Gears HYUNDAI I20 2023 User Guide

6-34
Driving your vehicle
Good driving practices

[Never move the shift lever from P
(Park) or N (Neutral) to any other
position with the accelerator pedal
depressed.

[Never move the shift lever into P
(Park) when the vehicle is in motion.
Be sure the vehicle is completely
stopped before you attempt to shift
into R (Reverse) or D (Drive).

[Do not move the shift lever to N
(Neutral) when driving. Doing so may
result in an accident because of a loss
of engine braking and the transmission
could be damaged.

[Driving uphill or downhill, always shift
to D (Drive) when driving forward or to
R (Reverse) when driving backwards,
and check the gear position indicated
on the cluster before driving. If you
drive in the opposite direction of the
selected gear, the engine will turn
off and a serious accident might be
occurred due to the degraded brake
performance.

[Do not drive with your foot resting
on the brake pedal. Even light, but
consistent pedal pressure can result
in the brakes overheating, brake wear
and possibly even brake failure.

[When driving in manual shift mode,
slow down before shifting to a lower
gear. Otherwise, the lower gear may
not be engaged if the engine rpms are
outside of the allowable range.

[Always apply the parking brake when
leaving the vehicle. Do not depend on
placing the transmission in P (Park) to
keep the vehicle from moving.

[Exercise extreme caution when driving
on a slippery surface. Be especially
careful when braking, accelerating or
shifting gears. On a slippery surface,
an abrupt change in vehicle speed can
cause the drive wheels to lose traction
and may cause loss of vehicle control
resulting in an accident.
[Optimum vehicle performance
and fuel economy is obtained by
smoothly depressing and releasing the
accelerator.
WARNING
To reduce the risk of SERIOUS INJURY
or DEATH:

[ALWAYS wear your seat belt. In a
collision, an unbelted occupant
is significantly more likely to be
seriously injured or killed than a
properly belted occupant.

[Avoid high speeds when cornering or
turning.

[Do not make quick steering wheel
movements, such as sharp lane
changes or fast, sharp turns.

[The risk of rollover is greatly
increased if you lose control of your
vehicle at highway speeds.

[Loss of control often occurs if two or
more wheels drop off the roadway
and the driver over steers to reenter
the roadway.

[In the event your vehicle leaves
the roadway, do not steer sharply.
Instead, slow down before pulling
back into the travel lanes.

[HYUNDAI recommends you follow all
posted speed limits.
i Information- Kickdown
Mechanism (if equipped)
8VHWKHNLFNGRZQPHFKDQLVPIRU
PD[LPXPDFFHOHUDWLRQ'HSUHVVWKH
DFFHOHUDWRUSHGDOEH\RQGWKHSUHVVXUH
SRLQW7KHDXWRPDWLFWUDQVPLVVLRQZLOO
VKLIWWRDORZHUJHDUGHSHQGLQJRQWKH
HQJLQHVSHHG

6-58
Driving your vehicle
Hazardous driving conditions
When hazardous driving elements are
encountered such as water, snow,
ice, mud and sand, take the following
precautions:

[Drive cautiously and maintain a longer
braking distance.

[Avoid abrupt braking or steering.

[When your vehicle is stuck in snow,
mud, or sand, use the second
gear. Accelerate slowly to avoid
unnecessary wheel spin.

[Put sand, rock salt, tyre chains or
other non-slip materials under the
wheels to provide additional traction
whilst the vehicle becomes stuck in
ice, snow, or mud.
WARNING
Downshifting with an Automatic
transmission, whilst driving on slippery
surfaces can cause an accident. The
sudden change in tyre speed could
cause the tyres to skid. Be careful when
downshifting on slippery surfaces.
Rocking the vehicle
If it is necessary to rock the vehicle to
free it from snow, sand, or mud, first
turn the steering wheel right and left to
clear the area around your front wheels.
Then, shift back and forth between the
1st gear and R (Reverse, for manual
transmission vehicle) or R (Reverse)
and a forward gear (for Automatic
transmission vehicle/Dual clutch
transmission vehicle).
Try to avoid spinning the wheels, and do
not race the engine.
To prevent transmission wear, wait until
the wheels stop spinning before shifting
gears. Release the accelerator pedal
whilst shifting, and press lightly on the
accelerator pedal whilst the transmission
is in gear. Slowly spinning the wheels in
forward and reverse directions causes
a rocking motion that may free the
vehicle.
WARNING
If the vehicle is stuck and excessive
wheel spin occurs, the temperature
in the tyres can increase very quickly.
If the tyres become damaged, a tyre
blow out or tyre explosion can occur.
This condition is dangerous - you and
others may be injured. Do not attempt
this procedure if people or objects are
anywhere near the vehicle.
If you attempt to free the vehicle, the
vehicle can overheat quickly, possibly
causing an engine compartment fire or
other damages. Try to avoid spinning
the wheels as much as possible to
prevent overheating of either the tyres
or the engine. DO NOT allow the vehicle
to spin the wheels above 35 mph (56
km/h).
i Information
7KH(6&V\VWHPLIHTXLSSHG PXVWEH
WXUQHG2))EHIRUHURFNLQJWKHYHKLFOH
63(&,$/'5,9,1*&21',7,216

Driver assistance system
7-158
OBC3070103TU
7. Parking complete
(1) Complete parking your vehicle by
following the instructions on the
cluster. If required, manually control
the steering wheel and complete
parking your vehicle.
(2) When using perpendicular reverse
parking, Parking Assist will complete
parking the vehicle without
completely entering the parking
space, considering stoppers, etc.
in the parking space. If necessary,
manually complete parking your
vehicle.
How to turn off Parking mode whilst
operating

[Press and hold the Parking/View ()
button in the following stage:
- Searching for parking space
- Select parking mode and type

[Press the Parking/View (
) button or
Parking Safety () button whilst the
steering wheel is being controlled.
Parking mode will cancel in the fol-
lowing conditions:

[When searching for parking space
- Shifting the gear to R (Reverse)
- The vehicle is above 18 mph (30
km/h)
- The parking space is narrow
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- ABS, TCS or ESC system operates
due to slippery road conditions

[When the steering wheel is being
controlled
- The steering wheel is steered
- Approximately 6 minutes have
passed after the steering wheel has
been controlled
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- ABS, TCS or ESC system operates
due to slippery road conditions

07
7-163
How to turn off Exit mode whilst
operating

[Press the Parking/View () button or
Parking Safety () button.
Exit mode will cancel in the following
conditions:

[ When checking space to exit
- Shifting the gear to R (Reverse)
- The vehicle moves
- Not enough space to exit
- An object is detected within 2mm (79
in.) in the direction of exit
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- ABS, TCS or ESC system operates
due to slippery road conditions

[When the steering wheel is being
controlled
- The steering wheel is steered
- Approximately 6 minutes have
passed after the steering wheel has
been controlled
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- ABS, TCS or ESC system operates
due to slippery road conditions
OBC3070104TU
Additional instructions (messages)
When Parking Assist is operating, a
message may appear regardless of the
operating order. The messages will
appear according to the circumstances.
Follow the instructions provided whilst
using Parking Assist.
WARNING

[Always check surroundings for
pedestrians, animals or objects
before taking your foot off the brake
pedal.

[If the vehicle does not move even
though the brake pedal is not
depressed, check the surroundings
before depressing the accelerator
pedal.

[ If it is determined that the space is
too small when the vehicle is being
controlled to exit, Exit mode will be
canceled.