spare wheel HUMMER H2 2005 User Guide

3. Place the end of the
spanner wrench on the
nut and then turn
the wheel wrench
counterclockwise to
loosen the nut
holding the tire to
the carrier.
4. Pull off the tire retainer plate and set it aside.
Remove the spare tire from the wheel carrier.
5. Put the spare tire near the at tire.The tools you’ll be using to nish changing a at tire are
the following:
A. Jack
B. Wheel Blocks
C. Jack HandleD. Jack Handle
Extension
E. Wheel Wrench
F. Ratchet
Before proceeding, be sure to set the wheel blocks at
the appropriate tires as shown previously.
5-76

Removing the
Spare-Tire-Carrier-Mounted Spare Tire
The outside-mounted spare tire is attached to the
tire carrier. To remove the spare tire, do the following:
1. Open the tire carrier. SeeTailgate (SUT) on
page 2-16for tire carrier operation.
2. Unscrew the wingnut on the back of the tire carrier.3. Pull off the license plate holder from the spare tire.
4. Slide the ratchet onto the wheel wrench with the
DOWN mark facing you.
5-77

5. Turn the ratchet counterclockwise to loosen the
wheel nuts.
6. Remove the three wheel nuts holding the spare tire
onto the tire carrier.
7. Pull off and gently lower the spare tire to the
ground. Set it next to the at tire.The tools you’ll be using to nish changing a at tire
include the following:
A. Jack
B. Wheel Blocks
C. Jack HandleD. Jack Handle
Extension
E. Wheel Wrench
F. Ratchet
Before proceeding, be sure to set the wheel blocks at
the appropriate tires as shown previously.
5-78

Removing the Flat Tire and
Installing the Spare Tire
1. To remove the center
cap, place the at end
of the wheel wrench
in the slot on the wheel
and gently pry the
center cap out.
2. Slide the ratchet onto the wheel wrench with the
DOWN mark facing you.
3. Turn the ratchet counterclockwise to loosen the
wheel nuts. Don’t remove them yet.
You will now need to jack the vehicle up using the
instructions following.
5-79

7. Remove all the wheel
nuts and take off the
at tire.
{CAUTION:
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after a time. The wheel could
come off and cause an accident. When you
change a wheel, remove any rust or dirt from
the places where the wheel attaches to the
vehicle. In an emergency, you can use a cloth
or a paper towel to do this; but be sure to use
a scraper or wire brush later, if you need to, to
get all the rust or dirt off.8. Remove any rust or dirt
from the wheel bolts,
mounting surfaces
and spare wheel.
{CAUTION:
Never use oil or grease on studs or nuts. If
you do, the nuts might come loose. Your wheel
could fall off, causing a serious accident.
5-83

9. After mounting the
spare, put the wheel
nuts back on with
the rounded end of
the nuts toward
the wheel.
10. Tighten each wheel nut by hand. Then use the
ratchet/wheel wrench to tighten the nuts, with
the UP mark facing you, clockwise until the wheel is
held against the hub.
You will not be tightening the nuts fully yet.
5-84

12. Tighten the nuts rmly
in a crisscross
sequence as shown by
turning the ratchet
clockwise, with the UP
mark facing you.
13. When you install the wheel and tire, you must
also reinstall the center cap. Place the cap on
the wheel and tap it into place until it sits ush
with the wheel.
Storing a Flat or Spare Tire
and Tools
Inside-Mounted Tire
Use the art and text following to help you store the
spare or at tire back into its proper spot when you
are done.
Store the at or spare tire back inside the vehicle on the
spare tire mount.A. Spare or Flat Tire
B. Receiver Extension
(If Equipped)C. Tire Retainer Plate
D. Nut
E. Wheel Blocks
5-86

To store the at or spare tire on the spare tire mount,
do the following:
1. Slide the at or spare tire onto the tire carrier.
2. Slide the tire retainer plate into the wheel opening.
Be sure that the stud attached to the tire carrier
passes through the hole in the tire retainer plate.
3. Tighten the nut by hand until the tire retainer plate
is snug against the tire.
4. Use the wheel wrench
and spanner to tighten
the nut rmly. Try to
move the tire back and
forth slightly to be
sure it is secure.
5. Reattach the wheel blocks to the tire retainer plate
and tighten the wing nut.
6. Reinstall the tire cover onto the spare or at tire.Spare-Tire-Carrier-Mounted Tire
To store the at or spare tire on the tire carrier, do
the following:
1. Close the tire carrier. SeeTailgate (SUT) on
page 2-16for tire carrier operation.
2. Place the at or spare tire onto the tire carrier with
the outside of the wheel facing you.
3. Reinstall the three nuts holding spare or at tire to
the tire carrier. Tighten the nuts by hand.
4. Use the ratchet and wheel wrench to tighten the
nuts rmly. Try to move the tire back and forth
slightly to be sure it is secure.
5-87

8. Replace the jack cover. Be sure the tabs on the
back of the jack cover t into the slots on the
cargo box before closing the jack cover.
9. Close the spare tire carrier to ensure it securely
latches. SeeTailgate (SUT) on page 2-16for tire
carrier operation.
Spare Tire
Your vehicle, when new, had a fully inated spare tire.
A spare tire may lose air over time, so check its
ination pressure regularly. SeeInation - Tire Pressure
on page 5-60andLoading Your Vehicle on page 4-58
for information regarding proper tire ination and loading
your vehicle. For instruction on how to remove, install
or store a spare tire, seeChanging a Flat Tire on
page 5-70andRemoving the Flat Tire and Installing the
Spare Tire on page 5-79.
After installing the spare tire on your vehicle, you should
stop as soon as possible and make sure the spare is
correctly inated. Have the damaged or at road
tire repaired or replaced as soon as you can and
installed back onto your vehicle. This way, a spare tire
will be available in case you need it again.
Your vehicle may have a different size spare tire than
the road tires—those originally installed on your vehicle.
This spare tires was developed for use on your
vehicle, so it’s all right to drive on it.
If your vehicle has a spare tire that does not match your
vehicle’s original road tires and wheels in size and
type, do not include the spare in the tire rotation.
5-91

Seats
60/40 Split Bench Seat.................................. 1-7
Head Restraints............................................ 1-6
Heated Seats............................................... 1-4
Heated Seats, Rear....................................... 1-7
Memory.....................................................2-63
Power Lumbar.............................................. 1-3
Power Seats................................................. 1-2
Reclining Seatbacks...................................... 1-5
Third Row Seat...........................................1-10
Securing a Child Restraint
Designed for the LATCH System...................1-51
Rear Seat Position......................................1-52
Right Front Seat Position..............................1-54
Security Light.................................................3-41
Selectable Extended Rear Ride Height...............4-65
Service........................................................... 5-3
Adding Equipment to the Outside of Your
Vehicle..................................................... 5-5
Doing Your Own Work................................... 5-4
Engine Soon Light.......................................3-37
Publications Ordering Information...................7-11
Servicing Your Airbag-Equipped Vehicle..............1-68
Setting the Time.............................................3-61
Sheet Metal Damage.......................................5-99
Shifting Into Park (P).......................................2-37
Shifting Out of Park (P)...................................2-38
Signals, Turn and Lane-Change.......................... 3-7
Spare Tire.....................................................5-91
Installing....................................................5-79Spare Tire (cont.)
Removing...................................................5-71
Storing.......................................................5-86
Specications, Capacities...............................5-112
Speedometer..................................................3-28
Split Bench Seat (60/40).................................... 1-7
Starting Your Engine.......................................2-26
Steering........................................................4-11
Steering Wheel Controls, Audio.........................3-89
Steering Wheel, Tilt Wheel................................. 3-6
Storage Areas
All-Weather Cargo Area................................2-59
Center Console Storage Area........................2-55
Center Overhead Console.............................2-54
Glove Box..................................................2-54
Luggage Carrier..........................................2-55
Rear Seat Armrest.......................................2-59
Stuck in Sand, Mud, Ice or Snow......................4-52
Sun Visors.....................................................2-22
Sunroof.........................................................2-62
Suspension....................................................4-66
T
Tachometer....................................................3-28
Tailgate.........................................................2-16
Taillamps.......................................................5-50
Theft-Deterrent, Radio.....................................3-89
Theft-Deterrent Systems...................................2-22
11