruise control HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual CR-V 2000 RD1-RD3 / 1.G HONDA HONDA https://www.carmanualsonline.info/img/13/5778/w960_5778-0.png HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual

Page 86 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Gruise Control
Component Location Index
CRUISE CONTROL UNITInput Test, page 4 38
CRUISE INDICATOR LIGHT(Built into gauge assembly)Bulb Locations. section 23
swtTcHTest, page 4-44
SET/RESUME SWITCHTes

Page 87 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
UNDER.OASH FUSARELAY BOX
INDICATORLIGHT(0.84W)
lPIOSET
526712813
CRUISE CONTROT UNLT 10
11114
COMEINATONL GHI SWITCH
f7
IRED/BLK
Gircuit Diagram
*: 98 00 models withAutomatic Transmission.
J
BRAK�

Page 88 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Cruise Control
Control Unit Input Test
SRS components are located in this area. Review the SRS component locations. precautions, and procedures in the SRS
section (241 before performing repairs or se

Page 89 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Disconnest the lilP connector from the control unit.
Csvity WireTest condition
R€conn€ct tho 14P connGctor to the control unit.
Test: Desired resultPossible cause it result is not obtained
BRNAr

Page 90 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Cruise Control
1.
Main Switch Test/Replacement
Carefully pry the switch out of the instrument panel.
Disconnect the 6P connector from the switch,
Terminal side of malerermtnats
6P CONNECTOR
/
Check f

Page 94 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Cruise Control
Brake Switch Test
1. Disconnect the 4P connector from the switch,
2. Remove the brake switch.
Terminal side of maletermtnals
Check for continuity between the terminals accord-
ing to t

Page 100 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Engine Removal/lnstallation
Removal (contdl
Remove the cruise control actuator (see section 4).
Remove the mounting bolt and lock bolt, then
remove the P/S pump belt and pump.
10.
1t.
MOUNNNG BOLT8

Page 123 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
Timing Belt
Removal
Replace the timing belt at 105,000 miles (168,000 km)
according to the maintenance schedule {normal condi-
tions/severe conditions). lf the vehicle is regularly driven
in either o

Page 132 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
13. Remove the upper radiator hose, heater hose and
water bypass hose.
WATER BYPASS
UPPEBRADIATORHOSE
17
HEATERHOSE
Remove the engine wire harness connectors and
wire harness clamps from the cylinder

Page 228 of 1395

HONDA CR-V 2000 RD1-RD3 / 1.G Workshop Manual 
TANKPRESSUFESENSOF
TESTTACHOiIETERcoNr{EctoBlo CRUISE CoNTEOLUNIT+r
EVAPPURGE CONTROL SOIENOID VAIVE
sp:rosENsoF*1
COUNIERSHAFTSPEEDSENSORT
coNlRo! solENotD vALvE A*1
TO INTEFLOCK COITIFOL UNIT*!H0
Page:   1-10 11-20 21-30 next >