lock HYUNDAI I20 2023 User Guide
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2023, Model line: I20, Model: HYUNDAI I20 2023Pages: 649, PDF Size: 12.35 MB
Page 47 of 649
3-10
Safety system
Rear seats (if equipped)
The rear seatbacks can be folded to
facilitate carrying long items or to
increase the luggage capacity of the
vehicle.
WARNING
[ Never allow passengers to sit on top
of the folded down seatback whilst
the vehicle is moving. This is not a
proper seating position and no seat
belts are available for use. This could
result in serious injury or death in
case of an accident or sudden stop.
[ Objects carried on the folded down
seatback should not extend higher
than the top of the front seatbacks.
This could allow cargo to slide
forward and cause injury or damage
during sudden stops.
1. Set the front seatback to the upright
position and if necessary, slide the
front seat forward.
2. Lower the rear head restraints to the
lowest position (if equipped with
adjustable head restraints).
OAI3039010
3. Insert the rear lap/shoulder belt plate
into the holder on the side trim. It will
prevent the lap/shoulder belt from
interfering with the seatback when
folding.
OAC3039006TU
OAC3039007TU
4. Pull up the seatback lever and fold
the seatback toward the front of the
vehicle.
To use the rear seat, lift and push up the
seatback backward. Push the seatback
firmly until it clicks into place. Make sure
the seatback is locked in place.
When returning the rear seatbacks to
the upright position, remember to return
the rear shoulder belts to their proper
position.
Page 48 of 649
3-11
03
WARNING
When you return the rear seatback to
its upright position after being folded
down:
Be careful not to damage the seat belt
webbing or buckle. Do not allow the
seat belt webbing or buckle to get
caught or pinched in the rear seat.
Ensure that the seatback is completely
locked into its upright position by
pushing on the top of the seatback.
Otherwise, in an accident or sudden
stop, the seat could fold down and
allow cargo to enter the passenger
compartment, which could result in
serious injury or death.
NOTICE
[ When returning the rear seatbacks
to the upright position, remember to
return the rear shoulder belts to their
proper position.
[ Routing the seat belt webbing
through the rear seat belt guides will
help keep the seat belts from being
trapped behind or under the seats.
WARNING
Cargo
Cargo should always be secured to
prevent it from being thrown about the
vehicle in a collision and causing injury
to the vehicle occupants. Do not place
objects in the rear seats, since they
cannot be properly secured and may hit
the front seat occupants in a collision.
WARNING
Cargo loading
Make sure the engine is off, the
Automatic transmission/Dual clutch
transmission is in N (Neutral) or the
Manual transmission is in R (Reverse)
or the 1st gear, and the parking brake is
securely applied whenever loading or
unloading cargo. Failure to take these
steps may allow the vehicle to move if
the shift lever is inadvertently moved to
another position.
Page 49 of 649
3-12
Safety system
Head restraint
The vehicle’s front and rear seats
have adjustable head restraints. The
head restraints provide comfort for
passengers, but more importantly they
are designed to help protect passengers
from whiplash and other neck and spinal
injuries during an accident, especially in
a rear impact collision.
WARNING
To reduce the risk of serious injury or
death in an accident, take the following
precautions when adjusting your head
restraints:
[ Always properly adjust the head
restraints for all passengers BEFORE
starting the vehicle.
[ NEVER let anyone ride in a seat
with the head restraint removed or
reversed.
[
ODN8039067L
Adjust the head restraints so the
middle of the head restraints is at the
same height as the height of the top
of the eyes.
[ NEVER adjust the head restraint
position of the driver’s seat when the
vehicle is in motion.
[ Adjust the head restraint as close to
the passenger’s head as possible. Do
not use a seat cushion that holds the
body away from the seatback.
[ Make sure the head restraint locks
into position after adjusting it.
NOTICE
To prevent damage, NEVER hit or pull
on the head restraints.
CAUTION
When there is no occupant in the rear
seats, adjust the height of the head
restraint to the lowest position. The
rear seat head restraint can reduce the
visibility of the rear area.
Page 51 of 649
3-14
Safety system
OBC3030007R
Removal/Reinstall
To remove the head restraint:
1. Recline the seatback (2) using the
seatback lever (1).
2. Raise head restraint as far as it can go.
3. Press the head restraint release button
(3) whilst pulling the head restraint up
(4).
WARNING
NEVER allow anyone to travel in a seat
with the head restraint removed.
OBC3030008R
To reinstall the head restraint :
1. Recline the seatback.
2. Put the head restraint poles (2) into
the holes whilst pressing the release
button (1).
3. Adjust the head restraint to the
appropriate height.
4. Recline the seatback (4) with the
seatback lever (3).
WARNING
Always make sure the head restraint
locks into position after reinstalling and
adjusting it properly.
Page 55 of 649
3-18
Safety system
WARNING
Rear Occupant Alert does not actually
detect objects or people in the rear
seat. By using a rear door opened and
closed history, the system informs the
driver that there may be something in
the rear seat.
CAUTION
Rear Occupant Alert uses a rear opened
and closed history.
The history is reset after the drive
turns off ignition normally, gets off the
vehicle and locks the door remotely
using the remote keyless entry. So even
if a rear door does not reopen, Rear
Occupant Alert alerts can occur.
For example, after Rear Occupant Alert
alerts occur, if the driver do not lock
the door then ride and drive again, the
alert can occur.
Page 60 of 649
3-23
03
WARNING
OTM038098R
Improperly positioned seat belts may
increase the risk of serious injury
in an accident. Take the following
precautions when adjusting the seat
belt:
[ Position the lap portion of the seat
belt as low as possible across your
hips, not on your waist, so that it
fits snugly. This allows your strong
pelvic bones to absorb the force of
the crash, reducing the chance of
internal injuries.
[ Position one arm under the shoulder
belt and the other over the belt, as
shown in the illustration.
[ Always position the shoulder belt
anchor into locked position at the
appropriate height.
[ Never position the shoulder belt
across your neck or face.
OJS038070AU
7 R U H O H D V H \ R X U V H D W E H O W
Press the release button (1) in the locking
buckle.
When it is released, the belt should
automatically draw back into the
retractor. If this does not happen, check
the belt to be sure it is not twisted, then
try again.
Page 61 of 649
3-24
Safety system
Rear centre seat belt
(if equipped)
OAC3039044TU
When using the rear centre seat belt, the
buckle with the “CENTER” mark must be
used.
i Information
If you are not able to pull out the safety
belt from the retractor, firmly pull the
belt out and release it. After release, you
will be able to pull the belt out smoothly.
Pre-tensioner seat belt
(if equipped)
OLMB033039/H
[1] : Retractor pre-tensioner seat belt
Your vehicle is equipped with driver’s
and front passenger’s Pre-tensioner
Seat Belts (Retractor Pre-tensioner). The
purpose of the pre-tensioner is to make
sure the seat belts fit tightly against the
occupant’s body in certain frontal or
side collision(s). The pre-tensioner seat
belts may be activated in crashes where
the frontal or side collision(s) is severe
enough, together with the air bags.
When the vehicle stops suddenly, or if
the occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position.
In certain frontal collisions, the pre-
tensioner will activate and pull the seat
belt into tighter contact against the
occupant’s body.
If the system senses excessive tension
on the driver or passenger’s seat
belt when the pre-tensioner system
activates, the load limiter inside the
retractor pre-tensioner will release some
of the pressure on the affected seat belt
(if equipped with load limiter).
Page 80 of 649
3-43
03
Where are the air bags?
Driver’s and passenger’s air bags (if
equipped)
OBC3030019R
„Driver’s front air bag
„Passenger's front air bag
OBC3030020R
Your vehicle is equipped with a
Supplemental Restraint System (SRS)
and lap/shoulder belts at both the driver
and passenger seating positions.
The SRS consists of air bags which are
located in the centre of the steering
wheel and the passenger’s side front
panel pad above the glove box. The air
bags are labelled with the letters “AIR
BAG” embossed on the pad covers.
The purpose of the SRS is to provide the
vehicle’s driver and front passengers
with additional protection than that
offered by the seat belt system alone
in case of a frontal impact of sufficient
severity.
WARNING
To reduce the risk of serious injury or
death from an inflating front air bags,
take the following precautions:
[ Seat belts must be worn at all times
to help keep occupants positioned
properly.
[ Move your seat as far back as
possible from front air bags, whilst
still maintaining control of the
vehicle.
[ Never lean against the door or centre
console.
[ Do not allow the front passenger
to place their feet or legs on the
dashboard.
[ No objects (such as crash pad cover,
mobile phone holder, cup holder,
perfume or stickers) should be placed
over or near the air bag modules on
the steering wheel, instrument panel,
windscreen glass, and the front
passenger’s panel above the glove
box. Such objects could cause harm
if the vehicle is in a crash severe
enough to cause the air bags to
deploy.
[ Do not attach any objects on front
windscreen and inside mirror.
[ Hold the steering wheel at the 9
o’clock and 3 o’clock positions, to
minimise the risk of injuries to your
hands and arms.
Page 89 of 649
3-52
Safety system
Do not install a Child Restraint
System on the front passenger
seat
OHI038169L
Never install a Child Restraint System in
the front passenger’s seat. An inflating air
bag can forcefully strike a child or restraint
resulting in serious or fatal injury.
WARNING
[ Extreme hazard! Do not use a
rearward facing Child Restraint
System on a seat protected by an air
bag in front of it!
[ NEVER use a rearward facing Child
Restraint System on a seat protected
by an ACTIVE AIRBAG in front of it,
DEATH or SERIOUS INJURY to the
CHILD can occur.
[ Never put a Child Restraint System in
the front passenger’s seat. If the front
passenger air bag inflates, it would
cause serious or fatal injuries.
Why didn’t my air bag go off in a
collision?
There are certain types of accidents in
which the air bag would not be expected
to provide additional protection. These
include rear impacts, second or third
collisions in multiple impact accidents,
as well as low speed impacts. Damage to
the vehicle indicates a collision energy
absorption, and is not an indicator of
whether or not an air bag should have
inflated.
Air bag collision sensors
WARNING
To reduce the risk of an air bag
deploying unexpectedly and causing
serious injury or death:
[ Do not hit or allow any objects to
impact the locations where air bags
or sensors are installed.
[ Do not perform maintenance on or
around the air bag sensors. If the
location or angle of the sensors is
altered, the air bags may deploy
when they should not or may not
deploy when they should.
[ Installing bumper guards with non-
genuine Hyundai or non-equivalent
parts may adversely affect the
collision and airbag deployment
performance.
To ensure correct function of the
airbag system we recommend to
replace the bumper with genuine
HYUNDAI part or the equivalent (of
the genuine part) specified for your
vehicle.
[ Place the ignition switch to the
LOCK/OFF or ACC position, when the
vehicle is being towed to prevent
inadvertent air bag deployment.
[ We recommend that all air bag
repairs are conducted by a HYUNDAI
authorised repairer.
Page 107 of 649
4-12
Instrument cluster
Anti-lock Brake System
(ABS) warning light
7 K L V Z D U Q L Q J O L J K W L O O X P L Q D W H V
[ When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- The ABS warning light illuminates for
about 3 seconds and then goes off.
[ Whenever there is a malfunction with
the ABS.
Note that the hydraulic braking system
will still be operational even if there is
a malfunction with the ABS.
If this occurs, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
Electronic Brake Force
Distribution (EBD)
system warning light
7 K H V H W Z R Z D U Q L Q J O L J K W V L O O X P L Q D W H
D W W K H V D P H W L P H Z K L O V W G U L Y L Q J
[ When the ABS warning and
Parking Brake warning lights are on
simultaneously, it may indicate a
problem with the Electronic Brake
Force Distribution system.
If this occurs, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
WARNING
Electronic Brake Force Distribution
(EBD) system warning light
When both ABS and Parking Brake &
Brake Fluid warning lights are on, the
brake system will not work normally
and you may experience an unexpected
and dangerous situation during sudden
braking.
In this case, avoid high speed driving
and abrupt braking.
We recommend you have the vehicle
inspected by a HYUNDAI authorised
repairer as soon as possible.
i Information
Electronic Brake Force Distribution
(EBD) system warning light
: K H Q W K H $ % 6 : D U Q L Q J / L J K W L V R Q
R U E R W K $ % 6 D Q G 3 D U N L Q J % U D N H
% U D N H ) O X L G Z D U Q L Q J O L J K W V D U H R Q W K H
V S H H G R P H W H U R G R P H W H U R U W U L S P H W H U P D \
Q R W Z R U N $ O V R W K H ( 3 6 Z D U Q L Q J O L J K W
P D \ L O O X P L Q D W H D Q G W K H V W H H U L Q J H I I R U W
P D \ L Q F U H D V H R U G H F U H D V H
, I W K L V R F F X U V Z H U H F R P P H Q G \ R X K D Y H
W K H Y H K L F O H L Q V S H F W H G E \ D + < 8 1 ' $ ,
D X W K R U L V H G U H S D L U H U D V V R R Q D V S R V V L E O H