turn signal Hyundai Genesis 2016 Quick Reference Guide
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2016, Model line: Genesis, Model: Hyundai Genesis 2016Pages: 22, PDF Size: 10.07 MB
Page 6 of 22

Quick Reference Guide I 09
FEATURES AND CONTROLS
08 I Quick Reference Guide
WIPERS AND WASHER
Auto control wipe interval adjustment
Adjust the control knob.
Windshield washer
Pull the lever gently toward you to
spray washer fluid on the windshield
and to run the wipers1-3 cycles.
Headlamp washer
Fluid will spray on headlamp
assemblies when headlamps are
turned ON. Will activate only once for
every ignition key cycle or only once
every 15 minutes.
Fast wiper speed
Slow wiper speedMIST
- Single wipe
AUTO
- Auto control wipe
LO
- Low wiper speed
HI
- High wiper speed
OFF
HEADLIGHTS AND FOG LIGHTS
Parking light positionDRL OFF position Auto light positionHeadlight position
Headlight delayHeadlights may stay on for 15 seconds after exiting and locking vehicle.
Press remote lock button twice to turn headlights off.
See Owner’s Manual for more detail.
Fog light
Turn signals and lane change
signalsFlashing high beam
PULL
PULL
High beam
PUSH
GENESIS HYUNDAI
Smart High Beam Function1. Select auto position on stalk.
2. Push lever forward to engage Auto High beam.
3. Push lever forward again to disengage.
See Owner's Manual for more details.
Page 8 of 22

Quick Reference Guide I 13
FEATURES AND CONTROLS
12 I Quick Reference Guide CHILD-PROTECTOR REAR DOOR LOCK
Lock Insert a screwdriver into the hole and
turn it to the lock position.UnlockInsert a screwdriver into the hole and turn it
counterclockwise to unlock position.
HOMELINK WIRELESS CONTROL SYSTEMStandard Programming To program most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons,
HomeLink
® Channel 1 and Channel 3 Buttons, until the indicator light
begins to flash (after 10 seconds). Release both buttons. Do not hold
the buttons for longer than 20 seconds.
2. Position the end of your hand-held transmitter 1-3 inches (2-8 cm)
away from the HomeLink
® buttons while keeping the indicator light
in view.
3. Simultaneously press and hold both the HomeLink
® and hand-held
transmitter button. DO NOT release the buttons until step 4 has
been completed.
4. While continuing to hold the buttons the red indicator Status LED
will flash slowly and then rapidly after HomeLink
® successfully trains
to the frequency signal from the hand-held transmitter. Release both
buttons.
For detail instructions, refer to your Owner’s Manual or visit
www.homelink.com.
GENESIS HYUNDAI
Smart TrunkTrunk will open automatically when
detecting smart key within range near the
trunk for more than 3 seconds.To enable Smart Trunk function:Vehicle must be in P (Park) to adjust
settings in the User Setting mode.
1. Select "Door/Trunk" in the User Settings
in the instrument cluster.
2. Check "Smart Trunk".NOTE: Function is active after 15 seconds
when all doors are closed and locked. The
vehicle will also provide an audible and visual
alarm while activating. For more details, refer
to Owner's Manual.
Factory setting defaults Smart Trunk in OFF
position.
Page 10 of 22

INSTRUMENT CLUSTER
Quick Reference Guide I 17
16 I Quick Reference Guide
WARNINGS AND INDICATORSAir bag warning lightElectric Power Steering
(EPS) warning light
Seat belt warning
Parking brake & Brake
fluid warning light
Electronic Brake Force Distribution (EBD)
system warning light
Low tire pressure
warning light
Trunk open
warning lightLow fuel level
warning light
Front fog light indicator
Low beam indicatorSmart high beam
indicatorSNOW mode
indicator
Light ON indicator
ECO indicator
SPORT mode
indicator
Anti-lock Brake System
(ABS) warning lightHigh beam indicator
Door open
warning lightElectronic Stability
Control (ESC) indicator
Master warning light
Automatic Emergency
Braking (AEB) warning light
Electric Parking Brake
(EPB) warning lightEngine oil pressure
warning light
Charging system
warning light
Immobilizer indicator
Malfunction Indicator
Lamp (MIL)
Electronic Stability Control
(ESC) OFF indicator
Cruise indicatorLane Keeping Assistant System(LKAS)
indicator
Cruise SET indicator
AUTO HOLD indicator
Turn signal indicator
LCD DISPLAY MODES
The head up display is a transparent
display which projects a shadow of
selected information of the instrument
cluster and navigation on the
windshield glass.
To activate the head up display, select
“Head-up Display” on the “User
Settings Mode” in the LCD display.
Adjust "Head-up Display" height until
in view.
HEAD UP DISPLAY
1 : MODE button for changing
modes2 : MOVE switch for changing
items
: SELECT/RESET button for
setting or resetting the
selected item3 : BACK button for moving
to upper level menu
(if equipped)
LCD DISPLAY CONTROL
Modes Symbol Explanation
Trip ComputerThis mode displays driving information like the
tripmeter, fuel economy, and so on.
Turn By Turn (TBT)
(if equipped)
This mode displays the navigation turn by turn
guidance.
ASCC/LKAS
(if equipped)This mode displays the state of the Advanced
Smart Cruise Control (ASCC) and
Lane Keeping Assist System (LKAS).
A/VThis mode displays the state of the A/V
system.
Informaition orDisplays service interval and warning
messages.
User Settings Changes settings.Type AType B
12
3
12
Engine coolant temperature
warning lightAWD warning light
GENESIS HYUNDAI NOTE: See Owner's Manual for more details on selecting content to
display on the Head Up Display.
(Press)