VIN HONDA CR-V 2002 RD4-RD7 / 2.G Owner's Guide

µµ
µ µ
You can insert or
remove the key only in this position.
To switch f rom ACCESSORY to
LOCK, you must push the key in
slightly as you turn it. If your vehicle
has an automatic transmission, the
shif t lever must also be in Park. The
anti-thef t lock will lock the steering
column when you remove the key.
If the f ront wheels are turned, the
anti-thef t lock may sometimes make
it difficult to turn the key from
LOCK to ACCESSORY. Firmly turn
the steering wheel to the lef t or to
the right as you turn the key. Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
You will hear a reminder beeper if
you leave the key LOCK (0) or
ACCESSORY (I) position and open
thedriver’sdoor.Removethekeyto
turn of f the beeper. The engine will not start if the
Immobilizer System does not
recognize the key’s coding (see page ).
This is the normal key
position when driving. All f eatures
and accessories on the vehicle are
usable. Several of the lights on the
instrument panel come on as a test
when you turn the ignition switch
f rom ACCESSORY to ON. In this position,
you can operate the audio system
and the accessory power sockets. 85
Keys and Locks
Inst rument s and Cont rols
L OCK (0)
ST A RT (III)
ON (II) A CCESSORY (I)
87
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control.
Remove the key from the
ignition switch only when
parked.

Youcanopenthehatchglassto
access the cargo area with the
tailgate closed. Make sure the
tailgate and the hatch glass are
closed and locked securely bef ore
driving.
The rear wiper will not operate with
the hatch glass open. If you open the
hatch glass while the rear wiper is
operating, the wiper will stop (see
page ).
See page for information on
cargoloading.Keepthetailgateand
the hatch glass closed at all times
while driving to avoid damaging the
tailgate and the hatch glass, and to
prevent exhaust gas f rom getting
into the interior. Seeon page .
Press and hold the hatch glass
release button on the remote
transmitter for about two seconds
(see page ). Use the master or valet key in the
tailgate lock. Turn the key
clockwise as f ar as it will go. The hatch glass will pop up slightly.
To open the hatch glass, lif t it up
f ully.
Make sure the rear wiper switch is
of f and the wiper is in its parked
position bef ore opening the hatch
glass.
To close the hatch glass, lower it,
then press on the handle until it
latches.
90 80
193
60
On EX model in the U.S., and EX andEX-L models in Canada
Keys and Locks
Inst rument s and Cont rols
Carbon
Monoxide Hazard
95
H H A
AT
TC
CH H G
GLLAA S
SSS
H
H A
AT
TC
CH H G
GLLAA S
SSS O
OPPE
EN
N P
PO
OS SIITT I
IOON N

Open the glove box by pulling the
bottom of the handle. Close it with a
f irm push. Lock or unlock the glove
box with the master key.
The glove box light comes on only
when the instrument panel lights are
on. Glove Box
Keys and Locks
Inst rument s and Cont rols96
L Loo c
ckk
An open glove box can cause
serious injury to your passenger
inacrash,evenifthe
passenger is wearing the seat
belt.
Always keep the glove box
closed while driving.

µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 13 15
Make all seat adjustments bef ore
you start driving.
To change the angle of the seat-back,
pull up on the lever on the outside of
the seat bottom. Move the seat-back
to the desired position and release
the lever. Let the seat-back latch in
the new position.
To adjust the seat forward and
backward, pull up on the bar under
the seat cushion’s f ront edge. Move
the seat to the desired position and
releasethebar.Trytomovetheseat
to make sure it is locked in position.
FrontSeatAdjustments
Seats
Inst rument s and Cont rols97

See page f or important saf etyinf ormation and a warning about how toproperly position the head restraints. 16
Your vehicle is equipped with head
restraints in all seating positions.
The head restraints help protect you
and your passengers f rom whiplash
and other injuries. They are most
ef f ective when you adjust them so
the back of the occupant’s head rests
against the center of the restraint. A
taller person should adjust the
restraint as high as possible.
The head restraints in the f ront and
rear outboard seating positions
adjust f or height. You need both
hands to adjust the restraint. Do not
attempt to adjust it while driving. To
raise it, pull upward. To lower the
restraint, push the release button
sideways and push the restraint
down.To remove a f ront head restraint or a
head restraint in one of the rear
outboard seating positions f or
cleaning or repair, pull it up as f ar as
it will go. Push the release button,
then pull the restraint out of the seat-
back.
To remove the rear center head
restraint, pull it up and out of the
seat-back.
Head Restraints
Seats
Inst rument s and Cont rols99
R RE
EL
LEE A
A S
SEE B
BUUT TT
TO
ON N R
RE
EA
A R
R C
CEEN
NT TE
ER
R

µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 13 15
Make all seat adjustments bef ore
you start driving.
The seat position and seat-back
angle of the lef t and right sides of
the rear seat can be adjusted
separately.
To adjust the rear seat f orward and
backward, pull up on the bar under
the seat cushion’s f ront edge. Move
the seat to the desired position and
releasethebar.Trytomovetheseat
to make sure it is locked in position.To change the angle of the seat-back,
pull up on the release lever on the
outside of the seat-back. Move the
seat-back to the desired position,
then release the lever. Make sure
the seat-back latches in the new
position.
Seats
Inst rument s and Cont rols
Rear Seat Adjustments
100

Reverse this procedure to return the
f ront and rear seats to the upright
position. Make sure you install the
head restraints and the seats are
locked securely bef ore driving.
When you return the seat-back to
the upright position, hold the seat-
back to keep it f rom going up too
quickly.The rear seat-back can be f olded
down to give more cargo room. Each
side f olds down separately. With only
half the seat f olded, you can still
carry a passenger in the rear seat.
You can also f old up each of the rear
seats separately to create further
cargo space (see page ).
Push the seat belt buckles into the
seat cushion.
1.
106
Seats
Inst rument s and Cont rols
Folding the Rear Seats
104
B BU
UC CKKLLEE

CONT INUED
When you are f olding the right half
of the rear seat, use the latch plate to
release the center seat belt from the
detachable anchor (see page ).
Allow the seat belt to retract into the
holder on the ceiling and store the
buckles in it.Lower the head restraint to its
lowest position.
Pull up on the release lever on the
outside of the seat-back.
Fold the seat-back forward.Reverse this procedure to return the
seat-back to the upright position.
Tug on the seat-back to make sure it
is latched. Position the seat belt in
front of the seat-back. Make sure the
seat is locked securely bef ore driving.
Do not put any heavy items on the
seat-back when it is folded. 3. 2.
4.
108
Seats
Inst rument s and Cont rols105
L LA
A T
TC
CH H P
PL
LAA T
TE
E
R
REEL
LEE A
A S
SEE L
LEE V
V E
ER
R

Tightenthestraptoremoveany
slack and make sure the seat is
secure.Reverse this procedure to return the
seat to the upright position.
Make sure the seat is securely
latched bef ore driving.
When you are not using the
f astening strap, roll up the strap and
store it properly into the slit on the
seat-back.
Make sure all rear shoulder belts are
positioned in f ront of the rear seat-
backs.
In the center seating position of the
rear seat, be sure the detachable
anchor is latched securely bef ore
using the seat belt (see page ).
Make sure all items in the cargo area
are secured. Loose items can f ly
f orward and cause injury if you have
to brake hard. See
on page .
108
193
6.
Seats
Inst rument s and Cont rols
Carrying Cargo
107

Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.
Adjust the outside mirrors with the
adjustment switch on the driver’s
door armrest:
Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side). 3.
4.
1.
2.
Inst rument s and Cont rols
Mirrors
Adjusting the Power Mirrors
114
S SE EL
LEE C
CT TO
OR R S
SWWI ITT C
CH H
T
T A
A B
B A
A
D
DJ
JUUS STTM
M E
EN
NT T S
SWWI ITT C
CH H