height HUMMER H2 2004 User Guide

Tire Size
The following examples show the different parts of a
tire size.
(A) Passenger (P-Metric) Tire:The United States
version of a metric tire sizing system. The letter “P” as
the rst character in the tire size means a passenger
vehicle tire engineered to standards set by the U.S. Tire
and Rim Association.
(B) Tire Width:The three-digit number indicates the
tire section width in millimeters from sidewall to sidewall.(C) Aspect Ratio:A two-digit number that indicates the
tire height-to-width measurements. For example, if
the tire size aspect ratio is “75,” as shown in item “C” of
the illustration, it would mean that the tire’s sidewall
is 75% as high as it is wide.
(D) Construction Code:A letter code is used to
indicate the type of ply construction in the tire. The letter
“R” means radial ply construction; the letter “D” means
diagonal or bias ply construction; and the letter “B”
means belted-bias ply construction.
(E) Rim Diameter:Diameter of the wheel in inches.
(F) Service Description:The service description
indicates the load range and speed rating of a tire. The
load index can range from 1 to 279. Speed ratings
range from “A” to “Z”. Passenger (P-Metric) Tire
5-64

(A) Light Truck (LT-Metric) Tire:The United States
version of a metric tire sizing system. The letter “LT” as
the rst two characters in the tire size means a light
truck tire engineered to standards set by the U. S. Tire
and Rim Association.
(B) Tire Width:The three-digit number indicates the
tire section width in millimeters from sidewall to sidewall.
(C) Aspect Ratio:A two-digit number that indicates
the tire height-to-width measurements. For example, if
the tire size aspect ratio is “75,” as shown in item “C” of
the illustration, it would mean that the tire’s sidewall is
75% as high as it is wide.(D) Construction Code:A letter code is used to
indicate the type of ply construction in the tire. The letter
“R” means radial ply construction; the letter “D” means
diagonal or bias ply construction; and the letter “B”
means belted-bias ply construction.
(E) Rim Diameter:Diameter of the wheel in inches.
(F) Service Description:The service description
indicates the load range and speed rating of a tire. The
load index can range from 1 to 279. Speed ratings
range from “A” to “Z”. The light truck tire size example
above shows dual or single tire congurations.Tire Terminology and Denitions
Air Pressure:The amount of air inside the tire pressing
outward on each square inch of the tire. Air pressure
is expressed in pounds per square inch (psi) or
kilopascal (kPa).
Accessory Weight:This means the combined weight
of optional accessories. Some examples of optional
accessories are, automatic transmission, power steering,
power brakes, power windows, power seats, and air
conditioning. Light Truck (LT-Metric) Tire
5-65

Aspect Ratio:The relationship of a tire’s height to its
width.
Belt:A rubber coated layer of cords that is located
between the plies and the tread. Cords may be made
from steel or other reinforcing materials.
Bead:The tire bead contains steel wires wrapped by
steel cords that hold the tire onto the rim.
Bias Ply Tire:A pneumatic tire in which the plies are
laid at alternate angles less than 90 degrees to the
centerline of the tread.
Cold Ination Pressure:The amount of air pressure in
a tire, measured in pounds per square inch (psi) or
kilopascals (kPa) before a tire has built up heat
from driving. SeeInation - Tire Pressure on page 5-68.
Curb Weight:This means the weight of a motor
vehicle with standard and optional equipment including
the maximum capacity of fuel, oil and coolant, but
without passengers and cargo.
DOT Markings:A code molded into the sidewall of a
tire signifying that the tire is in compliance with the U.S.
Department of Transportation motor vehicle safety
standards. The DOT code includes the Tire Identication
Number (TIN), an alphanumeric designator which can
also identify the tire manufacturer, production plant,
brand and date of production.GVWR:Gross Vehicle Weight Rating, seeLoading
Your Vehicle on page 4-67.
GAWR FRT:Gross Axle Weight Rating for the front
axle, seeLoading Your Vehicle on page 4-67.
GAWR RR:Gross Axle Weight Rating for the rear axle,
seeLoading Your Vehicle on page 4-67.
Intended Outboard Sidewall:The side of an
asymmetrical tire, that must always face outward when
mounted on a vehicle.
Kilopascal (kPa):The metric unit for air pressure.
There are 6.9 kPa’s to one psi.
Light Truck (LT-Metric) Tire:A tire used on light duty
trucks and some multipurpose passenger vehicles.
Load Index:An assigned number ranging from 1 to 279
that corresponds to the load carrying capacity of a tire.
Maximum Ination Pressure:The maximum air
pressure to which a cold tire may be inated. The
maximum air pressure is molded onto the sidewall.
Maximum Load Rating:The load rating for a tire at the
maximum permissible ination pressure for that tire.
5-66

Wheel Replacement
Replace any wheel that is bent, cracked or badly rusted
or corroded. If wheel nuts keep coming loose, the
wheel, wheel bolts and wheel nuts should be replaced.
If the wheel leaks air, replace it (except some
aluminum wheels, which can sometimes be repaired).
See your dealer if any of these conditions exist.
Your dealer will know the kind of wheel you need.
Each new wheel should have the same load-carrying
capacity, diameter, width, offset and be mounted
the same way as the one it replaces.
If you need to replace any of your wheels, wheel bolts
or wheel nuts, replace them only with new GM
original equipment parts. This way, you will be sure to
have the right wheel, wheel bolts and wheel nuts
for your vehicle.{CAUTION:
Using the wrong replacement wheels, wheel
bolts or wheel nuts on your vehicle can be
dangerous. It could affect the braking and
handling of your vehicle, make your tires lose
air and make you lose control. You could have
a collision in which you or others could be
injured. Always use the correct wheel, wheel
bolts and wheel nuts for replacement.
Notice:The wrong wheel can also cause problems
with bearing life, brake cooling, speedometer or
odometer calibration, headlamp aim, bumper height,
vehicle ground clearance and tire or tire chain
clearance to the body and chassis.
SeeChanging a Flat Tire on page 5-79for more
information.
5-74

The overall height, width, and underbody clearances of
the HUMMER H2 are similar to current General Motors’
full-size light duty trucks. This means a HUMMER H2
should t in a standard car wash. But, if your vehicle has
added accessories like roof-mounted lamps, roof basket,
etc., it might not t properly in a standard car wash.
Notice:Certain add-on accessories can change the
dimensions of your vehicle. If you’ve added items
to the outside of your vehicle, it might not t
properly in a standard car wash. Your vehicle and
the car wash could be damaged. To help prevent
damage, know how accessories have changed the
dimensions of your vehicle and check with the
car wash manager before entering a car wash.
Notice:If you drive your vehicle through an
automatic car wash that does not have enough
clearance for any roof-mounted accessories (such as
off-road lamps or a roof basket) on your vehicle, you
can damage your vehicle. To avoid damaging your
vehicle in a car wash, remove any roof-mounted
accessories if you can, and do not use an automatic
car wash while roof-mounted accessories are on
your vehicle. SeeCleaning the Outside of Your
Vehicle on page 5-95for more information.
Also, seeLuggage Carrier on page 2-46and “Off-Road
Lamps” underExterior Lamps on page 3-13.Cleaning Exterior Lamps/Lenses
Use only lukewarm or cold water, a soft cloth and a car
washing soap to clean exterior lamps and lenses.
Follow instructions under “Washing Your Vehicle.”
Finish Care
Occasional waxing or mild polishing of your vehicle by
hand may be necessary to remove residue from the
paint nish. You can get GM-approved cleaning products
from your dealer. SeeVehicle Care/Appearance
Materials on page 5-100.
If your vehicle has a “basecoat/clearcoat” paint nish. The
clearcoat gives more depth and gloss to the colored
basecoat. Always use waxes and polishes that are
non-abrasive and made for a basecoat/clearcoat paint
nish.
Notice:Machine compounding or aggressive
polishing on a basecoat/clearcoat paint nish may
damage it. Use only non-abrasive waxes and
polishes that are made for a basecoat/clearcoat
paint nish on your vehicle.
5-96

Replacement Bulbs.........................................5-58
Replacing Brake System Parts..........................5-42
Replacing Restraint System Parts After a Crash.....1-74
Replacing the Seat.........................................1-15
Reporting Safety Defects
Canadian Government..................................7-10
General Motors...........................................7-10
United States Government............................7-10
Reprogramming a Single HomeLink
®Button.......2-45
Resetting Defaults...........................................2-45
Restraint Systems
Checking....................................................1-73
Replacing Parts...........................................1-74
Resynchronization............................................. 2-6
Retained Accessory Power (RAP)......................2-19
Returning the Seat to an Upright Position...........1-12
Returning the Seats to an Upright Position........... 1-9
Ride Height, Selectable Extended Rear Ride......4-73
Right Front Passenger Position, Safety Belts......1-30
RIGHT REAR DOOR AJAR..............................3-61
Roadside Assistance Program............................ 7-5
Rocking Your Vehicle To Get It Out...................4-56
Routing, Engine Drive Belt...............................6-15
Running Your Engine While You Are Parked.......2-33
S
Safety Belt
Reminder Light............................................3-28
Safety Belts
Care of......................................................5-95
Driver Position............................................1-22
How to Wear Safety Belts Properly................1-21
Questions and Answers About Safety Belts.....1-21
Rear Safety Belt Comfort Guides for Children
and Small Adults......................................1-34
Rear Seat Passengers.................................1-30
Right Front Passenger Position......................1-30
Safety Belt Extender....................................1-37
Safety Belt Use During Pregnancy.................1-29
Safety Belts Are for Everyone.......................1-16
Safety Chains.................................................4-80
Safety Warnings and Symbols.............................. iii
Scanning the Terrain.......................................4-29
Scheduled Maintenance..................................... 6-4
Seats
60/40 Split Bench Seat.................................. 1-8
Head Restraints............................................ 1-6
Heated Seats............................................... 1-4
Heated Seats, Rear....................................... 1-8
12

Seats (cont.)
Memory.....................................................2-51
Power Lumbar.............................................. 1-3
Power Seats................................................. 1-2
Rear Seat Operation...................................... 1-7
Reclining Seatbacks...................................... 1-5
Third Row Seat...........................................1-10
Securing a Child Restraint
Designed for the LATCH System...................1-52
Rear Seat Position......................................1-53
Right Front Seat Position..............................1-55
Security Light.................................................3-42
Security While You Travel.................................. 7-5
Select Button.................................................3-55
Selectable Extended Rear Ride Height...............4-73
Service........................................................... 5-3
Adding Equipment to the Outside of Your
Vehicle..................................................... 5-5
Doing Your Own Work................................... 5-4
Engine Soon Light.......................................3-38
Publications Ordering Information...................7-11
SERVICE 4WD...............................................3-58
SERVICE AIR BAG.........................................3-58
SERVICE AIR SUSPENSION...........................3-58
SERVICE BRAKE SYSTEM.............................3-58
Service Bulletins.............................................7-11
Service Manuals.............................................7-11
Servicing Your Air Bag-Equipped Vehicle............1-72
Setting Preset PTYs........................................3-79Setting Preset PTYs (RDS Only).......................3-67
Setting Preset Stations............................3-64, 3-76
Setting the Time.............................................3-62
Setting the Tone (Bass/Treble)..................3-65, 3-76
Sheet Metal Damage.......................................5-98
Shifting Into Park (P).......................................2-30
Shifting Out of Park (P)...................................2-32
Skidding........................................................4-16
Some Other Rainy Weather Tips.......................4-45
Spare Tire.....................................................5-92
Specications, Capacities...............................5-111
Speedometer..................................................3-28
Split Bench Seat (60/40).................................... 1-8
Stalling on an Incline.......................................4-38
Starting Your Engine.......................................2-20
Steering........................................................4-12
Steering in Emergencies..................................4-13
Steering Tips..................................................4-12
Steering Wheel Controls, Audio.........................3-89
Steering Wheel, Tilt Wheel................................. 3-5
Storage Areas
Center Console Storage Area........................2-46
Center Overhead Console.............................2-46
Glove Box..................................................2-45
Luggage Carrier..........................................2-46
Rear Seat Armrest.......................................2-49
Storing a Flat or Spare Tire and Tools...............5-90
Stuck in Sand, Mud, Ice or Snow......................4-56
Sun Visors.....................................................2-16
13