windscreen HYUNDAI I10 2021 User Guide

5-62
Convenient features
AUTOMATIC CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OAI3059101I
1. Fan speed control knob
$&$LUFRQGLWLRQLQJEXWWRQ
5HFLUFXODWLRQPRGH)UHVKPRGH
4. Mode selection button
5. Rear window defroster button
(if equipped)6. Front windscreen defroster button
7. OFF button
8. Temperature control knob
9. AUTO (automatic control) button
10. Climate control screen

5-65
05
OAI3059113I
The mode selection button controls
the direction of the air flow through
the ventilation system.
The air flow outlet direction is cycled
as follows:
Face-Level (B, ')
Air flow is directed toward the upper
body and face. Additionally, each out-
let can be controlled to direct the air
discharged from the outlet.
Bi-Level (B, C, ')
Air flow is directed towards the face
and the floor.
Floor-Level (A, C, ')
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windscreen and
side window defrosters.
Floor 'efrost (A, C, ')
Most of the air flow is directed to the
floor and the windscreen with a small
amount directed to the side window
defrosters.
OAI3059114I
'efrost-Level (A, ')
Most of the air flow is directed to the
windscreen with a small amount of air
directed to the side window defrost-
ers.
OAC3059103R
Instrument panel vents
The instrument panel vent air flow
FDQ EH GLUHFWHG XSGRZQ RU OHIWULJKW
XVLQJWKHYHQWDGMXVWPHQWOHYHU
7R FORVH WKH YHQW DGMXVWPHQW OHYHU
rotate it to the outer side till the end.
To open the vent, rotate it to the inner
side.

5-68
Convenient features
Air conditioning
OAI3059107I
3XVKWKH$&EXWWRQWRPDQXDOO\WXUQ
the air conditioning system on (indi-
cator light will illuminate).
Push the button again to turn the air
conditioning system off.
OFF mode
OAI3059116I
Push the OFF button of the front to
turn off the air climate control system.
However, you can still operate the
mode and air intake buttons as long
as the ignition switch is in the ON
position.
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning
ON with the temperature control
knob set to heat in order to dehu-
midify the air before it enters into
the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press
the Front Defrost
mode.

5-73
05
WARNING
Windscreen heating
Do not use the or position
during cooling operation in
extremely humid weather. The dif-
ference between the temperature
of the outside air and that of the
windscreen could cause the outer
surface of the windscreen to fog
up, causing loss of visibility. In
this case, set the mode selection
knob or button to the
position
and fan speed control knob or but-
ton to lower speed.

5-74
Convenient features
Automatic climate control
system
To defog inside windscreen
OAI3059108I
1. Select desired fan speed.
2. Select desired temperature.
3. Press the defroster button (
).
4. The air-conditioning will turn on
according to the detected ambient
temperature, outside (fresh) and
higher fan speed will be selected
automatically.
If the air-conditioning, outside (fresh)
air position and higher fan speed are
QRWVHOHFWHGDXWRPDWLFDOO\DGMXVWWKH
corresponding button or knob manu-
ally.
If the
position is selected, lower
IDQ VSHHG LV DGMXVWHG WR KLJKHU IDQ
speed.
To defrost outside windscreen
OAI3059109I
1. Set the fan speed to the highest
position.
6HWWKHWHPSHUDWXUHWRWKHH[WUHPH
hot (HI) position.
3. Press the defroster button (
).
4. The air-conditioning will turn on
according to the detected ambient
temperature and outside (fresh)
mode will be selected automatical-
ly.
If the position is selected, lower fan
VSHHGLVDGMXVWHGWRKLJKHUIDQVSHHG

5-75
05
Defroster
NOTICE
To prevent damage to the conduc-
tors bonded to the inside surface
of the rear window, never use
sharp instruments or window
cleaners containing abrasives to
clean the window.
i Information
If you want to defrost and defog the
front windscreen, refer to “Windscreen
'efrosting and 'efogging” in this
chapter.
Rear window defroster
OAI3059102
„Manual climate control system
„Automatic climate control system
OAI3059102I
The defroster heats the window to
remove frost, fog and thin ice from
WKH LQWHULRU DQG H[WHULRU RI WKH UHDU
window, whilst engine is running.

6-4
Whilst driving
WARNING
Carbon monoxide (CO) gas is toxic. Breathing CO can cause uncon-
sciousness and death.
Engine exhaust contains carbon monoxide which cannot be seen or smelled.
Do not inhale engine exhaust.
If at any time you smell engine exhaust inside the vehicle, open the windows
immediately. Exposure to CO can cause unconsciousness and death by
asphyxiation.
Be sure the exhaust system does not leak.
The exhaust system should be checked whenever the vehicle is raised to
change the oil or for any other purpose. If you hear a change in the sound of the
exhaust or if you drive over something that strikes the underneath side of the
vehicle, we recommend that the exhaust system be checked as soon as pos-
sible by a HYUNDAI authorised repairer.
Do not run the engine in an enclosed area.
Letting the engine idle in your garage, even with the garage door open, is a
hazardous practice. Run the engine only long enough to start the engine and to
move the vehicle out of the garage.
Avoid idling the engine for prolonged periods with people inside the vehi-
cle.
If it is necessary to idle the engine for a prolonged period with people inside the
vehicle, be sure to do so only in an open area with the air intake set at “Fresh”
and fan control set to high so fresh air is drawn into the interior.
Keep the air intakes clear.
To assure proper operation of the ventilation system, keep the ventilation air
intakes located in front of the windscreen clear of snow, ice, leaves, or other
obstructions.
If you must drive with the tailgate open:
Close all windows.
Open instrument panel air vents.
Set the air intake control at “Fresh”, the air flow control at “Floor” or “Face”, and
the fan control set to high.

6-61
06
LANE KEEPING ASSIST
ãLKA
ä
ãIF EQUIPPED
ä
2$&78
Lane Keeping Assist system detects
the lane markers and road edge on
the road with a front view camera at
the front windscreen, and assists the
driver’s steering to help keep the
vehicle in the lanes.
When the system detects the vehicle
straying from its lane, it alerts the
driver with a visual and audible warn-
ing, whilst applying a counter-steer-
ing torque, trying to prevent the vehi-
cle from moving out of its lane.
WARNING
/DQH.HHSLQJ$VVLVWV\VWHPLVQRW
a substitute for safe driving prac-
tices, but a convenience function.
It is the responsibility of the driver
to always be aware of the sur-
roundings and steer the vehicle.
WARNING
Take the following precautions
ZKHQ XVLQJ /DQH .HHSLQJ $VVLVW
system:

6-72
Whilst driving
2$&78
Intelligent Speed Limit Warning sys-
tem displays the speed limit informa-
tion and overtaking restriction of the
current road through the instrument
cluster and the navigation. ISLW
reads the traffic signs through the
front view camera, which is attached
on the upper part of the inner front
windscreen.
ISLW also utilizes the navigation and
vehicle information to display the
speed limit information.
WARNING

6-81
06
NOTICE
Driver Attention Warning system
utilizes the front view camera on
the front windscreen for its opera-
tion. To keep the front view camera
in the best condition, you should
observe the followings: