windshield HYUNDAI ELANTRA 2022 User Guide

Convenient Features
5-80
Windshield Washers
ODN8059209KODN8059209K
In the OFF position, pull the lever gently
toward you to spray washer fluid on the
windshield and to run the wipers 1-3
cycles. The spray and wiper operation
will continue until you release the lever. If
the washer does not work, you may need
to add washer fluid to the washer fluid
reservoir.
WARNING
When the outside temperature is below
freezing, ALWAYS warm the windshield
using the defroster to help prevent
the washer fluid from freezing on the
windshield and obscuring your vision
which could result in an accident and
serious injury or death.
NOTICE
• To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
• To prevent possible damage to the
wipers or windshield, do not operate
the wipers when the windshield is
dry.
• To prevent damage to the wiper
arms and other components, do
not attempt to move the wipers
manually.
• To prevent possible damage to the
wipers and washer system, use anti-
freezing washer fluids in the winter
season or cold weather.
CN7 HMA 5.indd 5-802020-12-03 9:21:02

05
5-81
MANUAL CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
„„Type AType A
OCN7050100NOCN7050100N
„„Type BType B
OCN7050101NOCN7050101N
1. Fan speed control knob
2. Temperature control knob
3. Mode selection knob
4. Front windshield defroster position
5. Rear window defroster button
6. Air intake control button
7. A/C (Air conditioning) button
CN7 HMA 5.indd 5-812020-12-03 9:21:02

Convenient Features
5-84
OCN7050102OCN7050102
The mode selection knob controls the
direction of the air flow through the
ventilation system.
Air can be directed to the floor,
dashboard outlets, or windshield. Five
symbols are used to represent Face, Bi-
Level, Floor, Floor-Defrost and Defrost air
position.
)DFH/HYHO%'
Air flow is directed toward the upper
body and face. Additionally, each outlet
can be controlled to direct the air
discharged from the outlet.
%L/HYHO%&'(
Air flow is directed towards the face and
the floor.
)ORRU/HYHO$&'(
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windshield and side
window defrosters.
)ORRU 'HIURVW$&'(
Most of the air flow is directed to the
floor and the windshield with a small
amount directed to the side window
defrosters.
'HIURVW/HYHO$'
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side window defrosters.
OCN7050104OCN7050104
0$;$&/HYHO%'LIHTXLSSHG
The MAX A/C mode is used to cool the
inside of the vehicle faster. Air flow is
directed toward the upper body and
face.
In this mode, the air conditioning and
the recirculated air position cannot be
selected. Turn the fan speed mode to
adjust.
CN7 HMA 5.indd 5-842020-12-03 9:21:03

Convenient Features
5-86
5HFLUFXODWLRQPRGH
When Recirculation mode
is selected, air from the
passenger compartment will
be recirculated through the
system and heated or cooled
according to the function
selected.
)UHVKPRGH
„„Type AType AWhen Fresh mode is
selected, air enters the
vehicle from outside and is
heated or cooled according
to the function selected.
„„Type BType B
Information
2SHUDWLQJWKHV\VWHPSULPDULO\LQ)UHVK
PRGHLVUHFRPPHQGHG8VH5HFLUFXODWLRQ
PRGHWHPSRUDULO\RQO\ZKHQQHHGHG
3URORQJHGRSHUDWLRQRIWKHKHDWHULQ
5HFLUFXODWLRQPRGHDQGZLWKRXWWKH$&
21FDQFDXVHIRJJLQJRIWKHZLQGVKLHOG
,QDGGLWLRQSURORQJHGXVHRIWKH$&
21LQ5HFLUFXODWLRQPRGHPD\UHVXOWLQ
H[FHVVLYHO\GU\GHKXPLGLILHGDLULQWKH
FDELQDQGPD\SURPRWHIRUPDWLRQRI
PXVW\YHQWRGRUGXHWRVWDJQDQWDLU
WARNING
• Continued use of the climate control
system operation in Recirculation
mode for a prolonged period of
time may cause drowsiness to the
occupants in the cabin. This may lead
to loss of vehicle control which may
lead to an accident.
• Continued use of the climate control
system operation in Recirculation
mode with the A/C OFF may allow
humidity to increase inside the
cabin. This may cause condensation
to accumulate on the windshield and
obscure visibility.
• Do not sleep in your vehicle or
remain parked in your vehicle with
the windows up and either the
heater or the air conditioning ON for
prolonged periods of time. Doing so
may increase the levels of carbon
dioxide in the cabin which may lead
to serious injury or death.
CN7 HMA 5.indd 5-862020-12-03 9:21:04

Convenient Features
5-88
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning ON
with the temperature control knob set
to heat in order to dehumidify the air
before it enters into the cabin.
If the windshield fogs up, select the Floor
& Defrost
mode or rotate the mode
selecting knob to the Defrost
mode.
2SHUDWLRQ7LSV
• To help keep dust or unpleasant fumes
from ent
ering the vehicle through the
ventilation system, temporarily set the
air intake control to the recirculation
mode. Be sure to return the control
to fresh mode position when the
irritation has passed to keep fresh air
in the vehicle. This will help keep the
driver alert and comfortable.
• To help prevent interior fog on the
windshield, set the air intake control
to fresh mode and fan speed to
the desired position, turn on the
air conditioning system, and adjust
the temperature control to desired
temperature.
Air conditioning
HYUNDAI Air Conditioning Systems are
filled with R-1234yf refrigerant.
1. Start the vehicle.
2. Push the air conditioning button
3. Select the Face Level
mode.
4. Set the air intake control to
Recirculation mode temporarily to
allow the cabin to cool quickly. When
the desired temperature in the cabin
is reached, change the air intake
control back to Fresh mode.
5. Adjust the fan speed control and
temperature control to maintain
maximum comfort.
CN7 HMA 5.indd 5-882020-12-03 9:21:04

Convenient Features
5-90
$LUFRQGLWLRQLQJV\VWHPRSHUDWLRQWLSV
• If the vehicle has been parked in
direct sunlight during hot weather,
open the windows for a short time
to let the hot air inside the vehicle
escape.
• After sufficient cooling has been
achieved, switch back from
recirculation mode to fresh mode.
• To help reduce moisture inside of
the windows on rainy or humid
days, decrease the humidity inside
the vehicle by operating the air
conditioning system with the windows
and sunroof closed.
• During air conditioning system
operation, you may occasionally
notice a slight change in engine speed
as the air conditioning compressor
cycles. This is a normal system
operation characteristic.
• Use the air conditioning system
every month only for a few minutes
to ensure maximum system
performance.
• When using the air conditioning
system, you may notice clear water
dripping (or even puddling) on the
ground under the passenger side of
the vehicle. This is a normal system
operation characteristic.
• If you operate the air conditioner
excessively, the difference between
the temperature of the outside air and
that of the windshield could cause
the outer surface of the windshield to
fog up, causing loss of visibility. In this
case, set the mode selection button to
the
position and set the fan speed
control knob to the lowest speed
setting.
System Maintenance
Cabin air filter
OIK047401LOIK047401L[A] : Outside air, [B] : Recirculated air
[C] : Cabin air filter, [D] : Blower
[E] : Evaporator core, [F] : Heater core
The cabin air filter is installed behind
the glove box. It filters the dust or other
pollutants that enter the vehicle through
the heating and air conditioning system.
Have the cabin air filter replaced by an
authorized HYUNDAI dealer according to
the maintenance schedule. If the vehicle
is being driven in severe conditions such
as dusty or rough roads, more frequent
cabin air filter inspections and changes
are required.
If the air flow rate suddenly decreases,
the system should be checked at an
authorized HYUNDAI dealer.
Information
• 5HSODFHWKHILOWHUDFFRUGLQJWRWKH
0DLQWHQDQFH6FKHGXOH
• ,IWKHFDULVEHLQJGULYHQLQVHYHUH
FRQGLWLRQVVXFKDVGXVW\URXJK
URDGVPRUHIUHTXHQWFDELQDLUILOWHU
LQVSHFWLRQVDQGFKDQJHVDUHUHTXLUHG
• :KHQWKHDLUIORZUDWHVXGGHQO\
GHFUHDVHVZHUHFRPPHQGWKDWWKH
V\VWHPEHFKHFNHGE\DQDXWKRUL]HG
+<81'$,GHDOHU
CN7 HMA 5.indd 5-902020-12-03 9:21:05

Convenient Features
5-92
AUTOMATIC CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OCN7050110LOCN7050110L
1. Driver’s temperature control knob
2. Passenger’s temperature control knob
3. AUTO (automatic control) button
4. SYNC button
5. OFF button
6. Front windshield defroster button
7. Air conditioning button
8. Air intake control button
9. Rear window defroster button
10. Fan speed control button
11. Mode selection button
12. Climate control information screen
CN7 HMA 5.indd 5-922020-12-03 9:21:06

05
5-93
Automatic heating and air
conditioning
OCN7050112OCN7050112
1. Press the AUTO button
The modes, fan speeds, air intake and
air-conditioning will be controlled
automatically according to the
temperature setting you select.
OCN7050113OCN7050113
You can control the blower strength in
three stages by pushing the AUTO button
during automatic operation.
- HIGH : Provide rapid air conditioning
and heating with strong blower
- MEDIUM : Provide air conditioning
and heating with medium strength
blower
- LOW : Is suitable for drivers that prefer
lower air speedsWhen you select the temperature to HI
or LO in AUTO mode, the fan speed is set
to ‘HIGH’.
„„Driver’s seatDriver’s seat„„Passenger’s seatPassenger’s seat
OCN7050114OCN7050114
2. Turn the temperature control knob
to set the desired temperature. If
the temperature is set to the lowest
setting (Lo), the air conditioning
system will operate continuously.
• To turn the automatic operation off,
select any button of the following:
- Mode selection button
- Front windshield defroster button
(Press the button one more time
to deselect the front windshield
defroster function. The ‘AUTO’ sign
will illuminate on the information
screen once again.)
- Fan speed control toggle switch
The selected function will be
controlled manually while other
functions operate automatically.
• For your convenience and overall
system efficiency, use the AUTO
button and set the temperature to
72°F (22°C).
CN7 HMA 5.indd 5-932020-12-03 9:21:06

Convenient Features
5-96
OCN7050115OCN7050115
The mode selection toggle switch
controls the direction of the air flow
through the ventilation system.
The air flow outlet direction is cycled as
follows:
)DFHOHYHO%'
Air flow is directed toward the upper
body and face. Additionally, each outlet
can be controlled to direct the air
discharged from the outlet.
%L/HYHO%&'(
Air flow is directed towards the face and
the floor.
)ORRU/HYHO$&'(
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windshield and side
window defrosters.
)ORRU 'HIURVW$&'(
Most of the air flow is directed to the
floor and the windshield with a small
amount directed to the side window
defrosters.
CN7 HMA 5.indd 5-962020-12-03 9:21:07

05
5-97
OCN7050116OCN7050116
'HIURVW/HYHO$'
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side window defrosters.
OCN7050106OCN7050106
,QVWUXPHQWSDQHOYHQWV
The instrument panel vent air flow can be
directed up/down or left/right using the
vent adjustment lever.
To close the vent, push the air vent
lever in the opposite direction of the
passenger. To open the vent, push the
air vent lever in the same direction of the
passenger.
Temperature control
„„Driver’s seatDriver’s seat„„Passenger’s seatPassenger’s seat
OCN7050114OCN7050114
The temperature will increase by turning
the knob to the right.
The temperature will decrease by turning
the knob to the left.
The temperature will increase or
decrease by 1°F (0.5°C) for each
incremental location. When set to the
lowest temperature setting, the air
conditioning will operate continuously.
CN7 HMA 5.indd 5-972020-12-03 9:21:07