how to set cruise control HYUNDAI IONIQ 6 2023 Owners Manual

7
7-65
Setting vehicle distance
B7004302
Each time the button is pressed, the
headway changes as follows:
B7004303
Information • If you drive at 56 mph (90 km/h), the distance is maintained as follows:
Distance 4 - about 172 ft. (53 m)
Distance 3 - about 130 ft. (40 m)
Distance 2 - about 106 ft. (30 m)
Distance 1 - about 82 ft. (25 m)
• The distance is set to the last set distance when the vehicle is restarted, or when Smart
Cruise Control was temporarily canceled.

Increasing set speed
B7002304_1
• Push the + switch up and release it immediately. The set speed will
increase by 1 mph (1 km/h) each time
the switch is operated in this manner.
• Push the + switch up and hold it while monitoring the set speed on the
instrument cluster. The set speed will
increase by 5 mph (10 km/h) each time
the switch is operated in this manner.
Release the switch when the desired
speed is shown, and the vehicle will
accelerate to that speed. You can
increase the set speed to 120 mph (200
km/h).
WARNING Check the driving condition before using
the + switch. Driving speed may sharply
increase when you push up and hold the +
switch.

Hyundai_CE_en_US.book Page 65

7
7-67
Information If your vehicle is equipped with Manual
Speed Limit Assist, press and hold the Driving
Assist ( ) button to turn off Smart Cruise
Control. However Manual Speed Limit Assist
will turn on.

WARNING Do not use the switches and buttons at
the same time. Smart Cruise Control may
not operate properly.

Display and Control
Basic function
You can see the status of the Smart Cruise
Control operation in the Driving Assist
view on the instrument cluster. For more
information, refer to the “View Modes”
section in chapter 4.
Smart Cruise Control will be displayed as
below depending on the status of the
function.
Operating
B7004309
Temporarily canceled
B7004310
• When operating
1. Whether there is a vehicle ahead and the selected distance level
2. Set speed
3. Whether there is a vehicle ahead and the target vehicle distance
• When temporarily canceled 1. Your vehicle (grey)
2. Previous set speed (grey)
3. Vehicle ahead and distance level (grey) (if equipped)
Information • The distance of the front vehicle on the instrument cluster is displayed based on the
actual distance between your vehicle and
the vehicle ahead.
• The target distance may vary according to the vehicle speed and the set distance level.
If the vehicle speed is low, even though the
vehicle distance have changed, the change
of the target vehicle distance may be small.
• The images and colors in the instrument cluster may differ depending on the
instrument cluster type or theme selected
from the settings menu.

2
3
150MPH
231
3
50MPH
Hyundai_CE_en_US.book Page 67

Driver Assistance System
7-68
Accelerating temporarily
B7004311
If you want to speed up temporarily
without altering the set speed while
Smart Cruise Control is operating,
depress the accelerator pedal. While the
accelerator pedal is depressed, the set
speed, distance level and target distance
will blink on the instrument cluster.
However, if the accelerator pedal is
depressed insufficiently, the vehicle may
decelerate.
WARNING Be careful when accelerating temporarily,
because the speed and distance is not
controlled automatically even if there is a
vehicle in front of you.

Based on Driving Style operation
B7004312
When Based on Driving Style is operating,
'Driving Style Adaptive SCC' message
will appear on the instrument cluster for 2
seconds, and the distance level and
target distance will be displayed based on
the driving style.
CAUTION • The vehicle must be driven sufficiently to reflect the actual driver's driving
style to the Based on Driving Style’s
vehicle distance, acceleration, and
reaction speed.
• Based on Driving Style may not reflect driving styles or driving conditions that
affect safe driving.
• If you are driving in special conditions, such as snow, rain, fog, or steep slopes,
the vehicle may not be driven
according to the driver’s driving style.

Information • Driving styles that are far from safe driving such as sudden acceleration may not be
reflected to Based on Driving Style.
• Based on Driving Style does not reflect any other driving style other than vehicle
distance, acceleration and reaction speed.

50MPH
%SJWJOH
4UZMF
"EBQUJWF

4$$
50MPH50MPH
Hyundai_CE_en_US.book Page 68

Driver Assistance System
7-78
Information For more information on how to operate
Smart Cruise Control, refer to the “Smart
Cruise Control (SCC)” section in this chapter.

Navigation-based Smart Cruise
Control display and control
When Navigation-based Smart Cruise
Control operates, it will be displayed on
the instrument cluster as follows:
B7004702
Navigation-based Smart Cruise Control
standby
If the operating conditions are satisfied,
the green indicator light illuminates.
Navigation-based Smart Cruise Control
operating
While the speed is being controlled, the
green indicator light blinks.
Temporarily canceled or interrupted by
the driver
If Navigation-based Smart Cruise Control
cannot control the vehicle, such as when
Smart Cruise Control is temporarily
canceled or the navigation system is
searching for a route, the gray
indicator light illuminates.
When the driver depresses the
accelerator pedal, the white indicator
light blinks.
WARNING
B7004703
'Drive carefully' warning message will
appear in the following circumstances:
• Navigation-based Smart Cruise Control is not able to slow down your vehicle to
a safe speed

Information The images and colors in the instrument
cluster may differ depending on the
instrument cluster type or theme selected from
the settings menu.

Highway Curve Zone Auto Slowdown
• Depending on the curve ahead on the highway, the vehicle will decelerate,
and after passing the curve, the vehicle
will accelerate to Smart Cruise Control
set speed.
• Vehicle deceleration time may differ depending on the vehicle speed and
the degree of the curve on the road. The
higher the driving speed, deceleration
will start faster.
55MPH
%SJWF
DBSFGVMMZ
55MPH
Hyundai_CE_en_US.book Page 78

7
7-81
decelerate the vehicle. However, if the
accelerator pedal is depressed
insufficiently, the vehicle may
decelerate.
• If the driver accelerates and releases the accelerator pedal while
Navigation-based Smart Cruise Control
is operating, the vehicle may not
decelerate sufficiently or may rapidly
decelerate to a safe speed.
• If the curve is too large or too small, Navigation-based Smart Cruise Control
may not operate.

Information • A time gap could occur between the navigation’s guidance and when
Navigation-based Smart Cruise Control
operation starts and ends.
• The speed information on the instrument cluster and navigation may differ.
• Even if you are driving at a speed lower than Smart Cruise Control set speed,
acceleration may be limited by the curve
sections ahead.
• If Navigation-based Smart Cruise Control is operating while leaving the main road to
enter an interchange, junction, rest area,
etc., the function may operate for a certain
period of time.
• Deceleration by Navigation-based Smart Cruise Control may feel it is not sufficient
due to road conditions such as uneven road
surfaces, narrow lanes, etc.

Information This device complies with Part 15 of the FCC
rules.
Operation is subject to the following three
conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference
received, including interference that may
cause undesired operation.
3. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority
to operate the device.

Information Radio frequency radiation exposure
information:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and
operated with minimum distance of 8 in. (20
cm) between the radiator (antenna) and your
body.
This transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.

Hyundai_CE_en_US.book Page 81