lock HYUNDAI I20 2021 User Guide
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2021, Model line: I20, Model: HYUNDAI I20 2021Pages: 444, PDF Size: 8.93 MB
Page 46 of 444

4-13
04
1. Set the front seatback to the upright
position and if necessary, slide the
front seat forward.
2. Lower the rear headrests to the lowest
position (if equipped with adjustable
headrests).
OAI3039010OAI3039010
3. Insert the rear lap/shoulder belt plate
into the holder on the side trim. It will
prevent the lap/shoulder belt from
interfering with the seatback when
folding.
OAI3039011OAI3039011
OBI3030003OBI3030003
4. Pull up both sides of the seatback
lever and fold the seatback toward the
front of the vehicle.
To use the rear seat, lift and push up the
seatback backward. Push the seatback
firmly until it clicks into place. Make sure
the seatback is locked in place.
When returning the rear seatbacks to
the upright position, remember to return
the rear shoulder belts to their proper
position.
i Information
If you are not able to pull out the seat belt
from the retractor, firmly pull the belt out
and release it. Then you will be able to
pull the belt out smoothly.
Page 47 of 444

4-14
Safety system
WARNING
When you return the rear seatback to
its upright position after being folded
down:
Be careful not to damage the seat belt
webbing or buckle. Do not allow the
seat belt webbing or buckle to get
caught or pinched in the rear seat.
Ensure that the seatback is completely
locked into its upright position by
pushing on the top of the seatback.
Otherwise, in an accident or sudden
stop, the seat could fold down and
allow cargo to enter the passenger
compartment, which could result in
serious injury or death.
NOTICE
• When returning the rear seatbacks
to the upright position, remember to
return the rear shoulder belts to their
proper position.
• Routing the seat belt webbing
through the rear seat belt guides will
help keep the seat belts from being
trapped behind or under the seats.
WARNING
Cargo
Cargo should always be secured to
prevent it from being thrown about the
vehicle in a collision and causing injury
to the vehicle occupants. Do not place
objects in the rear seats, since they
cannot be properly secured and may hit
the front seat occupants in a collision.
WARNING
Cargo loading
Make sure the engine is off, the
Intelligent variable transmission is in P
(Park) or the Manual transmission is in R
(Reverse) or 1st, and the parking brake
is securely applied whenever loading or
unloading cargo. Failure to take these
steps may allow the vehicle to move if
the shift lever is inadvertently moved to
another position.
Page 50 of 444

4-17
04
i Information
•You can find the front passenger’s seat
belt warning light on the cluster.
• Although the front passenger seat is not
occupied, the seat belt warning light
will blink or illuminate for 6 seconds.
• The front passenger’s seat belt warning
may operate when luggage is placed on
the front passenger seat.
Lap/shoulder belt
OHSS038101OHSS038101
To fasten your seat belt:
To fasten your seat belt, pull it out of
the retractor and insert the metal tab
(1) into the buckle (2). There will be an
audible “click” when the tab locks into
the buckle.
OHSS038100OHSS038100
You should place the lap belt (1) portion
across your hips and the shoulder belt
(2) portion across your chest.
The seat belt automatically adjusts to
the proper length only after the lap belt
portion is adjusted manually so that it
fits snugly around your hips. If you lean
forward in a slow, easy motion, the belt
will extend and let you move around.
If there is a sudden stop or impact,
however, the belt will lock into position.
It will also lock if you try to lean forward
too quickly.
i Information
If you are not able to pull out the safety
belt from the retractor, firmly pull the
belt out and release it. After release, you
will be able to pull the belt out smoothly.
Page 51 of 444

4-18
Safety system
WARNING
Improperly positioned seat belts may
increase the risk of serious injury
in an accident.Take the following
precautions when adjusting the seat
belt:
• Position the lap portion of the seat
belt as low as possible across your
hips, not on your waist, so that it
fits snugly.This allows your strong
pelvic bones to absorb the force of
the crash, reducing the chance of
internal injuries.
• Position one arm under the shoulder
belt and the other over the belt, as
shown in the illustration.
• Always position the shoulder belt
anchor into the locked position at the
appropriate height.
• Never position the shoulder belt
across your neck or face.
OHSS038102OHSS038102
WARNING
You should place the lap belt portion
as low as possible and snugly across
your hips, not on your waist. If the lap
belt is located too high on your waist, it
may increase the chance of injury in the
event of a collision. Both arms should
not be under or over the belt. Rather,
one should be over and the other
under, as shown in the illustration.
Never wear the seat belt under the arm
nearest the door.
Page 52 of 444

4-19
04
OHSS038103OHSS038103
To release the seat belt:
The seat belt is released by pressing
the release button (1) in the locking
buckle. When it is released, the belt
should automatically draw back into the
retractor.
If this does not happen, check the belt to
be sure it is not twisted, then try again.
Lap belt
OHSS038003/HOHSS038003/H
To fasten your seat belt:
To fasten a 2-point static type belt, insert
the metal tab into the locking buckle.
There will be an audible “click” when the
tab locks into the buckle. Check to make
sure the belt is properly locked and that
the belt is not twisted.
OHSS038004OHSS038004
With a 2-point static type seat belt, the
length must be adjusted manually so it
fits snugly around your body. Fasten the
belt and pull on the loose end to tighten.
The belt should be placed as low as
possible on your hips, not on your waist.
If the belt is too high, it could increase
the possibility of your being injured in an
accident.
Page 53 of 444

4-20
Safety system
OAI3039015OAI3039015
When using the rear center seat belt, the
buckle with the “CENTER” mark must be
used.
OHSS038005/HOHSS038005/H
To release the seat belt:
When you want to release the seat
belt, press the button (1) in the locking
buckle.
WARNING
The center lap belt latching mechanism
is different from those for the rear seat
shoulder belts. When fastening the rear
seat shoulder belts or the center lap
belt, make sure they are inserted into
the correct buckles to obtain maximum
protection from the seat belt system
and assure proper operation.
Pre-tensioner seat belt
(if equipped)
OIB034039OIB034039
Your vehicle is equipped with driver’s
and front passenger’s pre-tensioner
seat belts (retractor pre-tensioner).The
purpose of the pre-tensioner is to make
sure the seat belts fit tightly against the
occupant’s body in certain frontal or
side collision(s). The pre-tensioner seat
belts may be activated in crashes where
the frontal or side collision(s) is severe
enough, together with the air bags.
When the vehicle stops suddenly, or if
the occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position. In certain frontal collisions,
the pre-tensioner will activate and pull
the seat belt into tighter contact against
the occupant’s body.
WARNING
For your safety, be sure that the belt
webbing is not loose or twisted and
always sit properly on your seat.
Page 59 of 444

4-26
Safety system
WARNING
To reduce the chance of serious or fatal
injuries:
• Children of all ages are safer when
restrained in the rear seat. A child
riding in the front passenger seat can
be forcefully struck by an inflating
air bag resulting in serious or fatal
injuries.
• Always follow the instructions for
installation and use of the child
restraint maker.
• Always make sure the child seat is
secured properly in the car and your
child is securely restrained in the
child seat.
• Never hold a child in your arms or lap
when riding in a vehicle. The violent
forces created during a crash will tear
the child from your arms and throw
the child against the car’s interior.
• Never put a seat belt over yourself
and a child. During a crash, the
belt could press deep into the child
causing serious internal injuries.
• Never leave children unattended
in a vehicle - not even for a short
time. The car can heat up very
quickly, resulting in serious injuries
to children inside. Even very young
children may inadvertently cause the
vehicle to move, entangle themselves
in the windows, or lock themselves or
others inside the vehicle.
• Never allow two children, or any two
persons, to use the same seat belt.• Children often squirm and reposition
themselves improperly. Never let
a child ride with the shoulder belt
under their arm or behind their back.
Always properly position and secure
children in rear seat.
• Never allow a child to stand-up or
kneel on the seat or floorboard of a
moving vehicle. During a collision
or sudden stop, the child can be
violently thrown against the vehicles
interior, resulting in serious injury.
• Never use an infant carrier or a
child safety seat that “hooks” over
a seatback, it may not provide
adequate security in an accident.
• Seat belts can become very hot,
especially when the car is parked in
direct sunlight. Always check seat
belt buckles before fastening them
over a child.
• After an accident, we recommend
that the system be checked by an
authorized HYUNDAI dealer.
• If there is not enough space to place
the child restraint system because
of the driver’s seat, install the child
restraint system in the rear right seat.
Page 68 of 444

4-35
04
MMSA3030MMSA3030
3. Buckle the seat belt and allow the
seat belt to take up any slack. After
installation of the child restraint
system, try to move it in all directions
to be sure the child restraint system is
securely installed.
If you need to tighten the belt, pull more
webbing toward the retractor. When you
unbuckle the seat belt and allow it to
retract, the retractor will automatically
revert back to its normal seated
passenger emergency locking usage
condition.