check engine HYUNDAI PALISADE 2022 Manual PDF

7-50
Maintenance
Engine Compartment Panel
Fuse Replacement
1. Turn the engine off.
2. Turn all other switches OFF.3. Remove the fuse panel cover by
pressing the tap and pulling up.
4. Check the removed fuse; replace it if it is blown. To remove or insert
the fuse, use the fuse puller in the
engine compartment fuse panel.
5. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips. If it fits loosely, consult
an authorized HYUNDAI dealer.
Multi fuse
If the multi fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative batterycable.
3. Remove the fuse panel cover by pressing the tab and pulling it up.
4. Remove the nuts shown in the pic- ture above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.
Information
If the multi fuse is blown, consult an
authorized HYUNDAI dealer.
i
After checking the fuse box in
the engine compartment
securely close the fuse box
cover inside the engine com-
partment, until it clicks.
If the fuse box is not closed
properly, water may leak in side,
possibly causing a malfunction
with the electrical system.
CAUTIONOLX2078024
■Blade type fuse
OLX2078025
■Cartridge type fuse
OLX2078023

7-78
Maintenance
Canister
Fuel vapors generated inside the fuel
tank are absorbed and stored in the
onboard canister. When the engine is
running, the fuel vapors absorbed in
the canister are drawn into the surge
tank through the purge control sole-
noid valve.
Purge Control Solenoid Valve(PCSV)
The purge control solenoid valve is
controlled by the Engine Control
Module (ECM); when the engine
coolant temperature is low during
idling, the PCSV closes so that evap-
orated fuel is not taken into the
engine. After the engine warms-up
during ordinary driving, the PCSV
opens to introduce evaporated fuel to
the engine.
3. Exhaust Emission Control System
The Exhaust Emission Control
System is a highly effective system
which controls exhaust emissions
while maintaining good vehicle per-
formance.
When the engine starts or fails to
start, excessive attempts to restart
the engine may cause damage to the
emission system.
Engine exhaust (carbon monox-
ide) precautions
Carbon monoxide can be present
with other exhaust fumes. If you
smell exhaust fumes of any kind in
your vehicle, drive with all the win-
dows fully open. Have your vehicle
checked and repaired immediately.
Engine exhaust gases contain
carbon monoxide (CO). Though
colorless and odorless, it is
dangerous and could be lethal if
inhaled. Follow the instructions
on this page to avoid CO poi-
soning.
WARNING

8-9
88
Specifications, Consumer information and Reporting safety defects
Recommended SAE viscosity
number
Always be sure to clean the area
around any filler plug, drain
plug, or dipstick before check-
ing or draining any lubricant.
This is especially important in
dusty or sandy areas and when
the vehicle is used on unpaved
roads. Cleaning the plug and
dipstick areas will prevent dirt
and grit from entering the
engine and other mechanisms
that could be damaged.
CAUTION
*1: For better fuel economy, it is recommended to use the engine oil of a viscositygrade SAE 5W-30. However, if the engine oil is not available in your country,
select the proper engine oil using the engine oil viscosity chart.
An engine oil displaying this American Petroleum Institute(API)
Certification Mark conforms to the International Lubricant
Specification Advisory Committee (ILSAC). It is recommended to
only use engine oils that uphold this API Certification Mark.
Engine oil viscosity (thickness) has an effect on fuel economy and cold
weather operating (engine start and engine oil flowability). Lower viscosity
engine oils can provide better fuel economy and cold weather performance,
however, higher viscosity engine oils are required for satisfactory lubrication
in hot weather.
Using oils of any viscosity other than those recommended could result in
engine damage.
When choosing an oil, consider the range of temperature your vehicle will be
operated in before the next oil change. Proceed to select the recommended
oil viscosity from the chart.
Temperature Range for SAE Viscosity Numbers
Temperature -30 -20 -10 0 10 20 30 40 50
-10 0 20 40 60 80 100 120
Engine Oil *1
°C
(°F)
5W-30

I-4
Drive Mode Integrated Control System (2WD) .............5-55Drive Mode ................................................................5-55
Drive Mode Integrated Control System(AWD)..............5-59 Drive Mode ................................................................5-59
Driver Attention Warning (DAW) ................................5-136 Driver Attention Warning malfunction and limitations ........................................................5-140
Driver Attention Warning operation.........................5-138
Driver Attention Warning settings ..........................5-137
Driver position memory system ....................................3-32 Easy Access Function .................................................3-34
Recalling Positions from Memory .............................3-33
Resetting the Driver's Seat Memory System .............3-33
Storing Positions into Memory .................................3-32
Emission control system .................................................7-77 Crankcase Emission Control System .........................7-77
Evaporative Emission Control System Including
Onboard Refueling Vapor Recovery (ORVR)............7-77 Exhaust Emission Control System .............................7-78
Engine ........................................................................\
.......8-2
Engine Compartment ........................................................1-6
Engine compartment .........................................................7-3
Engine coolant ................................................................7-18 Changing Engine Coolant ..........................................7-20
Checking the Engine Coolant Level ..........................7-18
Engine Number ...............................................................8-11 Engine oil ........................................................................\
7-16
Checking the Engine Oil and Filter ...........................7-17
Checking the Engine Oil Level ..................................7-16
Explanation of scheduled maintenance items.................7-13
Exterior Features .............................................................3-66 Fuel Filler Door ..........................................................3-79
Hood ........................................................................\
...3-66
Non-Powered Liftgate ................................................3-67
Power Liftgate ...........................................................3-69
Smart Liftgate.............................................................3-75
Exterior features............................................................3-234 Roof Side Rails ........................................................3-234
Exterior Overview.............................................................1-2
Forward Collision-avoidance Assist(FCA) (Sensor Fusion) .............................................................5-63
Forward Collision-Avoidance Assist malfunction and limitations ..........................................................5-70
Forward Collision-Avoidance Assist operation ........5-66
Forward Collision-Avoidance Assist settings ............5-64
Forward/Reverse Parking Distance Warning (PDW) ...3-170 Forward/Reverse Parking Distance Warning malfunction and precautions ..................................3-173
Forward/Reverse Parking Distance Warning operation .................................................................3-171
Reverse Parking Distance Warning settings ............3-170
Index
EF