lock HYUNDAI I20 2020 Owner's Guide

6-9
06
Unlocking
OBI3050001OBI3050001
To unlock:
1. Carry the Smart Key.
2. Either press the door handle button or
press the Door Unlock button (2) on
the smart key.
3. The doors will unlock. The hazard
warning lights will blink two times.
i Information
• The door handle button will only
operate when the smart key is within 1
m (40 in.) from the outside door handle.
Other people can also open the doors
without the smart key in possession.
• After unlocking the doors, the doors
will lock automatically after 30 seconds
unless a door is opened.
Tailgate unlocking
To unlock:
1. Carry the smart key.
2. Press the Tailgate Unlock button (3)
on the smart key for more than one
second.
3. The hazard warning lights will blink
two times.
Once the tailgate is opened and then
closed, the tailgate/trunk will lock
automatically.
i Information
After unlocking the tailgate, the tailgate
will lock automatically after 30 seconds
unless the tailgate is opened.
Panic button (if equipped)
Press and hold the Panic button (4) for
more than one second. The horn sounds
and hazard warning lights flash for about
30 seconds.
To cancel the panic mode, press any
button on the smart key.

6-10
Convenient features
Start-up
You can start the engine without
inserting the key. For detailed
information refer to the Engine Start/
Stop button in chapter 6.
NOTICE
To prevent damaging the smart key:
• Keep the smart key away from water
or any liquid and fire. If the inside
of the smart key gets damp (due to
drinks or moisture), or is heated,
internal circuit may malfunction,
excluding the car from the warranty.
• Avoid dropping or throwing the
smart key.
• Protect the smart key from extreme
temperatures.
NOTICE
Always have the smart key with you
when leaving the vehicle. If the smart
key is left near the vehicle, the vehicle
battery may be discharged.
Mechanical key
If the Smart Key does not operate
normally, you can lock or unlock the
door by using the mechanical key.
OIB044175OIB044175
Press and hold the release button (1) and
remove the mechanical key (2). Insert
the mechanical key into the key hole on
the door.
To reinstall the mechanical key, put the
key into the hole and push it until a click
sound is heard.
Loss of a smart key
A maximum of two smart keys can
be registered to a single vehicle. If
you happen to lose your smart key,
it is recommended that you should
immediately take the vehicle and
remaining key to your authorized
HYUNDAI dealer or tow the vehicle, if
necessary.

6-11
06
Smart key precautions
The smart key will not work if any of the
following occur:
• The smart key is close to a radio
transmitter such as a radio station,
military area, police station,
government offices, broadcasting
stations, transmission towers, port or
an airport which can interfere with
normal operation of the smart key.
• The smart key is near a mobile two
way radio system or a cellular phone.
• The smart key is close to a metal
product or coins
• Another vehicle’s smart key is being
operated close to your vehicle.
• When you connect an external device
to the multi-purpose socket or USB
port and place it near the smart key,
the smart key may not be recognized/
work in some areas of the vehicle. In
this case, try moving the smart key to
another location to start the engine or
press the start button directly with the
smart key to start the engine.
In the following situations, the frequency
band from the smart key may be mixed
with a different frequency, which may
cause smart key malfunction (engine
operation, door lock function, etc.) or
the working distance of smart key may
change.
• The smart key is placed near the
electronic systems (woofer, cellular
phone, portable wired/wireless
charger, electric heating device,
electronic power bank, e-cigarettes,
etc.)
When the smart key does not work
correctly, open and close the door
with the mechanical key. If you have
a problem with the smart key, it is
recommended that you contact an
authorized HYUNDAI dealer.
If the smart key is in close proximity to
your mobile phone, the signal could be
blocked by your mobile phones normal
operational signals. This is especially
important when the phone is active
such as making and receiving calls, text
messaging, and/or sending/receiving
emails. Avoid placing the smart key and
your mobile phone in the same pants or
jacket pocket and always try to maintain
an adequate distance between the two
devices.
i Information
Changes or modifications not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate the equipment. If the
keyless entry system is inoperative due
to changes or modifications not expressly
approved by the party responsible for
compliance, it will not be covered by your
manufacturer’s vehicle warranty.
NOTICE
Keep the smart key away from
electromagnetic materials that blocks
electromagnetic waves to the key
surface.

6-12
Convenient features
Battery replacement
OLF044008OLF044008
If the Smart Key is not working properly,
try replacing the battery with a new one.
Battery Type: CR2032
To replace the battery:
1. Pry open the rear cover of the smart
key.
2. Remove the old battery and insert the
new battery. Make sure the battery
position is correct.
3. Reinstall the rear cover of the smart
key.
If you suspect your smart key might
have sustained some damage, or you
feel your smart key is not working
correctly, it is recommended that you
contact an authorized HYUNDAI dealer.
i Information
An inappropriately disposed
battery can be harmful to the
environment and human
health. Dispose the battery
according to your local law(s)
and regulation.
Immobilizer system
The immobilizer system protects your
vehicle from theft. If an improperly
coded key (or other device) is used, the
engine’s fuel system is disabled.
When the ignition switch is placed in
the ON position, the immobilizer system
indicator should come on briefly, then
go off. If the indicator starts to blink, the
system does not recognize the coding of
the key.
Place the ignition switch to the LOCK/
OFF position, then place the ignition
switch to the ON position again.
The system may not recognize your
key’s coding if another immobilizer key
or other metal object (i.e., key chain) is
near the key. The engine may not start
because the metal may interrupt the
transponder signal from transmitting
normally.
If the system repeatedly does not
recognize the coding of the key, it is
recommended that you contact your
HYUNDAI dealer.
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle inoperable.

6-13
06
WARNING
In order to prevent theft of your
vehicle, do not leave spare keys
anywhere in your vehicle. Your
immobilizer password is a customer
unique password and should be kept
confidential.
NOTICE
The transponder in your key is an
important part of the immobilizer
system. It is designed to give years
of trouble-free service, however you
should avoid exposure to moisture,
static electricity and rough handling.
Immobilizer system malfunction could
occur.
MT (Manual Transmission)
Remote start function
(if equipped)
Remote Engine Start allows you to start
your vehicle engine remotely from your
convenient place by Mobile (Blue Link
Application).
The following conditions must be met
for a vehicle to start remotely:
• All the vehicle doors including tailgate
and hood must be closed and Locked.
OAI3069006OAI3069006
• Verify that the parking brake lever
should be pulled above 5 notches,
Notch can be detected as the click
sound when parking brake lever
operating.
OIB054001OIB054001
• Gear shift lever must be in ‘N’ position.

6-14
Convenient features
• Vehicle should be parked on a flat
surface.
• Smart Key (FOB) should not be placed
inside the vehicle.
Remote Engine Start will not
operate:
1. If gear position is other than ‘N’
2. If the parking brake position is less
than 5th notch condition
3. If vehicle is parked on a hill or an
inclination road(not on flat area)
4. If vehicle battery is low.
CAUTION
For remote start operation in Manual
Transmission, vehicle must be parked
on a flat surface.
Door lock/unlock sound
When a user steps out of the car, all
doors are closed and then the user tries
to lock or unlock the car with the remote
key or smart key, sound occurs along
with flashing.
• Door Lock beep sound : 1time
• Door Unlock beep sound : 2times
Lock/Unlock Sound Function
Disable / Enable:
The user can disable or enable the lock/
unlock sound using the remote key or
smart key.
• Default condition : Sound is Enabled
(ON)
- Sound Disable : User must press
both lock and unlock buttons in the
remote key or smart key together for
at least 4seconds to deactivate the
sound (from “ON  OFF”).
- Sound Enable : User must press
both lock and unlock buttons in the
remote key or smart key together for
at least 4seconds to activate Sound
(from “ OFF  ON”).
• For a successful Activation/
De-activation of Sound, Hazard
warning lights will blink 4 times.

6-15
06
DOOR LOCKS
Operating door locks from
outside the vehicle
Mechanical key
OBI3050002OBI3050002
Turn the key toward the rear of the
vehicle to unlock and toward the front of
the vehicle to lock.
If you lock/unlock the driver’s door with
a key, all vehicle doors will lock/unlock
automatically. (If equipped with the
central door lock system)
Once the doors are unlocked, they may
be opened by pulling the door handle.
When closing the door, push the door by
hand. Make sure that doors are closed
securely.
Remote key
OQXI049004OQXI049004
To lock the doors, press the Door Lock
button (1) on the remote key.
To unlock the doors, press the Door
Unlock button (2) on the remote key.
Once the doors are unlocked, they may
be opened by pulling the door handle.
When closing the door, push the door by
hand. Make sure that doors are closed
securely.
i Information
• In cold and wet climates, door lock
and door mechanisms may not work
properly due to freezing conditions.
• If the door is locked/unlocked multiple
times in rapid succession with either
the vehicle key or door lock switch, the
system may stop operating temporarily
in order to protect the circuit and
prevent damage to system components.

6-16
Convenient features
Smart key
OAI3059062OAI3059062
1. Door lock
2. Door unlock
To lock the doors, press the button on
the outside door handle while carrying
the smart key with you or press the door
lock button on the smart key.
To unlock the doors, press the button on
the outside door handle while carrying
the smart key with you or press the door
unlock button on the smart key.
Once the doors are unlocked, they may
be opened by pulling the door handle.
When closing the door, push the door by
hand. Make sure that doors are closed
securely.
i Information
• In cold and wet climates, door lock
and door mechanisms may not work
properly due to freezing conditions.
• If the door is locked/unlocked multiple
times in rapid succession with either
the vehicle key or door lock switch, the
system may stop operating temporarily
in order to protect the circuit and
prevent damage to system components.

6-17
06
Operating door locks from
inside the vehicle
With the door lock button
OBI3050003OBI3050003
• To unlock a door, push the door lock
button (1) to the “Unlock” position.
• To lock a door, push the door lock
button (1) to the “Lock” position.
• To open a door, pull the door handle
(2) outward.
• If the inner door handle of the driver’s
door is pulled when the door lock
button is in the lock position, the
button is unlocked and door opens.
• Front doors cannot be locked if the
key is in the ignition switch and any
front door is open.
• Doors cannot be locked if the smart
key is in the vehicle and any door is
open.
i Information
If a power door lock ever fails to function
while you are in the vehicle try one or
more of the following techniques to exit:
Operate the door unlock feature
repeatedly (both electronic and manual)
while simultaneously pulling on the door
handle.
Operate the other door locks and handles,
front and rear.
Lower a front window and use the
mechanical key to unlock the door from
outside.

6-18
Convenient features
With the central door lock/unlock
switch
OBI3050004OBI3050004
When pressing the () portion (1) of the
switch, all vehicle doors will lock.
• If the key is in the ignition switch and
any door is opened, the doors will not
lock even though the lock button (1) of
the central door lock switch is pressed.
• If the smart key is in the vehicle and
any door is opened, the doors will not
lock even though the lock button (1) of
the central door lock switch is pressed.
When pressing the (
) portion (2) of the
switch, all vehicle doors will unlock.
WARNING
• The doors should always be fully
closed and locked while the vehicle is
in motion. If the doors are unlocked,
the risk of being thrown from the
vehicle in a crash is increased.
• Do not pull the inner door handle of
the driver’s or passenger’s door while
the vehicle is moving.
WARNING
Do not leave children or animals
unattended in your vehicle. An
enclosed vehicle can become
extremely hot, causing death or serious
injury to unattended children or
animals who cannot escape the vehicle.
Children might operate features of the
vehicle that could injure them, or they
could encounter other harm, possibly
from someone gaining entry to the
vehicle.
WARNING
Always secure your vehicle
Leaving your vehicle unlocked
increases the potential risk to you or
others from someone hiding in your
vehicle.
To secure your vehicle, while
depressing the brake, move the shift
lever to the P (Park) position (for
Intelligent Manual Transmission) or
first gear or R (Reverse, for manual
transmission), engage the parking
brake, and place the ignition switch
in the LOCK/OFF position, close all
windows, lock all doors, and always
take the key with you.