HUMMER H3 2007 User Guide

The seats have manual reclining seatbacks.
The lever used to operate them is located on
the outboard side of the seats.
To recline the seatback, do the following:
1. Lift the recline lever.
2. Move the seatback to the desired position,
then release the lever to lock the seatback
in place.
3. Push and pull on the seatback to make sure
it is locked.To return the seatback to an upright position,
do the following:
1. Lift the lever fully without applying pressure
to the seatback and the seatback will return
to the upright position.
2. Push and pull on the seatback to make sure
it is locked.
11

{CAUTION:
Sitting in a reclined position when your
vehicle is in motion can be dangerous.
Even if you buckle up, your safety belts
cannot do their job when you are reclined
like this.
The shoulder belt cannot do its job
because it will not be against your body.
Instead, it will be in front of you. In a
crash, you could go into it, receiving neck
or other injuries.
The lap belt cannot do its job either. In a
crash, the belt could go up over your
abdomen. The belt forces would be there,
not at your pelvic bones. This could cause
serious internal injuries.
For proper protection when the vehicle is
in motion, have the seatback upright.
Then sit well back in the seat and wear
your safety belt properly.
Do not have a seatback reclined if your vehicle
is moving.
12

Head Restraints
Adjust the head restraint so that the top of the
restraint is at the same height as the occupant’s
head. This position reduces the chance of a
neck injury in a crash.Pull the head restraint
up to raise it. To lower
the head restraint,
press the button,
located on the top
of the seatback,
and push the head
restraint down.
13

Rear Seats
60/40 Split Bench Seat
The 60/40 split bench seats can be folded to give
you more cargo space.
Folding the Seatbacks
To fold the rear seatback(s), do the following:
1. Make sure that nothing is on, under, or in
front of the seat.2. Place your hand
under the front of
the seat cushion
and lift the cushion
up while moving
it forward.
There is a label below the seat cushion with
instructions to aid in seat operation.
14

3. Pull the cushion forward until it rests in the
footwell.
Notice:Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.4. Lift the latch on top of the seatback and pull
the seatback forward. Fold the seatback down
until it is nearly at.
5. If the seatback will not fold nearly at, try
moving the front seat forward and/or moving
the front seatback more upright.
6. Repeat the steps for the other half of the
60/40 split bench seat.
15

Returning the Seatbacks to an Upright
Position
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on
the seatback to be sure it is locked.
{CAUTION:
A safety belt that is improperly routed,
not properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After raising the rear
seatback, always check to be sure that
the safety belts are properly routed and
attached, and are not twisted.To return the seatback(s) to the upright position,
do the following:
1. Lift the seatback up and push it rearward all
the way.
2. Place your hand under the front of the seat
cushion and lift the cushion while moving it
rearward until it latches into position.
3. Pull forward on the seatback and push down
on the seat cushion to make sure the seat is
securely in place.
16

Safety Belts
Safety Belts: They Are for Everyone
This part of the manual tells you how to use
safety belts properly. It also tells you some things
you should not do with safety belts.
{CAUTION:
Do not let anyone ride where he or she
cannot wear a safety belt properly. If you
are in a crash and you are not wearing a
safety belt, your injuries can be much
worse. You can hit things inside the
vehicle or be ejected from it. You can be
seriously injured or killed. In the same
crash, you might not be, if you are
buckled up. Always fasten your safety
belt, and check that your passengers’
belts are fastened properly too.
{CAUTION:
It is extremely dangerous to ride in a
cargo area, inside or outside of a vehicle.
In a collision, people riding in these areas
are more likely to be seriously injured or
killed. Do not allow people to ride in any
area of your vehicle that is not equipped
with seats and safety belts. Be sure
everyone in your vehicle is in a seat and
using a safety belt properly.
Your vehicle has indicators to remind you and your
passengers to buckle your safety belts. SeeSafety
Belt Reminder Light on page 177andPassenger
Safety Belt Reminder Light on page 177.
17

In most states and in all Canadian provinces,
the law says to wear safety belts. Here is
why:They work.
You never know if you will be in a crash. If you
do have a crash, you do not know if it will be
a bad one.
A few crashes are mild, and some crashes can
be so serious that even buckled up, a person
would not survive. But most crashes are in
between. In many of them, people who buckle up
can survive and sometimes walk away. Without
belts they could have been badly hurt or killed.
After more than 40 years of safety belts in
vehicles, the facts are clear. In most crashes
buckling up does matter... a lot!Why Safety Belts Work
When you ride in or on anything, you go as fast
as it goes.
Take the simplest vehicle. Suppose it is just a
seat on wheels.
18

Put someone on it. Get it up to speed. Then stop the vehicle.
The rider does not stop.
19

The person keeps going until stopped by
something. In a real vehicle, it could be the
windshield...or the instrument panel...
20