Eco HYUNDAI I20 2023 Owner's Manual

3-26
Safety system
8KMB3311/H
The Pre-Tensioner Seat Belt System
consists mainly of the following
components. Their locations are shown
in the illustration above:
(1) SRS air bag warning light
(2) Front retractor pre-tensioner
(if equipped)
(3) SRS control module
OBC3030012R
„Rear
(4) Rear retractor pre-tensioner
(if equipped)
NOTICE
The sensor that activates the SRS
air bag is connected with the pre–
tensioner seat belts. The SRS air bag
warning light on the instrument panel
will illuminate for approximately 6
seconds after the ignition switch is
placed to the ON position, and then it
should turn off.
If the pre-tensioner is not working
properly, the warning light will
illuminate even if the SRS air bag is not
malfunctioning. If the warning light
does not illuminate, stays illuminated
or illuminates when the vehicle is
being driven, we recommend the pre-
tensioner seat belts and/or SRS air bags
be inspected by a HYUNDAI authorised
repairer as soon as possible.

3-29
03
Seat belt use and injured people
A seat belt should be used when an
injured person is being transported.
Consult a physician for specific
recommendations.
One person per belt
Two people (including children) should
never attempt to use a single seat belt.
This could increase the severity of injuries
in case of an accident.
Do not lie down
Sitting in a reclined position when the
vehicle is in motion can be dangerous.
Even when buckled up, the protections
of your restraint system (seat belts
and/or air bags) is greatly reduced by
reclining your seatback.
Seat belts must be snug against your
hips and chest to work properly. During
an accident, you could be twined with
the seat belt, causing neck or other
injuries.
The more the seatback is reclined,
the greater chance the passenger’s
hips will slide under the lap belt or the
passenger’s neck will strike the shoulder
belt.
WARNING

[NEVER ride with a reclined seatback
when the vehicle is moving.

[Riding with a reclined seatback
increases your chance of serious
or fatal injuries in the event of a
collision or sudden stop.

[Driver and passengers should always
sit well back in their seats, properly
belted, and with the seatbacks
upright.
Care of seat belts
Seat belt systems should never be
disassembled or modified. In addition,
care should be taken to assure that
seat belts and belt hardware are not
damaged by seat hinges, doors or other
abuse.
Periodic inspection
All seat belts should be inspected
periodically for wear or damage of any
kind. Any damaged parts should be
replaced as soon as possible.
Keep belts clean and dry
Seat belts should be kept clean and
dry. If belts become dirty, they can be
cleaned by using a mild soap solution
and warm water. Bleach, dye, strong
detergents or abrasives should not be
used because they may damage and
weaken the fabric.
When to replace seat belts
The entire seat belt assembly or
assemblies should be replaced if the
vehicle has been involved in an accident.
This should be done even if no damage
is visible. We recommend that you
consult a HYUNDAI authorised repairer.

3-31
03
Child Restraint System (CRS) always
in the rear
Infants and younger children must be
restrained in an appropriate rearward-
facing or forward-facing CRS that has
first been properly secured to the rear
seat of the vehicle. Read and comply
with the instructions for installation and
use provided by the manufacturer of the
Child Restraint System.
WARNING

[Always follow the Child Restraint
System manufacturer’s instructions
for installation and use.

[Always properly restrain your child in
the Child Restraint System.

[Do not use an infant carrier or a
child safety seat that “hooks” over
a seatback, it may not provide
adequate protection in an accident.

[After an accident, we recommend
a HYUNDAI dealer check the Child
Restraint System, seat belts,
ISOFIX anchorages and top-tether
anchorages.
Selecting a Child Restraint
System (CRS)
When selecting a CRS for your child,
always:

[Make sure a CRS has a label certifying
that it meets applicable Safety
Standards of your country.

[Select a CRS based on your child’s
height and weight. The required label
or the instructions for use typically
provide this information.

[Select a CRS that fits the vehicle
seating position where it will be used.

[Read and comply with the warnings
and instructions for installation and
use provided with a CRS.
Child Restraint System types
There are three main types of Child
Restraint Systems: rearward-facing
seats, forward-facing seats, and booster
seats. They are classified according to
the child’s age, height and weight.

3-33
03
Installing a Child Restraint
System (CRS)
WARNING
Before installing your Child Restraint
System always:
Read and follow the instructions
provided by the manufacturer of the
Child Restraint System.
Failure to follow all warnings and
instructions could increase the risk of
the SERIOUS INJURY or DEATH if an
accident occurs.
WARNING
If the vehicle head restraint prevents
proper installation of a Child Restraint
System, the head restraint of the
respective seating position shall be
readjusted or entirely removed.
After selecting a proper Child Restraint
System and checking that the Child
Restraint System fits properly in the rear
of this vehicle, you are ready to install
the Child Restraint System according to
the manufacturer’s instruction. There are
three general steps in installing the Child
Restraint Systems properly:

[Properly secure the Child Restraint
System to the vehicle. All Child
Restraint Systems must be secured
to the vehicle with the lap belt or lap
part of a lap/shoulder belt or with
the ISOFIX top-tether and/or ISOFIX
anchorage.
[Make sure the Child Restraint System
is firmly secured. After installing a
Child Restraint System to the vehicle,
push and pull the seat forward and
from side-to-side to verify that it is
securely attached to the seat. A Child
Restraint System secured with a seat
belt should be installed as firmly as
possible. However, some side-to- side
movement can be expected.
When installing a Child Restraint
System, adjust the vehicle seat (up
and down, forward and rearward)
so that your child fits in the Child
Restraint System in a comfortable
manner.

[Secure the child in the Child
Restraint System. Make sure the
child is properly strapped in the Child
Restraint System according to the
Child Restraint System manufacturer’s
instructions.
CAUTION
A Child Restraint System in a closed
vehicle can become very hot. To
prevent burns, check the seating
surface and buckles before placing
your child in the Child Restraint
System.

3-35
03
Seat NumberPosition
in the vehicleSeating positions
1 Front left
2 Front centre
3 Front right
42
nd row left
52
nd row centre
62
nd row right
❈ If the vehicle head restraint prevents proper installation of a CRS, the head restraint of the
seating position shall be readjusted or entirely removed
❈ Never place a rearward facing Child Restraint System on the front passenger seat, unless the
air bag is deactivated.
Recommended CRS for Vehicle according to UN regulations
(Information for use by vehicle users and CRS manufacturers)
Mass
groupName Manufacturer Type of FixationECE
Approval Number
Group 2 KidFix III S Britax RömerISOFIX and vehicle belt,
using CRS lap belt guideR44/04 - E1 – 04301304
Group 3 Junior III Graco Vehicle belt R44/04 – E11 – 03.44.165
CRS Manufacturer information
Britax : http://www.britax.com
Graco : http://www.gracobaby.com

3-38
Safety system
WARNING
Take the following precautions when
using the ISOFIX system:

[Read and follow all installation
instructions provided with your Child
Restraint System.

[To prevent the child from reaching
and taking hold of unretracted
seat belts, buckle all unused rear
seat belts and retract the seat belt
webbing behind the child. Children
can be strangled if a shoulder belt
becomes wrapped around their neck
and the seat belt tightens.

[NEVER attach more than one
Child Restraint System to a single
anchorage. This could cause the
anchor or attachment to come loose
or break.

[Always have the ISOFIX system
inspected by your dealer after an
accident. An accident can damage
the ISOFIX system and may not
properly secure the Child Restraint
System.
Securing a Child Restraint System
seat with “Top-tether Anchorage”
system
OBC3030017
Top-tether anchorages for Child
Restraint Systems are located on the
rear of the seatback.
OBC3030018
1. Route the Child Restraint System seat
strap over the seatback.
For vehicles with adjustable head
restraint, route the tether strap under
the head restraint and between the
head restraint posts, otherwise route
the tether strap over the top of the
seatback.
2. Connect the top-tether to the top-
tether anchorage, then tighten
the top-tether according to the
instructions of your Child Restraint
System’s manufacturer to firmly
attach the Child Restraint System to
the seat.

3-40
Safety system
OHI038146
2. Fasten the lap/shoulder belt latch
into the buckle. Listen for the distinct
“click” sound.
i Information
Position the release button so that it is
easy to access in case of an emergency.
OHI038183L
3. Remove as much slack from the
belt as possible by pushing down
on the Child Restraint System whilst
feeding the shoulder belt back into the
retractor.
4. Push and pull on the Child Restraint
System to confirm that the seat belt is
holding it firmly in place.
If your CRS manufacturer instructs
or recommends you use a top-tether
anchorage with the lap/shoulder belt,
see page 3-36.
To remove the Child Restraint System,
press the release button on the buckle
and then pull the lap/shoulder belt out
of the Child Restraint System and allow
the seat belt to retract fully.

3-45
03
OBC3030022
„Type A
„Type B
OBC3030035
To reactivate the passenger’s front air
bag:
Insert the key or a similar rigid device
into the passenger’s front air bag
ON/OFF switch and turn it to the ON
position. The passenger air bag ON
indicator (
) will illuminate and stay on
for 60 seconds.
WARNING
Never allow an adult passenger to
ride in the front passenger seat when
the passenger air bag OFF indicator is
illuminated. During a collision, the air
bag will not inflate if the indicator is
illuminated. Turn on the passenger’s
front air bag or have your passenger
move to the rear seat.
WARNING
If the passenger’s front air bag ON/
OFF switch malfunctions, the following
conditions may occur:

[The air bag warning light (
) on the
instrument cluster will illuminate.

[The passenger air bag OFF indicator
(
) will not illuminate and the ON
indicator () will come on and go off
after approximately 60 seconds. The
passenger’s front air bag will inflate
in a frontal impact even though the
passenger’s front air bag ON/OFF
switch is set to the OFF position.

[We recommend that a HYUNDAI
authorised repairer inspect the
passenger’s front air bag ON/OFF
switch and the SRS air bag system as
soon as possible.

3-46
Safety system
Side air bags (if equipped)
OAC3039019TU
OAC3039020R
Your vehicle is equipped with a side air
bag in each front seat.
The purpose of the air bag is to provide
the vehicle’s driver and the front
passenger with additional protection
than that offered by the seat belt alone.
The side air bags are designed to
deploy only during certain side impact
collisions, depending on the crash
severity.
The side air bags are not designed to
deploy in all side impact.
WARNING
To reduce the risk of serious injury or
death from an inflating side air bag,
take the following precautions:

[Seat belts must be worn at all times
to help keep occupants positioned
properly.

[Do not allow passengers to lean their
heads or bodies onto doors, put their
arms on the doors, stretch their arms
out of the window, or place objects
between the doors and seats.

[Do not use any accessory seat covers.
This could reduce or prevent the
effectiveness of the system.

[Do not place any objects over the
air bag or between the air bag and
yourself. Also, do not attach any
objects around the area the air bag
inflates such as the door, side door
glass, front and rear pillar.

[Do not place any objects between the
door and the seat. They may become
dangerous projectiles if the side air
bag inflates.

[Do not install any accessories on the
side or near the side air bags.

[Do not put any objects between the
side air bag label and seat cushion. It
could cause harm if the vehicle is in a
crash severe enough to cause the air
bags to deploy.

[Do not cause impact to the doors
when the ignition switch is in the ON
position or this may cause the side air
bags to inflate.

[If the seat or seat cover is damaged,
we recommend that the system be
serviced by a HYUNDAI authorised
repairer.

3-48
Safety system
How does the air bags system
operate?
OBC3030023R
The SRS consists of the following
components:
(1) Driver’s front air bag module
(2) Passenger’s front air bag module*
(3) Side air bag modules*
(4) Curtain air bag modules*
(5) Retractor pre-tensioner assemblies*
(6) Air bag warning light
(7) SRS control module (SRSCM)
(8) Front impact sensors
(9) Side impact sensors*
(10) Side pressure sensors*
(11) Passenger’s front air bag OFF
indicator (front passenger’s seat
only) *
(12) Passenger’s front air bag ON/OFF
switch *
* : if equipped
The SRSCM continually monitors SRS
components whilst the ignition switch
is in the ON position to determine if a
crash impact is severe enough to require
air bag deployment or pre-tensioner seat
belt deployment.
SRS warning light
The SRS (Supplement Restraint System)
air bag warning light on the instrument
panel displays the air bag symbol
depicted in the illustration. The system
checks the air bag electrical system for
malfunctions. The light indicates that
there is a potential problem with your air
bag system.
WARNING
If your SRS malfunctions, the air bag
may not inflate properly during an
accident increasing the risk of serious
injury or death.
If any of the following conditions occur,
your SRS is malfunctioning:

[The light does not turn on for
approximately six seconds when the
ignition switch is in the ON position.

[The light stays on after illuminating
for approximately six seconds.

[The light comes on whilst the vehicle
is in motion.

[The light blinks when the engine is
running.
We recommend that a HYUNDAI
authorised repairer inspect the SRS
as soon as possible if any of these
conditions occur.