HONDA ELEMENT 2010 1.G Owners Manual

HONDA ELEMENT 2010 1.G Owners Manual ELEMENT 2010 1.G HONDA HONDA https://www.carmanualsonline.info/img/13/5913/w960_5913-0.png HONDA ELEMENT 2010 1.G Owners Manual
Trending: coolant temperature, mileage, audio, mirror controls, buttons, navigation, seats

Page 271 of 342

HONDA ELEMENT 2010 1.G Owners Manual 1. Make sure the engine and radiatorare cool.
2. Relieve any pressure in the cooling system by turning the radiator cap 
counterclockwise, without 
pressing down.
3. Remove the radiator cap by pushing

Page 272 of 342

HONDA ELEMENT 2010 1.G Owners Manual On Canadian models:The low washer
level indicator comes on when the 
level is low (see page 61). 
Fill the reservoir with a good-quality 
windshield washer fluid. This
increases the cleaning capabilit

Page 273 of 342

HONDA ELEMENT 2010 1.G Owners Manual 5. If the level is below the lowermark, add fluid into the dipstick 
hole to bring it to the level
between the upper and lower marks. 
Pour the fluid slowly and carefully
so you do not spill any. Clea

Page 274 of 342

HONDA ELEMENT 2010 1.G Owners Manual Put a new washer on the filler bolt, 
then reinstall the filler bolt and
tighten it securely. 
If Honda MTF is not available, you 
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Cert

Page 275 of 342

HONDA ELEMENT 2010 1.G Owners Manual Using any non-Honda brake fluid can 
cause corrosion and decrease the life
of the system. Have the brake
system flushed and refilled with 
Honda Heavy Duty Brake Fluid DOT 
3 as soon as possible. 
Bra

Page 276 of 342

HONDA ELEMENT 2010 1.G Owners Manual Power Steering Fluid
Check the level on the side of the 
reservoir when the engine is cold. 
The fluid should be between the 
UPPER LEVEL and LOWER LEVEL.
If not, add power steering fluid to the
UPPER

Page 277 of 342

HONDA ELEMENT 2010 1.G Owners Manual Headlight Aiming 
The headlights were properly aimed
when your vehicle was new. If you
regularly carry heavy items in the 
cargo area or pull a trailer, 
readjustment may be required.
Adjustments shou

Page 278 of 342

HONDA ELEMENT 2010 1.G Owners Manual 2. Remove the electrical connectorfrom the bulb by pulling the 
connector straight back.
3. Remove the rubber weather seal by pulling on the tab.
4. Unclip the end of the hold-down wire from its slot.

Page 279 of 342

HONDA ELEMENT 2010 1.G Owners Manual 4. Insert the new bulb into the hole,and turn it one-quarter turn 
clockwise to lock it in place.
5. Push the electrical connector back onto the bulb. Make sure it is on
all the way.
6. Test the light

Page 280 of 342

HONDA ELEMENT 2010 1.G Owners Manual Replacing a Side Turn Signal Bulb
1. If you are changing the bulb on thedrivers side, start the engine, turn 
the steering wheel all the way to 
the left, and turn off the engine. If
you are changing
Trending: height, fuse box, service interval reset, jacking points, low beam, child lock, CD player