engine stop HYUNDAI I10 2023 User Guide

4-20
Instrument cluster
Forward Collision-
Avoidance Assist sys-
tem warning light (if
equipped)
7his indicator light illuminates
‡When you set the ignition switch or
Engine Start/Stop button to the ON
position.
- It illuminates for approximately 3
seconds and then goes off.
‡When there is a malfunction with
FCA.
In this case, we recommend that you
have the vehicle inspected by a
HYUNDAI authorised repairer.
For more details, refer to “Forward
Collision-Avoidance Assist (FCA)”
in chapter 6.
Lane Keeping Assist
system indicator light
(if equipped)
7his indicator light illuminates
‡[Green] When the system operating
conditions are satisfied.
‡[White] The system operating con-
ditions are not satisfied.
‡[Yellow] When there is a malfunc-
tion with the lane keeping assist
system.
In this case, we recommend that
you have your vehicle inspected by
a HYUNDAI authorised repairer.
For more details, refer to “Lane
Keeping Assist (LKA)” in chapter
6.
LCD display messages
Key not in vehicle
(for smart key system)
This warning message is displayed if
the smart key is not in the vehicle
when you open or close door in the
ACC position or ON position. The
warning sound is heard when you
close door without a smart key in
vehicle.
When attempting to start the vehicle
always have the smart key with you.
Key not detected
(for smart key system)
This warning message is displayed if
the smart key is not detected when
you press the Engine Start/Stop but-
ton.
Press START button with key
(for smart key system)
This warning message is displayed if
you press the Engine Start/Stop but-
ton whilst the warning message “Key
not detected” is displayed.
At this time, the immobiliser indicator
light blinks.
Low Key Battery
(for smart key system)
This warning message is displayed if
the battery of the smart key is dis-
charged whilst changing the Engine
Start/Stop button to the OFF position.

4-21
04
Press brake pedal to start
engine (for smart key system
and Automated Manual
Transmission)
This warning message is displayed if
the Engine Start/Stop button changes
to the ACC position twice by pressing
the button repeatedly without
depressing the brake pedal.
You can start the vehicle by depress-
ing the brake pedal.
Press clutch pedal to start
engine (for smart key system
and Manual transmission)
This warning message is displayed if
the Engine Start/Stop button is in the
ACC position twice by pressing the
button repeatedly without depressing
the clutch pedal.
Depress the clutch pedal to start the
engine.
Press START button again
(for smart key system)
This message is displayed if you
were unable to start the vehicle when
the Engine Start/Stop button was
pressed.
If this occurs, attempt to start the
engine by pressing the Engine Start/
Stop button again.
If the warning message appears each
time you press the Engine Start/Stop
button, we recommend that you have
your vehicle inspected by a HYUNDAI
authorised repairer.
Shift to N to start engine
(for smart key system and
Automated Manual
Transmission)
This warning message is displayed if
you try to start the engine with the
shift button not in the N (Neutral)
position.
i Information
lever in the 1 (1eutral) position.
Check BRAKE SWITCH fuse (for
smart key system and
Automated manual transmis-
sion)
This warning message is displayed if
the brake switch fuse is disconnect-
ed.
You need to replace the fuse with a
new one. If that is not possible, you
can start the engine by pressing the
Engine Start/Stop button for 10 sec-
onds in the ACC position.

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed
when the engine oil level should be
checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as
required.
Slowly pour the recommended oil lit-
tle by little into a funnel. (Oil refill
capacity : approximately 0.15 ~ 0.26
gal. (0.6 ~ 1.0 l)
Use only the specified engine oil.
(Refer to "Recommended lubricants
and capacities" in chapter 8.)
Do not overfill the engine oil. Make
sure the oil level is not above F (Full)
mark on the dipstick.
NOTICE
If the message is displayed contin-
uously after adding the engine oil
and travelling approximately
50~100 km after the engine warms
up, we recommend that the system
be checked by a HYUNDAI autho-
rised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means
that the engine is overheated and
may be damaged.
If your vehicle is overheated, refer
to “Overheating” in chapter 7.
Check headlight (if equipped)
This warning message is displayed if
the headlamps are not operating
properly.
In addition, if a specific lamp(turn sig-
nal lamp etc.) is not operating proper-
ly, the warning message according to
a specific lamp (turn signal lamp etc.)
is displayed. A corresponding bulb
may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.
Check brake light (if equipped)
This warning message is displayed if
the stop lamps are not operating
properly. A lamp may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.

4-35
04
„Type A
OQX069060L
„Type B
To change the trip mode, toggle the
"
, " switch on the steering wheel.
Fuel economy
OAC3069039R
Average Fuel (conomy (1)
‡The average fuel economy is calcu-
lated by the total driving distance
and fuel consumption since the last
average fuel economy reset.
‡The average fuel economy can be
reset both manually and automati-
cally.Manual reset
To clear the average fuel economy
manually, press the [OK] button on
the steering wheel for more than 1
second when the average fuel econo-
my is displayed.
Automatic reset
To automatically reset the average
fuel economy after refueling, select
the "Fuel Econ. Reset" mode in the
User Settings menu on the LCD dis-
play.
- After vehicle On: The average fuel
economy will reset automatically
whenever it has passed 4 hours
after turning OFF the engine.
- After refueling: The average fuel
economy will reset automatically
when driving speed exceeds 1
km/h, after adding 1.6 gallons (6
liters) of fuel or more.
i Information
7he average fuel economy may be
inaccurate, when the vehicle drives
shorter than .1 miles (3 metres)
after turning 21 the (ngine Start/
Stop button.
Instant Fuel Economy (2)
‡This mode displays the instant fuel
economy during the last few sec-
onds when the vehicle speed is
more than 6.2 mph (10 km/h).

4-36
Instrument cluster
Accumulated Info display
OAC3069041TU
This display shows the accumulated
trip distance (1), the average fuel
economy (2), and the total driving
time (3).
The information is accumulated start-
ing from the last reset.
To manually reset the information,
press and hold the OK button when
viewing the Accumulated driving info.
The trip distance, the average fuel
economy, and total driving time will
reset simultaneously.
The accumulated driving information
will continue to be counted whilst the
engine is still running (for example,
when the vehicle is in traffic or
stopped at a stop light).
i Information
7he vehicle must be driven for a mini-
mum of .1 miles (3 metres) since
the last ignition key cycle before the
average fuel economy will be recalcu-
lated.
Drive Info display
OAC3069040R
This display shows the trip distance
(1), the average fuel economy (2),
and the total driving time (3).
The information is combined for each
ignition cycle. However, when the
engine has been OFF for 4 hours or
longer the Drive Info screen will reset.
To manually reset the information,
press and hold the OK button when
viewing the Drive Info. The trip dis-
tance, the average fuel economy,
and total driving time will reset simul-
taneously.
The driving information will continue
to be counted whilst the engine is still
running (for example, when the vehi-
cle is in traffic or stopped at a stop
light.)

5-33
05
WARNING
OAC3059062TU
Do not hold the part (gas lifter) that
supports the tailgate. Be aware
that the deformation of the part
may cause vehicle damage and a
risk of safety accident.
)XHOILOOHUGRRU
Opening the fuel filler door
OAC3059021R
The fuel filler door must be opened
from inside the vehicle by pulling up
the fuel filler door opener.
1. Stop the engine.
2. Pull the fuel filler door opener up.
OAC3059053TU
3. Pull the fuel filler door out (1) to
fully open.
4. To remove the fuel tank cap (2),
turn it counterclockwise. You may
hear a hissing noise as the pres-
sure inside the tank equalizes.
5. Place the cap on the fuel filler door
(3).
i Information
If the fuel filler door does not open
because ice has formed around it, tap
lightly or push on the door to break the
ice and release the door. 'o not pry on
the door. If necessary, spray around
the door with an approved de-icer fluid
(do not use radiator anti-free]e) or
move the vehicle to a warm place and
allow the ice to melt.

5-103
05
i Information
$ERXWKDQGOLQJWKHV\VWHP
‡ 'o not apply excessive force to the
system. Excessive pressure on the
screen may damage the LC' panel
or the touch panel.
‡ When cleaning the screen or button
panel, make sure to stop the engine
and use a soft, dry cloth. Wiping the
screen or buttons with a rough cloth
or using solvents (alcohol, ben]ene,
paint thinner, etc.) may scratch or
chemically damage the surface.
‡ If you attach a liquid-type air fresh-
ener to the fan louvre, the surface of
the louvre may become deformed
due to the flowing air.
‡ If you want to change the position of
the installed device, please inquire
with your place of purchase or ser-
vice maintenance centre. 7echnical
expertise is required to install or dis-
assemble the device.
NOTICE

Before driving ......................................................................................................6-5
Before entering the vehicle ...........................................................................6-5
Before starting ................................................................................................6-5
Ignition switch..................................................................................................... 6-7
Key ignition switch
......................................................................................... 6-7
Engine Start/Stop button ............................................................................. 6-10
Manual transmission
........................................................................................ 6-15
Manual transmission operation ................................................................... 6-15
Good driving practices ..................................................................................6-17
Automated manual transmission (AMT)
......................................................... 6-18
Automated Manual Transmission (AMT) operation .................................... 6-19
Features of the Automated Manual Transmission (AMT) .......................... 6-19
LCD display for transmission temperature and warning message ............ 6-23
Transmission ranges ......................................................................................6-28
Parking ........................................................................................................... 6-31
Good driving practices ................................................................................. 6-31
Braking system
..................................................................................................6-33
Power brakes ................................................................................................6-33
Disc brakes wear indicator ...........................................................................6-33
Rear drum brakes ..........................................................................................6-34
Parking brake ................................................................................................6-34
Anti-lock Brake System (ABS) .......................................................................6-35
Electronic Stability Control (ESC)................................................................. 6-37
Vehicle Stability Management (VSM) ......................................................... 6-40
Hill-Start Assist Control (HAC) ...................................................................... 6-41
Emergency Stop Signal (ESS) ...................................................................... 6-42
Good braking practices ............................................................................... 6-42
ISG (Idle Stop and Go) system
........................................................................ 6-44
To activate the ISG system ........................................................................... 6-44
To deactivate the ISG system ......................................................................6-47
ISG system malfunction ................................................................................6-47
The battery sensor deactivation .................................................................. 6-48
6. Whilst driving
6

6-12
Whilst driving
Engine Stop/Start button positions
Button PositionAction Notice
OFF

6-30
Whilst driving
Manual shift mode
2$,,
Whether the vehicle is stationary or in
PRWLRQ 0DQXDO VKLIW PRGH LV VHOHFW-
ed by pushing the shift lever from the
D (Drive) position into the manual
JDWH07RUHWXUQWR''ULYHUDQJH
operation, push the shift lever back
into the main gate.
,Q 0DQXDO VKLIW PRGH PRYLQJ WKH
shift lever backwards and forwards
will allow you to select the desired
range of gears for the current driving
conditions.
8S3XVK WKH OHYHU IRUZDUG RQFH
to shift up one gear.
'RZQ3XOO WKH OHYHU EDFNZDUGV
once to shift down one
gear.
NOTICE
If you cannot move the shift lever
into any position or if the gear is
automatically moved to N (Neutral)
position when the vehicle speed
becomes below 6 mph (10 km/h),
this may indicate malfunction of
the system. In this case, we recom-
mend the system be checked by a
HYUNDAI authorised repairer.
i Information
‡ 2nly the five forward gears can be
selected. 7o reverse or park the vehi-
cle, move the shift lever to the R
(Reverse) or 1 (1eutral) position as
required.
‡ 'ownshifts are made automatically
when the vehicle slows down. When
the vehicle stops, 1st gear is automat-
ically selected.
‡ When the engine rpm approaches
the red ]one the transmission will
upshift automatically.
‡ If the driver presses the lever to 
(8p) or - ('own) position, the trans-
mission may not make the requested
gear change if the next gear is out-
side of the allowable engine rpm
range. 7he driver must execute
upshifts in accordance with road
conditions, taking care to keep the
engine rpms below the red ]one.
‡ When accelerating from a stop on a
slippery road, push the shift lever
forward into the  (8p) position.
7his allows the transmission to shift
into the 2nd gear which is better for
smooth driving on a slippery road.
Push the shift lever to the - ('own)
side to shift back to the 1st gear.