buttons HONDA PASSPORT 2000 2.G Owners Manual

Powe
r Doo r Lock s
The power door lock system has lock buttons on the driver's and
front passenger's door armrests.
Either button controls all four
door locks and the tailgate.
Press the front of the lock buttonto lock all the doors, and the rear
of the button to unlock all doors. The lock knob on each door
controls only that door. Push thelock knob down to lock, and pull
it up to unlock. To lock any
passenger's door from the outside, push the lock knob down and
close the door.
Locking the driver's door fromthe outside with the key locks
all the doors and the tailgate. To
unlock only the driver's door
from the outside, turn the key and
release it. To unlock the remaining doors, turn the key a
second time within three seconds. Unlocking the passenger's door
with the key unlocks only that
door. To unlock the remaining
doors, open the door and use the
armrest lock button.
Interio r Feature s

UNLOC
K LOC
K
DRIVER' S SID E

DOO R LOC K
LOC
K
UNLOC K

PASSENGER' S

SID E DOO R

LOC K

Audi
o Syste m
AM/FM/Cassett e Stere o
Audi o Syste m

For LX and EX models

Your Honda's audio system
provides clear reception on both AM and FM bands, while the
preset buttons allow you to easily select your favorite stations.
The cassette system features Dolby B* noise reduction,
automatic sensing of chromium-
dioxide (CrC2) tape, and autoreverse for continuous play.
* Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing Corporation. "DOLBY" and the symbol
are trademarks of Dolby Laboratories
Licensing Corporation. Operatin
g th e Radi o
The ignition switch must be in
ACCESSORY or ON. Turn the system on by pressing the PWR/
VOL knob. Adjust the volume by
turning the PWR/VOL knob.
The band and frequency that the
radio was last tuned to is
displayed. To change bands, press the AM or FM button. On the FM
band, ST will be displayed if the station is broadcasting in stereo.
Stereo reproduction on AM is not

available.

You can use any of three methods
to find radio stations on the selected band: TUNE , SEEK , or
the Preset buttons.
TUN E — Use the TUNE bar to tune
the radio to a desired frequency. Press the right side ( ) to tune to
a higher frequency, or the left side ( ) to tune to a lower frequency.
The frequency numbers will start to change rapidly. Release the bar
when the display reaches the
desired frequency. To change the
frequency in small increments,
press and release the TUNE bar quickly.
SEE K — The SEEK function
searches the band for a station
with a strong signal. To activate it,
press and release the SEEK/SCAN
button. The system scans upward
from the current frequency. It stops when it finds a station with
a strong signal.
Preset — You can store the
frequencies of your favorite radio stations in the six preset buttons.
Each button will store one
frequency on the AM band, and two on the FM band (FM1 and
FM2).
Comfor t an d Convenienc e Feature s

Operatin
g th e Cassett e Playe r
The ignition switch must be in
ACCESSORY or ON. Make sure the tape opening on the cassette is
facing to the right, then insert the
cassette most of the way into the slot. The system will pull it in the
rest of the way, and begin to play.
The tape direction indicator will light to show you which side of the cassette is playing. The
indicates the side you inserted
facing upward is now playing. If
you want to play the other side, press the (preset 2) button.
If the cassette was recorded using
Dolby noise reduction, turn it on
by pressing the (preset 5)
button. You will see in the
display.
You can switch between the
cassette and the radio by pressing the FM/AM and TAPE buttons.
When you press the FM/AM
button with a cassette playing, the
radio begins to play and the cassette stops but does not eject.
To begin playing the cassette at the same point, press the TAPE

button.

When the system reaches the end
of the tape, it will automatically
reverse direction and play the
other side. If you want to remove
the cassette from the drive, press
the EJECT button.
When you turn off the ignitionswitch, the system stops the tape
but does not eject the cassette. It
will begin to play when you turn
the ignition switch back on. To
eject the tape, even with the ignition switch off, press the
EJECT button.
Tap
e Searc h Function s

With a cassette playing, you can use the FF, REW, or APS function
to find a desired program.
FF/RE W — Fast Forward and
Rewind move the tape rapidly. Press and release the button
(preset 1) to rewind, or the
button (preset 3) to fast forward.
You will see REW or FF in the display. Press the button to
return to PLAY mode. If the system reaches the end of the tape
while in fast forward or rewind, it
automatically stops that function,
reverses direction, and begins to
play.

Comfor t an d Convenienc e Feature s

AP
S — The Automatic Program
Search function allows you to find
the beginning of a song or passage. Use the (preset 4) or
(preset 6) buttons to activate

APS.

For example, the first song on the cassette is playing, and you wish
to listen to the third song. Press
twice; you will see FF and 2

displayed. Th
e system will fast
forward the tape to the beginning
of the third song, then return to
PLAY mode.
To return to the beginning of the current song or passage, press
once. To return to the beginning
of the previous song, press
twice.
If the system reaches the end of
the tape before finding theselected song or passage, it
reverses direction and returns to

PLAY mode.
To cancel APS, press the

button.

The APS function uses silent
periods on the tape to find the end
of a song or passage. This feature
may not work to your satisfaction
Comfor t an d Convenienc e Feature s

TAP
E DIRECTIO N BUTTO N
CASSETT E SLO T REWIN
D BUTTO N
FAST FORWAR D
BUTTO N
AUTOMATI C PROGRA M
SEARC H BUTTO N
EJEC
T BUTTO N
AUTOMATIC PROGRA M
SEARC H BUTTO N
TAP E BUTTO N
DOLBY BUTTO N

slot. The drive will pull it in the
rest of the way, and begin playing the first track. The light next to
the button will stay on as a
reminder that a CD is loaded in
that position.
Repeat this procedure to load CDsin the remaining positions in the
changer. The positions that
contain CDs will display a green
light next to their buttons. The CD
position that is currently loaded and ready to play will display an
orange light.
Playing CDs Press the CD button on the frontof the radio. The CD that is
currently loaded will begin
playing. The disc and track
numbers will be shown in the
radio display. When the system
reaches the end of that CD, it will load and play the next CD. To select a different disc, push the
appropriate button (1-6) on the
front of the CD changer. The light next to the button will flash as the
current CD is stored and the new
CD is loaded. The light will thenturn orange, and the CD will
begin playing from the first track.
You can also press the
TUNE/DISC button on the front of
the radio:
to select the
previous disc, or to select the
next disc.
To change tracks, press and
release either the button
(preset 4), or the button
(preset 6). Each time you press
the system will advance one
track. Pressing once will
return the system to the beginning
of the current track. Press it again
to select the previous track.To move rapidly within a track, press and hold the button
(preset 3) to move forward, or the
button (preset 1) to move
backward. Release the button
when the system reaches the point you want.
You can switch to the radio or
cassette player by pressing the
FM/AM or TAPE buttons on the
front of the radio. To switch back
to the CD changer, press the CD
button. The CD will begin playing
where it left off.
To eject a CD, select it with the
button on the front of the CD
changer (the light turns to orange), then press the EJECT

button.

Protectin g Compac t Disc s
For information on how to handle and protect compact discs, see
page 142.
Comfor t an d Convenienc e Feature s

AM/FM/Cassette/C
D
Change r Stere o
Audi o Syste m
For EX-L model
Your Honda's audio system
provides clear reception on both AM and FM bands, while the
preset buttons allow you to easily select your favorite stations.
The CD changer holds up to six
discs, providing several hours of
continuous entertainment.
The cassette system features
Dolby B* noise reduction, automatic sensing of chromium-
dioxide (CrO 2) tape, and
autoreverse for continuous play.
* Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. "DOLBY" and the symbol
are trademarks of Dolby Laboratories
Licensing Corporation. Operatin
g th e Radi o
The ignition switch must be in ACCESSORY or ON. Turn the
system on by pressing the
PWR/VOL knob. Adjust the
volume by turning the PWR/VOL

knob.

The band and frequency that the
radio was last tuned to is
displayed. To change bands, press the AM or FM button. Press the
FM button again to switch between FM1 and FM2. On the
FM band, ST will be displayed if the station is broadcasting in
stereo. Stereo reproduction on
AM is not available.
You can use any of four methods
to find radio stations on the
selected band: TUNE , SEEK ,
SCAN , or the Prese t buttons.
TUN E — Use the TUNE bar to
tune the radio to a desired frequency. Press the right side to tune to a higher frequency,
or the left side to tune to a
lower frequency. The frequency
numbers will start to change
rapidly. Release the bar when the display reaches the desired
frequency. To change the frequency in small increments,
press and release the TUNE bar quickly.
SEE K — The SEEK function
searches the band for a station
with a strong signal. To activate it,
press and release the SEEK/SCAN button. The systemscans up the band from the current
frequency. It stops when it finds a station with a strong signal.
SCA N — The SCAN function
samples all the stations with
strong signals on the selected
band. To activate it, press and
hold the SEEK/SCAN button until
Comfor t an d Convenienc e Feature s

you hear a beep, then release it.
SCAN shows in the display. The
system scans up the band for a
station with a strong signal. When
it finds one, it stops and plays that
station for approximately five
seconds. If you do nothing, the
system scans for the next strong
station and plays that for five
seconds. When it finds a station
that you want to continue
listening to, press the SEEK/SCAN button again.
Prese t — You can store the
frequencies of your favorite radio stations in the six preset buttons.
Each button will store one frequency on the AM band, and
two on the FM band (FM1 and
FM2).

To store a frequency:

1. Select the desired band; AM,
FM1,or FM2.

Comfor t an d Convenienc e Feature s
PWR/VO
L

KNO B F
M
BUTTO NA
M
BUTTO N AUDI
O
CONTRO L
KNO B
SCAN/SEE K
BUTTO N
PRESE
T BUTTON S
TUN
E BA R