Time HONDA ODYSSEY 2011 RB3-RB4 / 4.G Repair Manual

µ
When you push the main switch in,
the indicator comes on and the
passengers’ windows cannot be
raised or lowered. Use the main
switchwhenyouhavechildreninthe
vehicle so they do not injure
themselves by operating the
windows unintentionally. To cancel
this feature, push on the switch
again. The switch will pop out and
the indicator will go of f .
The windows and the main switch
feature will operate for up to 10
minutes after you turn off the
ignition switch. Opening either f ront
door cancels this f unction. If either f ront
window senses any obstacle while it
is closing automatically, it will
reverse direction and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.
The driver’s window auto
reverse f unction is disabled when
you continuously pull up the switch. You can open all of the windows and
the moonroof (if equipped) f rom the
outside with the remote transmitter.
Press the UNLOCK button once
to unlock the driver’s door.
Press the UNLOCK button a
second time, and hold it. The
passenger’s doors and the tailgate
unlock, and all f our windows and
moonroof start to open. To stop
the windows and moonroof ,
release the button.
1.
2.
On all models except LX
Power Windows
AUTO REVERSE
Opening the Windows and
Moonroof with the Remote
Transmitter
Instruments and Controls
193
NOTE:
10/07/17 10:00:11 31TK8600_198
2011 Odyssey

Turn on the f ront row individual map
lights by pushing the lens. Push the
lens again to turn it off. With the
light control switch in the door
activated position, the second row
and third row map lights can be
turned on by pushing the lens. Push
the lens again to turn it off.
Withanydoororthetailgateleft
open, the lights stay on about 15
minutes, then go out.
You can change the ‘‘INTERIOR
LIGHT DIMMING TIME’’ setting on
the multi-information display (see
page ).
All the individual map lights come
onandstayonaslongasthe
switch remains in the ON position. 113
When the switch is in the ON position:
On Touring models
Individual Map L ights
Interior Lights214
Front
Second and Third Row
Push PushPush
10/07/17 10:02:48 31TK8600_219
2011 Odyssey

The cargo area light has a three-
position switch. In the OFF position,
the light does not come on. In the
center position, it comes on when
you open the tailgate. In the ON
position, it stays on continuously.To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
Your vehicle also has a courtesy light
in the ignition switch. This light
comesonwhenyouopenthedriver’s
door. It f ades out in about 30
seconds af ter the door is closed.
The courtesy light in each f ront door
comes on when the door is opened,
and goes out when the door is closed.
With the tailgate open, the light
stays on about 30 minutes, then goes
out. 113
CONT INUED
On Touring models
Cargo Area Light
Courtesy Lights
Interior Lights
Instruments and Controls
215
OFFON
FRONT DOOR LIGHTIGNITION SWITCH LIGHT
10/07/17 10:02:56 31TK8600_220
2011 Odyssey

Select . The system
automatically switches to f resh air
mode and turns on the A/C.
The indicator in the A/C button
will not come on (LX and Canadian
DX models), or the A/C ON
indicator will not come on (EX,
EX-L, Touring, and Canadian SE
models), if the A/C was of f to
start with.
Select .
Set the f an and temperature
controls to maximum level.To turn the system completely off,
press the ON/OFF button.
Keep the system completely of f
f or short periods only.
To keep stale air and mustiness
f rom collecting, you should have
the f an running at all times.
To clear the windows f aster, you can
close the dashboard corner vents by
rotating the wheel next to each vent.
This sends more warm air to the
windshield def roster vents. Once the
windshield is clear, select f resh air
mode to avoid f ogging the windows.
For your saf ety, make sure you have
a clear view through all the windows
bef ore driving.
1.
2.
3.
CONT INUED
Vents, Heating, and A/C
T o Remove Exterior Frost or Ice
From the Windows
To Turn Everything Off
Features
223
10/07/17 10:04:07 31TK8600_228
2011 Odyssey

Û
Ý
Û
Ý Press the fan control button to
increase the f an speed and airf low,
and the button to decrease it. The
f an speed you adjust is shown in the
system display.
Each time you press the MODE
button, the display shows the mode
selected. Press the temperature control
button to increase the temperature
of airflow, and the button to
decrease it. The temperature you
adjust is shown in the system display.
When is selected, air f lows
f rom the rear ceiling vents.
When is selected, air f lows
f rom the rear f loor vents.
When is selected, airf low is
divided between the rear f loor vents
and rear ceiling vents.
To control the rear A/C, press the
REAR ON/OFF button. The rear
control display will come on. You can
adjust the temperature, the mode,
the f an speed and airf low of the rear
passenger compartment on the f ront
control panel.
Fan Cont rol
Mode Cont rol
T emperat ure Cont rol
Vents, Heating, and A/CREAR A/C Controls224
10/07/17 10:04:16 31TK8600_229
2011 Odyssey

Û
Ý
You can manually select various
f unctions of the climate control
system when it is in f ully automatic
mode. All other f eatures remain
automatically controlled. Making any
manual selection causes the word
AUTO in the display to go out.
Press the button to increase
the fan speed and airflow. Press the
button to decrease it.
This button turns the air
conditioningonandoff.Youwillsee
A/C ON or A/C OFF in the display.
When you turn the A/C of f , the
system cannot regulate the inside
temperature if you set the
temperature control below the
outside temperature. When the indicator in the button is
on, air f rom the vehicle’s interior is
sent through the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode. Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up. The outside air intakes f or the
climate control system are at the
base of the windshield. Keep this
area clear of leaves and other debris.
To turn the system completely off,
press the ON/OFF button.
Keep the system completely of f
f or short periods only.
To keep stale air and mustiness
f rom collecting, you should have
the f an running at all times. Semi-automatic Operation
To Turn Everything Off
Fan Control
A ir Condit ioning (A /C) But t onRecirculat ion But t on
Climate Control System228
10/07/17 10:04:50 31TK8600_233
2011 Odyssey

Û
Ý
Û
Ý To turn the rear system completely
of f , press the ON/OFF button on the
rear control panel or press and hold
the REAR LOCK button on the front
control panel f or more than 2
seconds.
Pressing the AUTO button puts the
system in automatic operation mode.
The rear system automatically
adjusts the fan speed and airflow
levels to maintain the selected
temperature of the rear passenger
compartment. You will see AUTO in
the display. Press the fan control button
to increase the f an speed and airf low.
Press the button to
decrease it. The level of the f an
speed is shown in the display.
Press the temperature control
button to increase the temperature
of airflow, and the button to
decrease it. The temperature you
adjust is shown in the system display.
Each time you press the MODE
button, the display shows the mode
selected.
When is selected, air f lows
f rom the rear f loor vents.
When is selected, airf low is
divided between the rear f loor vents
and rear ceiling vents.
When is selected, air f lows
f rom the rear ceiling vents.
Climate Control System
Mode Cont rol
A ut omat ic Operat ion
Fan Cont rol
T emperat ure Cont rol
Features
231
10/07/17 10:05:22 31TK8600_236
2011 Odyssey

µ
µ
µ
The band and f requency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
On the AM band, AM noise
reduction turns on automatically. The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM or
FM button. Adjust the volume by
turning the power/volume knob.
You can use any of f ive methods to
f ind radio stations on the selected
band: tune, skip, scan, the preset
buttons, and auto select.
On the FM band, you can also use
the f eatures provided by the radio
data system (RDS). For more
inf ormation on the RDS, see page
. The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency. Each time you press and release
either of the SKIP buttons ( or
), the radio f requency changes
in small increments.
The skip f unction searches
up and down f rom the current
f requency to f ind a station with a
strong signal. To activate it, press
either of the SKIP buttons ( or ), then release it.
239
CONT INUED
To Select a Station
To Play the Radio
SCAN
TUNE
SK IP
Playing the FM/AM Radio (LX model)
Features
237
10/07/17 10:06:10 31TK8600_242
2011 Odyssey

Each time you press the TITLE
button, the display shows you the
text, if the disc was recorded with
text data.
When you press and release the
TITLE button while a disc without
text data is playing, you will see ‘‘NO
INFO’’ on the display.
Depending on the sof tware the f iles
were made with, it may not be
possible to play some f iles, or display
some text data.
Insert a disc about half way into the
disc slot. The drive will pull the disc
intherestof thewaytoplayit.You
operate the disc player with the
same controls used f or the radio.
The number of the current track is
showninthedisplay.Whenplayinga
disc in MP3, WMA or AAC, the
numbers of the current f older and
f ile are shown. The system will
continuously play a disc until you
change modes.
You cannot load and play 3-inch
(8-cm)discsinthissystem.
For inf ormation on how to handle
and protect compact discs, see
. You can see the album, artist, and
track name in the display. If a disc is
recorded in MP3, WMA or AAC you
can see the f older and f ile name, and
the artist, album, and track tag.
CONT INUED
T ext Data Display Function
To Load a DiscPlaying a Disc (L X model)
Features
245
10/07/17 10:07:15 31TK8600_250
page 352
2011 Odyssey

µ
The display shows up to about 14
characters of selected text data (the
foldername,filename,etc.).If the
text data has more than 14
characters, you will see the first 14
characters and the indicator in
the display. Press and hold the
TITLE button until the next 14
characters are shown. You will also see some text data
under these conditions:
When a new f older, f ile, or track is
selected.
When you insert a disc, and the
system begins to play.
If any letter is not available, it is
replaced with ‘‘ . ’’ (dot) in the display.
When the disc has no text data, you
will see ‘‘NO INFO’’ on the display. When you change the audio mode
to play a disc with text data or in
MP3, WMA or AAC.
When playing a CD-DA with text
data, the album and track name are
showninthedisplay.Withadiscin
MP3, WMA or AAC the display
shows the f older and f ile name. You can use the SKIP buttons while
a disc is playing to select passages
and change tracks (files in MP3,
WMA or AAC mode).
Each time you press and
release the SKIP button, the
player skips f orward to the
beginning of the next track (f ile in
MP3, WMA or AAC mode). Press
and release the to skip
backward to the beginning of the
current track. Press it again to skip
to the beginning of the previous
track.
To move rapidly within a track, press
andholdthe or SKIP
button.
T o Change or Select T racks/Files
Playing a Disc (L X model)
SK IP
246
10/07/17 10:07:24 31TK8600_251
2011 Odyssey