lock Hyundai Coupe 2008 User Guide

1
FEATURES OF YOUR HYUNDAI
13
To stop at the desired opening, pull up and release the switch. In order toprevent operation of the passenger front window by the passenger, a window lock switch (2) is provided on the armrest of the driver's door. To disable the passenger's power window, push the window lock switch. To revert to normaloperation, push in on the window lock switch again.
HGK2016
!WARNING:
1) Be careful that someone's head, hands and body are not trapped by a closing window.
2) Never try to operate the main switch on the driver's door and theindividual door window switch inopposing directions at the same time. If this is done, the window will stop and cannot be opened orclosed.
3) Do not leave children alone in the
car. Always remove the ignitionkey for their safety.
NOTE: The power windows can be operated for 30 seconds after the ignition key is turned to the "ACC" or "LOCK"positions, or removed from the igni- tion switch. If the front doors are opened during this 30 second pe-riod, the power windows can no longer be operated without the igni- tion key turned to the "ON" position.
SEATS
!
B080A01FC-GAT Adjustable Seats
WARNING:
Never attempt to adjust the seat while the vehicle is moving. This could result in loss of control or an acci-dent which may cause death, seri- ous injury, or property damage.

1FEATURES OF YOUR HYUNDAI
14
!!WARNING:
To ensure the seat is locked se- curely, attempt to move the seat for-ward or rearward without using the lock release lever. B080C01A-AAT Adjusting Seatback Angle
OGK036003
To recline the seatback, lean forward to take your weight off it, then pull up onthe recliner control lever at the outside edge of the seat. Now lean back until the desired seatback angle is achieved.To lock the seatback into position, release the recliner control lever. WARNING:
To minimize risk of severe injury inthe event of a collision or a sudden stop, both the driver's andpassenger's seatbacks should al- ways be in an upright position while the vehicle is in motion. The protec-tion provided by the seat belts and airbags in a frontal collision may be reduced significantly when the seatbacks are reclined. There is greater risk that the driver and passenger will slide under the seat belt which may result in serious injury if a crash occurs when the seatbacksare reclined. The seat belt cannot provide full protection to an occu- pant if the seat back is reclined.
B080B02FC-GAT FRONT SEATS Adjusting Seat Forward andRearward To move the seat toward the front or rear, pull the lock release lever upward.This will release the seat on its track so you can move it forward or rearward to the desired position. When you find theposition you want, release the lever and slide the seat forward or rearward on its track until it locks into the desiredposition and cannot be moved further. OGK036002

1
FEATURES OF YOUR HYUNDAI
15
B080D02JM-AAT Adjustable Headrests Headrests are designed to help reduce the risk of neck injuries. To raise the headrest, pull it up. Tolower it, push it down while pressing the lock knob. To remove the head- rest, raise it as far as it can go thenpress the lock knob while pulling up- ward. Lock Knob
HGK2032
!WARNING:
o For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the same height as the top of the occupant's eyes.The use of a cushion that holds the body away from the seatback is not recommended.
o Do not operate the vehicle with theheadrests removed as severe in- jury to an occupant may occur in the event of an accident. Head- rests may provide protectionagainst severe neck injuries when properly adjusted.
o Do not adjust the headrest height
while the vehicle is in motion.
B080D01JM

1
FEATURES OF YOUR HYUNDAI
17
NOTE:
o The seat warmer may not operate if ambient temperature is warm enough.
o If the seat warmer doesn't work when the ambient temperature islower than 24.5°C (76.1°F), it mustbe checked at an authorized dealer.
!
B130A01GK-AAT Rear Seat Entry (Walk in device) The driver and front passenger's seatbacks should be tilted to enter therear seat. By pulling up the walk in device lever (1) at the left-upper side of the driver sideseatback, the seatback will tilt forward. Then pull the lock release lever (2) up to move the seat forward. OGK036007
WARNING:
Be very careful not to injure by lowtemperature burn or an attack of fe- ver as following occupants; infants, children, old man, drunken man,people who is taken sleeping drug or cold remedy.
By pulling up the walk in device lever (1) at the right-upper side of the passengerside seatback, the seatback will tilt forward. Then push the seat forward to allow the occupants to enter. Recliner Memory By pulling up the walk in device lever (1), the seatback is reclined and re- turned to the original position. OGK036008

1
FEATURES OF YOUR HYUNDAI
19
CAUTION:
o Seat belts must be removed from the hanger when in use.
!
o Before folding the seatback, insert the buckle in the pocket. This can prevent the buckle from being dam-aged by seatback.
OGK016606 B110A02S-AAT Folding Rear Seatbacks The rear seatbacks may be folded to facilitate carrying long items or to in- crease the luggage capacity of thevehicle.
o To unlock the seatback, push the
seatback locking button, then pull forward on the seatback panel.
o When you return the seatback to its upright position, always be sure ithas locked into position by pulling and pushing on the top of theseatback.
HGK2035
!WARNING:
The purpose of the fold-down rear seatbacks is to allow you to carry longer objects than could other-wise be accommodated. Never al- low passengers to sit on top of the folded down seat back while the caris moving as this is not a proper seating position and no seat belts are available for use. This couldresult in injury in case of an acci- dent or sudden stop. Objects car- ried on the folded down seatback should not extend higher than the top of the front seats. This couldallow cargo to slide forward and cause injury or damage during sud- den stops.

1
FEATURES OF YOUR HYUNDAI
23
!
B170A04A-AAT Height Adjustable Front Seat Shoulder Belt (If installed)
WARNING:
o The height adjuster must be in the locked position when the vehicle is moving.
o The misadjustment of height of
the shoulder belt could reduce theeffectiveness of the seat belt in a crash.
HGK2038
You can adjust the height of the shoul-der belt anchor to one of the 4 positionsfor maximum comfort and safety. If the height of the adjusting seat belt is too near your neck, you will not begetting the most effective protection. The shoulder portion should be ad- justed so that it lies across your chestand midway over your shoulder nearest the door and not your neck. To adjust the height of the seat beltanchor, lower or raise the height ad- juster into an appropriate position. To raise the height adjuster, pull it up. Tolower it, push it down while pressing the height adjuster button. Release the button to lock the anchor into position. Try sliding the height ad-juster to make sure that it has locked into the position.B180A03A-GAT SEAT BELTS-Driver's and Passenger's 3-Point System withWebbing Clamp Locking Retrac-tor (If Installed)To Fasten Your Belt To fasten your seat belt, pull it out of the retractor and insert the metal tab intothe buckle. There will be an audible "click" when the tab locks into the buckle.The seat belt automatically adjusts to the proper length only after the lap belt is adjusted manually so that it fitssnugly around your hips. If you lean forward in a slow, easy motion, the belt will extend and let you move around.
B180A01NF

1FEATURES OF YOUR HYUNDAI
24
B200A01S-GAT Adjusting Your Seat Belt You should place the belt as low as possible on your hips, not on your waist. If the belt is located too high onyour body, you could slide under it in case of accident or a sudden stop. This could result of death, seriousinjury or property damage. Both arms should not be under or over the belt. Rather, one should be over and theother under, as shown in the illustra- tion. Never wear the seat belt under the armnearest the door. B200A01NFIf there is a sudden stop or impact, however, the belt will lock into position.It will also lock if you try to lean forward too quickly. NOTE: If you are not able to pull out the seat belt from the retractor, firmly pull the belt out and release it. Then you will be able to pull the belt out smoothly. B180A03Y-GAT SEAT BELTS-3-Point System with Emergency Locking Retrac- tor (If Installed)To Fasten Your Belt To fasten your seat belt, pull it out of the retractor and insert the metal tab intothe buckle. There will be an audible "click" when the tab locks into the buckle.The seat belt automatically adjusts to the proper length only after the lap belt is adjusted manually so that it fitssnugly around your hips. If you lean forward in a slow, easy motion, the belt will extend and let you move around. Ifthere is a sudden stop or impact, how- ever, the belt will lock into position. It will also lock if you try to lean forwardtoo quickly. Check to make sure that the belt is properly locked and that the belt is not twisted. NOTE: If you are not able to pull out the seat belt from the retractor, firmly pull the belt out and release it. Then you willbe able to pull the belt out smoothly.
B180A01NF

1
FEATURES OF YOUR HYUNDAI
25
B210A01A-AAT To Release the Seat Belt The seat belt is released by pressing the release button in the locking buckle. When it is released, the belt shouldautomatically draw back into the re- tractor. If this does not happen, check the beltto be sure it is not twisted, then try again.CHILD RESTRAINT SYSTEM
B230A04P-GAT (If Installed) Children riding in the car should sit in the rear seat and must always beproperly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. Accordingto accident statistics, children are safer when properly restrained in the rear seats than in the front seat. Largerchildren not in a child restraint should use one of the seat belts provided. You are required by law to use safetyrestraints for children. If small children ride in your vehicle you must put them in a child restraint system (safety seat).Child restraint systems are designed to be secured in vehicle seats by lap belts or the lap belt portion of a lap/shoulderbelt, or by a tether anchor and/or ISOFIX anchors (if installed). Children could be injured or killed in acrash if their restraints are not properly secured. For small children and ba- bies, a child seat or infant seat must beused. Before buying a particular child restraint system, make sure it fits your car and seat belts, and fits your child.Follow all the instructions provided by the manufacturer when installing the child restraint system.
B210A01NF
!WARNING:
o A child restraint system must be placed in the rear seat. Never install a child or infant seat on the front passenger's seat.Should an accident occur and cause the passenger's side airbag to deploy, it could severely in-jure or kill an infant or child seated in an infant or child seat. Thus, only use a child restraint in therear seat of your vehicle.
o Since a safety belt or child re-
straint system can become very hot if it is left in a closed vehicle, be sure to check the seat coverand buckles before placing a child there.
o When the child restraint system is not in use, fasten it with a safetybelt so that it will not be thrown forward in the case of a suddenstop or an accident.

1
FEATURES OF YOUR HYUNDAI
27
!
If you need to tighten the belt, pull more webbing toward the retractor. When youunbuckle the seat belt and allow it to retract, the retractor will automatically revert back to its normal seated pas-senger emergency locking usage con- dition. NOTE:
o Before installing the child re-
straint system, read the instruc- tions supplied by the child re- straint system manufacturer.
o If the seat belt does not operate as described, have the systemchecked immediately by yourauthorized Hyundai dealer.
WARNING:
Do not install any child restraintsystem in the front passenger seat. Should an accident occur and cause the passenger side airbag to de-ploy, it could severely injure or kill an infant or child seated in an infant or child seat. Therefore, only use achild restraint system in the rear seat of your vehicle. U: Suitable for "universal" category
restraints approved for use in thismass group
UF: Suitable for forward-facing "uni-
versal" category restraints ap-proved for use in this mass group
L1: Suitable for "Römer ISOFIX GR1"
approved for use in this massgroup
(Approval No: E1 R44-03301133)
X: Seat position not suitable for chil- dren in this mass group
N/A: No seating position is provided
B230H04GK-GAT Child Seat Restraint Suitability For Seat Position Using the SeatBelt Use child safety seats that have been officially approved and are appropriate for your children.
Rear
Center
Age Group Seating Position
X
N/A
XX N/A
X L1 N/A
X X N/A Rear
Outboard
1st
Passenger
0 : Up to 10 kg (0 ~ 9 months)0+ : Up to 13 kg(0 ~ 2 years)I : 9kg to 18kg(9 months ~4 years)II & III : 15kg to36kg (4 ~ 12years) X

1
FEATURES OF YOUR HYUNDAI
31
B180B02GK-GAT Pre-tensioner Seat Belt (If Installed) Your Hyundai vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pre-tensioner is to make sure that the seat belts fit tightly against theoccupant's body in certain frontal col- lisions. The pre-tensioner seat belts can beactivated alone or, where the frontal collision is severe enough, together with the airbags. The pre-tensioner seat belt operates ina similiar way as an Emergency Lock-ing Retractor (ELR) type of seat belt. When the vehicle stops suddenly, or if the occupant tries to lean forward tooquickly, the seat belt retractor will lock into position. In certain frontal colli- sions, the pre-tensioner will activateand pull the seat belt into tighter contact against the occupant's body.
OMG035300 B180B01GK
Driver's airbag1
2 3Passenger's airbag
o Do not mount more than one child
restraint to a child restraint lower anchorage point. The improper increased load may cause the an-chorage points or tether anchor to break, causing serious injury or death.
o Attach the ISOFIX or ISOFIX-com- patible child restraint seat onlyto the appropriate locationsshown in the illustration.
o Always follow the installation and
use instructions provided by themanufacturer of the child re- straint.