light HONDA PRELUDE 2000 (in English) User Guide

Indicato
r Light s

Sea t Bel t Reminde r Ligh t

This indicator lights when you turn the ignition switch ON (II). It is a
reminder to you and your passengersto protect yourselves by fastening
the seat belts. A beeper also sounds
if you have not fastened your seat

belt.

If you do not fasten your seat belt,
the beeper will stop after a few seconds but the light stays on until
you do.
Both the ligh
t and the beeper
stay off if you fasten your seat belt
before turning on the ignition.

* The U.S. Type SH instrument panel is shown. Differences for the Canadian
model are noted in the text.
Instrument s an d Control s MALFUNCTIO
N
INDICATO R LAM P SUPPLEMENTA
L
RESTRAIN T
SYSTE M
INDICATO R PARKIN
G BRAK E AN D
BRAK E SYSTE M INDICATOR *
ACTIV E TORQU E TRANSFE R
SYSTE M INDICATO R
ANTI-LOC K BRAK E
SYSTE M INDICATOR *
TRUNK-OPE
N
INDICATO R
DOOR-OPE N
INDICATO R
IMMOBILIZER
SYSTE M INDICATO R
LO W OI L PRESSUR E
INDICATO R
CHARGIN G SYSTE M
INDICATO R HIG
H BEA M
INDICATO R
SEA
T BEL T
REMINDE R LIGH T LO
W FUE L
INDICATO R
CRUIS E CONTRO L
INDICATO R

Indicator Light s
Supplementa l Restrain t
System Indicato r
This indicator lights when you turn
the ignition switch ON (II). If it
comes on at any other time, it
indicates a problem in thesupplemental restraint system. For
complete information, see page 47.
Immobilize r Syste m
Indicato r
This indicator comes on for a few seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded ignition key. If it is not a properly-
coded key, the indicator will blinkand the engine will not start (see
page 71).
This indicator also blinks several times when you turn the ignitionswitch from ON (II) to ACCESSORY (I) or LOCK (0). Chargin
g Syste m
Indicato r
If this light comes on when the
engine is running, the battery is not
being charged. For complete
information, see page 249.
Lo w Oi l Pressur e
Indicato r
The engine can be severely damaged
if this light flashes or stays on when
the engine is running. For complete
information, see page 248.
Malfunctio n Indicato r
Lam p
See page 250.
Cruis e Contro l Indicato r
This lights when you set the cruise
control. See page 67 for information
on operating the cruise control.
Parkin g Brak e
an d Brak e
System
Indicato r
This light has two functions:
1. It lights as a reminder that you have not released the parking
brake. Driving with the parking
brake applied can damage thebrakes and tires.
2. If it remains lit after you release the parking brake while the engine
is running, or comes on while driving, it can indicate a problemin the brake system. For complete
information, see page 251.
Instrument s an d Control s
SRS
CRUISE
CONTRO L
U.S. Canad a
BRAKE

Indicato
r Lights

U.S .


Anti-lock Brak e
Syste m (ABS )
Indicato r
This light normally comes on for a few seconds when you turn the
ignition switch ON (II), and when
the ignition switch is turned toSTART (III). If this light comes on at
any other time, there is a problem in
the ABS. If this happens, take the
car to your dealer to have it checked.
With the light on, your car still has normal braking ability but no anti-
lock. For complete information, see

page 156.
Activ
e Torqu e Transfe r
Syste m (ATTS ) Indicato r
Type SH only

This indicator normally comes o
n for
a few seconds when you turn the
ignition switch ON (II).
If it comes on at any other time,
there is a problem in the Active
Torque Transfer System (ATTS). If this happens, take the car to yourdealer to have it checked. With the
indicator on, your car will corner
normally, but you will not have active
torque transfer. Tur
n Signa l an d
Hazar d Warnin g
Indicator s
The left or right turn signal light blinks when you signal a lane changeor turn. If the light does not blink or
blinks rapidly, it usually means one of the turn signal bulbs is burned out (see page 218). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
When you turn on the Hazard
Warning switch, both turn signal lights blink. All turn signals on the outside of the car should flash.
Instrument s an d Control s

Canad
a

AB S

ATTS

Indicato
r Light s

Trunk-ope n Indicato r
This light comes on if the trunk lid is not closed tightly.
Door-ope n Indicato r
This light comes on if either door is not closed tightly.
High Bea m Indicato r
This light comes on with the high beam headlights. See page 62 for
information on the headlight

controls.

On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights (DRL) are on (see page 62). Lo
w Fue l Indicato r
This indicator is located in the fuel gauge. It comes on as a reminder
that you must refuel soon. "Daytim
e Runnin g
Lights " Indicato r

Canadian models only

This indicator lights when you turn the ignition switch to ON (II) withthe headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release the parking brake. If it comes on atany other time, it means there is a
problem with the DRL. There mayalso be a problem with the high
beam headlights.
Instrument s an d Control s

LO
W FUE L INDICATO R
DRL

Gauges

Fue l Gaug e
This shows how much fuel you have. It is most accurate when the car is on
level ground. It may show slightly more or less than the actual amount
when you are driving on curvy or hilly roads. The gauge stays at the same fuel
level reading after you turn off theignition. When you add fuel, the
gauge slowly changes to the new
reading after you turn the ignition switch back ON (II). Temperatur
e Gaug e
This shows the temperature of the engine's coolant. During normal
operation, the pointer should rise
from the bottom white mark to about the middle of the gauge. In severedriving conditions, such as very hot
weather or a long period of uphill driving, the pointer may rise to near
the upper white mark. If it reaches
the red (Hot) mark, pull safely to the side of the road. Turn to page 246 for
instructions and precautions on
checking the engine's cooling
system.

Instrument s an d Control s

FUE
L GAUG E
TRI
P METE R
SPEEDOMETE
R
TACHOMETE R
TEMPERATUR E
GAUG E MAINTENANC
E
REQUIRE D INDICATO R
ODOMETE
R TRIP METE R
RESE T BUTTO N

Control
s Nea r th e Steerin g Whee l

The two levers on the steering column contain controls for driving
features you use most often. The left
lever controls the turn signals,
headlights, and high beams. The right lever controls the windshield
washers and wipers.
The controls under the left air vent are for the moonroof, cruise control
and instrument panel brightness.
The switches for the hazard warning lights and rear window defogger are
to the right of the steering column.
The tilt adjustment lever on the underside of the steering column
allows you to tilt the steering wheel.
Instruments an d Control s
WINDSHIEL
D
WIPERS/WASHER S
(P . 64 )

CRUIS
E

CONTRO L

(P .
67 ) INSTRUMEN
T PANE L

BRIGHTNES S

(P . 63 )
HAZAR
D WARNIN G

LIGHT S

(P . 65 )
REAR WINDO W

DEFOGGER
(P . 65 )

HOR
N
BUTTON S

TILT

ADJUSTMEN
T
(P . 66 )

HEADLIGHTS
/

TUR N SIGNAL S
(P . 62 )
MOONROO
F
(P . 87 )

Controls
Nea r th e Steerin g Whee l
Headlight s
The rotating switch on the left lever controls the lights. Turning this switch to the position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights. Turning the switch to the
position turns on the headlights. If you leave the lights on with the
ignition switch in ACCESSORY (I)
or LOCK (0), you will hear a
reminder chime when you open the driver's door.

To change between low beams and
high beams, pull the turn signal leveruntil you hear a click, then let go.
The blue high beam indicator will
light (see page 57).
To flash the high beams, pull the
turn signal lever back lightly, thenrelease it. The high beams will comeon and go off.
The high beams will stay on for as long as you hold the lever back, no
matter what position the headlightswitch is in.
Daytim e Runnin g Light s
(Canadia n Models )
With the headlight switch off, the high beam headlights come on withreduced brightness when you turn
the ignition switch to ON (II) and release the parking brake. They
remain on until you turn the ignitionoff, even if you set the parking brake.
The headlights revert to normal operation when you turn them on
with the switch.

Instrument s an d Control s

Control
s Nea r th e Steerin g Whee l

Instrument Panel Brightness

The dial on the dashboard to the left of the instrument panel controls the
brightness of the instrument panel
lights. Turn the dial to adjust the
brightness. Tur
n Signal s
Signal a turn or lane change with this
lever. Push down on the lever to signal a left turn, and up to signal a
right turn. If you push it up or down all the way, the turn signal continues
to blink even when you release the
lever. It shuts off automatically as
you complete the turn. To signal a lane change, push lightly
on the turn signal lever in the properdirection and hold it. The lever will
return to the center position as soon
as you release it.
Instrument s an d Control s
TUR
N SIGNA L LEVER

Controls
Nea r th e Steering Whee l

Windshiel d Washer s
To clea
n the
windshield, pull back on
the wiper control lever. The washers spray until you release the lever.
The wipers run at low speed while
you're pulling the lever, then complete one more sweep of the
windshield after you release it. Hazar
d Warnin g
Push the red button to the left of the
clock to turn on the hazard warning
lights (four-way flashers). This causes all four outside turn signals
and both indicators in the instrument
panel to flash. Use the hazard
warning lights if you need to park in a dangerous area near heavy traffic,
or if your car is disabled. Rea
r Windo w Defogger
The rear window defogger will clear fog, frost, and thin ice from the
window. Push the defogger button to turn it on and off. The light in the
button lights to show the defogger ison. If you do not turn it off, thedefogger will shut itself off after
about 25 minutes. It also shuts off
when you turn off the ignition. You have to turn it on again when you
restart the car.
Instrument s an d Control s
CONTINUED

Controls Nea r th e Steerin g Wheel
Make sure the rear window is clear
and you have good visibility before starting to drive.
The defogger and antenna wires on the inside of the rear window can be accidentally damaged. When
cleaning the glass, always wipe side
to side. Steerin
g Whee l Adjustmen t
See page 17 for important safety
information about how to properly
position the steering wheel.
Make any steering wheel adjustment
before you start driving.
To adjust the steering wheel upward or downward:
1. Push the lever under the steering column all the way down. 2. Move the steering wheel to the
desired position, making sure the
wheel points toward your chest,
not toward your face. Make sure
you can see the instrument panel
gauges and the indicator lights.
3. Push the lever up to lock the steering wheel in that position.
4. Make sure you have securely locked the steering wheel in place
by trying to move it up and down.
Instrument s an d Control s
Adjusting the steering wheel
position while driving may
cause you to lose control of the
car and be seriously injured in a
crash.
Adjust the steering wheel only
when the car is stopped.