brake sensor HYUNDAI I20 2023 User Guide

Driver assistance system
7-100
OBC3070011
In the following cases, the vehicle
in front cannot be detected by the
sensor:
- Vehicles with higher ground
clearance or vehicles carrying loads
that stick out of the back of the
vehicle
- Vehicles that has the front lifted due
to heavy loads
- You are steering your vehicle
- Driving on narrow or sharply curved
roads
Adjust your vehicle speed by
depressing the brake pedal according
to the road and driving conditions
ahead.
OJX1070293R

[When a vehicle ahead disappears
at an intersection, your vehicle may
accelerate.
Always pay attention to road and
driving conditions whilst driving.
OJX1070294R

[When a vehicle in front of you merges
out of the lane, Smart Cruise Control
may not immediately detect the new
vehicle that is now in front of you.
Always pay attention to road and
driving conditions whilst driving.
OTM058124

[Always look out for pedestrians when
your vehicle is maintaining a distance
with the vehicle ahead.

07
7-131
Rear Cross-Traffic Collision-
Avoidance Assist disabled
OTM070124L
When the rear bumper around the rear-
side radar or sensor is covered with
foreign material, such as snow or rain,
or installing a trailer or carrier, it can
reduce the detecting performance and
temporarily limit or disable Rear Cross-
Traffic Safety system.
If this occurs, the ‘Rear cross-traffic
VDIHW\IXQFWLRQVGLVDEOHG5DGDUEORFNHG
T
warning message will appear on the
cluster.
The function will operate normally when
such foreign material or trailer, etc. is
removed.
If the function does not operate normally
after it is removed, we recommend that
the function be inspected by a HYUNDAI
authorised repairer.
WARNING

[Even though the warning message
does not appear on the cluster, Rear
Cross-Traffic Safety system may not
operate properly.

[Rear Cross-Traffic Safety system may
not operate properly in an area (for
example: open terrain), where any
substance are not detected after
turning ON the engine.
CAUTION
Turn off Rear Cross-Traffic Safety
system to install a trailer, carrier, etc.,
or remove the trailer, carrier, etc. to use
Rear Cross-Traffic Safety system.
Limitations of Rear Cross-Traffic
Collision-Avoidance Assist
Rear Cross-Traffic Safety system may
not operate normally, or the function
may operate unexpectedly under the
following circumstances:

[Departing from where trees or grass
are overgrown

[Departing from where roads are wet

[Speed of the approaching vehicle is
fast or slow
%UDNLQJFRQWUROPD\QRWZRUNGULYHU
TV
attention is required in the following
circumstances:

[The vehicle severely vibrates whilst
driving over a bumpy road, uneven
road or concrete patch

[Driving on a slippery surface due to
snow, water puddle, ice, etc.

[The tyre pressure is low or a tyre is
damaged

[The brake is reworked

[Parking Assist is operating
(if equipped)

07
7-145
Reverse Parking Collision-
Avoidance Assist operation
Operating conditions
,I
S$FWLYHDVVLVW
TRU
S:DUQLQJRQO\
TLVVHW
from the Settings menu, Reverse Parking
Collision-Avoidance Assist will be in
the ready status when the following
conditions are satisfied:
- The tailgate is closed
- The gear is shifted to R (Reverse)
- The vehicle is below 6 mph (10 km/h)
- Function components such as the rear
view camera and the rear ultrasonic
sensors are in normal conditions
When Reverse Parking Collision-
Avoidance Assist activates, a line
appears behind the vehicle image in the
instrument cluster.
Reverse Parking Collision-Avoidance
Assist operates only once after the gear
is shifted to R (Reverse). To reactivate
Reverse Parking Collision-Avoidance
Assist, shift the gear from another gear
to R (Reverse).
OBC3070113TU
Active assist

[If the function detects a risk of
collision with a pedestrian or an
object, the function will warn the
driver with an audible warning,
steering wheel vibration (if equipped)
and warning message on the cluster.
When Rear View Monitor is operating,
a warning will appear on the
infotainment system screen.

[If the function detects an imminent
collision with a pedestrian or an object
behind the vehicle, the function will
assist you with braking. The driver
needs to pay attention as the brake
assist will end within 2 seconds. The
driver must immediately depress
the brake pedal and check vehicle
surroundings.

[Brake control will end when:
- The gear is shifted to P (Park) or D
(Drive).
- The driver depresses the brake pedal
with sufficient power
- Braking assist has last for
approximately 2 seconds

[The warning will turn off when:
- The driver shifts the gear to P (Park),
N (Neutral) or D (Drive)

[The brake control may not operate
properly depending on the status of
ESC (Electronic Stability Control).
There will only be a warning when:
- The ESC (Electronic Stability Control)
warning light is on
- ESC (Electronic Stability Control) is
engaged in a different function

07
7-147
„Rear view camera„Rear ultrasonic sensor
OBC3070061OBC3070058
7KH
S5HDUFDPHUDHUURURUEORFNDJH
T
RU
S3DUNLQJVHQVRUHUURURUEORFNDJH
T
warning message will appear on the
cluster if the following situations occur:
- The rear view camera is covered with
foreign material, such as snow or rain,
etc.
- There is inclement weather, such as
heavy snow, heavy rain, etc.
If this occurs, Reverse Parking Collision-
Avoidance Assist may turn off or may
not operate properly. Check whether
the rear view camera and rear ultrasonic
sensors are clean.
Limitations of Reverse Parking
Collision-Avoidance Assist
Reverse Parking Collision-Avoidance
Assist may not assist braking or warn
the driver even if there are pedestrians
or objects under the following
circumstances:

[Any non-factory equipment or
accessory is installed

[Your vehicle is unstable due to an
accident or other causes

[Bumper height or rear ultrasonic
sensor installation has been modified

[Rear view camera or rear ultrasonic
sensor(s) is damaged

[Rear view camera or the rear
ultrasonic sensor(s) is stained with
foreign material, such as snow, dirt,
etc.

[Rear view camera is obscured by a
light source or by inclement weather,
such as heavy rain, fog, snow, etc.

[The surrounding is very bright or very
dark

[Outside temperature is very high or
very low

[The wind is either strong (above
12 mph (20 km/h)) or blowing
perpendicular to the rear bumper

[Objects generating excessive noise,
such as vehicle horns, loud motorcycle
engines or truck air brakes, are near
your vehicle

[An ultrasonic sensor with similar
frequency is near your vehicle

[There is ground height difference
between the vehicle and the
pedestrian

[The image of the pedestrian in the rear
view camera is indistinguishable from
the background

Driver assistance system
7-148

[The pedestrian is near the rear edge of
the vehicle

[The pedestrian is not standing upright

[The pedestrian is either very short or
very tall for the function to detect

[The pedestrian or cyclist is wearing
clothing that easily blends into the
background, making it difficult to
detect

[The pedestrian is wearing clothing that
does not reflect ultrasonic waves well

[Size, thickness, height, or shape of
the object does not reflect ultrasonic
waves well (e.g., pole, bush, curbs,
carts, edge of a wall, etc.)

[The pedestrian or the object is moving

[The pedestrian or the object is very
close to the rear of the vehicle

[A wall is behind the pedestrian or the
object

[The object is not located at the rear
centre of your vehicle

[The object is not parallel to the rear
bumper

[The road is slippery or inclined

[The driver backs up the vehicle
immediately after shifting to R
(Reverse)

[The driver accelerates or circles the
vehicleReverse Parking Collision-Avoidance
Assist may unnecessarily warn the driver
or assist with braking even if there are
no pedestrians or objects under the
following circumstances:

[Any non-factory equipment or
accessory is installed

[Your vehicle is unstable due to an
accident or other causes

[Bumper height or rear ultrasonic
sensor installation has been modified

[Your vehicle height is low or high
due to heavy loads, abnormal tyre
pressure, etc.

[Rear view camera or the rear
ultrasonic sensor(s) is stained with
foreign material, such as snow, dirt,
etc.

[The pattern on the road is mistaken for
a pedestrian

[There is shadow or light reflecting on
the ground

[Pedestrians or objects are around the
path of the vehicle

[Objects generating excessive noise,
such as vehicle horns, loud motorcycle
engines or truck air brakes, are near
your vehicle

[Your vehicle is backing towards a
narrow passage or parking space

[Your vehicle is backing towards an
uneven road surface, such as an
unpaved road, gravel, bump, gradient,
etc.

[A trailer or carrier is installed on the
rear of your vehicle

[An ultrasonic sensor with similar
frequency is near your vehicle

07
7-149
WARNING
Take the following precautions when
using Reverse Parking Collision-
Avoidance Assist:

[Always pay extreme caution whilst
driving. The driver is responsible for
controlling the brake for safe driving.

[Always pay attention to road and
traffic conditions whilst driving,
whether or not there is a warning.

[Always look around your vehicle to
make sure there are no pedestrians
or objects before moving the vehicle.

[The performance of Reverse Parking
Collision-Avoidance Assist may
vary under certain conditions. If
the vehicle speed is above 2 mph
(4 km/h), the function will provide
collision avoidance assist only when
pedestrians are detected. Always
look around and pay attention when
backing up your vehicle.

[Some objects may not be detected by
the rear ultrasonic sensors due to the
objects distance, size or material, all
of which can limit the effectiveness
of the sensor.

[Reverse Parking Collision-Avoidance
Assist may not operate properly
or may operate unnecessarily
depending on the road conditions
and the surroundings.

[Do not solely rely on the function.
Doing so may lead to vehicle damage
or injuries.
CAUTION

[Noise may be heard when sudden
braking occurs to avoid a collision.

[If any other warning sound such
as the seat belt warning chime is
already generated, Reverse Parking
Collision-Avoidance Assist warning
may not sound.

[The function may not work properly
if the bumper has been damaged,
replaced or repaired.

[Reverse Parking Collision-Avoidance
Assist may not operate normally if
interfered by strong electromagnetic
waves.

[Playing the vehicle audio system at
high volume may prevent passengers
from hearing Reverse Parking
Collision-Avoidance Assist warning
sounds.

[Turn off Reverse Parking Collision-
Avoidance Assist when towing a
trailer. If towing and moving in
reverse, Reverse Parking Collision-
Avoidance Assist will activate as it
detects the trailer.

07
7-161
OBC3070118TU
3. Checking space
(1) When the vehicle is parked parallel,
the vehicle sensors will detect the
distance from nearby objects and
check for space to exit.

[If the front or rear vehicle (or object) is
too near, the function will not be able
to search for space, and will turn off.

[Parking Assist may not be able to
search for space even if there is space
to leave, and the function may search
for a space that is not suitable for
the vehicle to leave in the following
circumstances:
- The ultrasonic sensor is frozen or
dirty
- There are objects located high or low
- There are pillars around the parking
space
- The parked vehicle has objects
attached to the bumper such as
bumper guard, trailer hitch, etc. OBC3070100TU/OBC3070102TU
OBC3070101TU/OBC3070099TU
4. Steering wheel control
(1) Shift the gear to D (Drive) or R
(Reverse) according to the message
on the cluster.
(2) Parking Assist will start to control the
steering wheel.
- If the steering wheel is held tight,
Parking Assist will be cancelled.
(3) Take your foot off the brake pedal
and drive forward or in reverse
according to the message on the
cluster.

8-15
08
If the indicators do not extinguish after
a few minutes, it is recommended to
contact the nearest authorised HYUNDAI
dealer.
Each wheel is equipped with a tyre
pressure sensor mounted inside the tyre
behind the valve stem (except for the
spare tyre). You must use TPMS specific
wheels. It is recommended that you
always have your tyres serviced by a
HYUNDAI authorised repairer.
You may not be able to identify a tyre
with low pressure by simply looking at it.
Always use a good quality tyre pressure
gauge to measure. Please note that a
tyre that is hot (from being driven) will
have a higher pressure measurement
than a tyre that is cold.
A cold tyre means the vehicle has been
sitting for 3 hours and driven for less
than 1 mile (1.6 km) in that 3 hour period.
Allow the tyre to cool before measuring
the inflation pressure. Always be sure
the tyre is cold before inflating to the
recommended pressure.
WARNING

[The TPMS cannot alert you to severe
and sudden tyre damage caused by
external factors such as nails or road
debris.

[If you feel any vehicle instability,
immediately take your foot off
the accelerator, apply the brakes
gradually with light force, and slowly
move to a safe position off the road.
WARNING
Tampering with, modifying, or disabling
the Tyre Pressure Monitoring System
(TPMS) components may interfere
with the system’s ability to warn the
driver of low tyre pressure conditions
and/or TPMS malfunctions. Tampering
with, modifying, or disabling the Tyre
Pressure Monitoring System (TPMS)
components may void the warranty for
that portion of the vehicle.
WARNING

[Do not modify the vehicle; it may
interfere with the TPMS function.

[The wheels on the market do not
have a TPMS sensor.

[For your safety, we recommend that
you use parts for replacement from a
HYUNDAI authorised repairer.

[If you use the wheels on the market,
use a TPMS sensor approved by a
HYUNDAI dealer or the equivalent
approved for your vehicle. If your
vehicle is not equipped with a TPMS
sensor or TPMS does not work
properly, you may fail the periodic
vehicle inspection conducted in your
country.