374 HONDA FIT 2015 3.G Owners Manual

Visual Index
8
Quick Reference Guide
❙Door Lock/Unlock Control (P93)
❙Power Door Mirrors (P131)
❙Maintenance Under the Hood (P361)
❙Windshield Wipers (P126, 380)
❙Headlights (P121, 373)
❙Front Turn Signal/Parking Lights (P121, 374)
❙Side Marker Lights (P121, 375)
❙Tires (P384, 405)
❙Fog Lights* (P124, 375)
❙Audio Antenna (P166)
❙High-Mount Brake Light (P378)
❙Rear Wiper (P127, 382)
❙Opening/Closing the Tailgate (P107)
❙Tailgate Outer Handle/Release Button (P108)
❙License Plate Lights (P379)
❙Multi-View Rear Camera (P345)
❙Brake/Tail/Rear Side Marker Lights (P378)
❙Back-Up Lights (P377)
❙Rear Turn Signal Lights (P377)
❙How to Refuel (P348)
15 US FIT-31T5A6000.book 8 ページ ２０１４年３月６日　木曜日　午後７時５分

77
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanation
Starter System
Indicator
●Comes on for a few seconds when you
set the power mode to ON, then goes
off.
●Comes on if the starter system has a
problem.
●As a temporary measure, press and hold the
ENGINE START/STOP button for up to 15 seconds
while pressing the brake pedal and clutch pedal
(manual transmission only), and manually start the
engine. Have your vehicle checked by a dealer.
Turn Signal and
Hazard Warning
Indicators
●The turn signal indica tors blink when you
operate the turn signal lever.
●If you press the hazard warning button,
both indicators and al l turn signals blink
at the same time.
●Does not blink or blinks rapidly - A turn signal
light bulb has blown. Change the bulb immediately.
2 Replacing Light Bulbs P. 374, 377
High Beam Indicator●Comes on when the high beam
headlights are on.—
Lights On Indicator
●Comes on whenever the light switch is
on, or in AUTO* when the exterior lights
are on.
●If you remove the key from the ignition switch*, or
set the power mode* to VEHICLE OFF (LOCK) while
the exterior lights are on, a chime sounds when the
driver’s door is opened.
Fog Light Indicator*●Comes on when the fog lights are on.—
U.S.
Canada
* Not available on all models
15 US FIT-31T5A6000.book 77 ページ ２０１４年３月６日　木曜日　午後７時５分

374
uuReplacing Light Bulbs uFront Turn Signal/Parking Light Bulbs
Maintenance
5. Reinstall the hold-down wire. Hook the end
of the wire on the knob in the slot.
u You can see if the hold-down wire is in
the right place from the inspection
window.
6. Reinstall the rubber weather seal.
7. Insert the coupler into the connector of the
bulb.
Front Turn Signal/Parking Light Bulbs
When replacing, use the following bulbs.
1.Turn the socket to the left and remove it.
2. Push in the old bulb, rotate to the left until
it unlocks, and remove.
3. Insert a new bulb.
Hold-Down Wire
Inspection Window
Front Turn Signal/Parking Light: 28/8 W (Amber)
Bulb
Socket
15 US FIT-31T5A6000.book 374 ページ ２０１４年３月６日　木曜日　午後７時５分