engine HYUNDAI SANTA FE 2023 Owners Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2023, Model line: SANTA FE, Model: HYUNDAI SANTA FE 2023Pages: 624, PDF Size: 8.13 MB
Page 407 of 624
07
7-27
CAUTION
Take the following precautions to
maintain optimal performance of the
detecting sensor:
[ Never disassemble the rear corner
radar or radar assembly, or apply any
impact on it.
[ If there is impact on the rear corner
radar or near the radar, even though
the warning message does not
appear on the cluster, Blind-Spot
Collision-Avoidance Assist may not
operate properly. Have the vehicle be
inspected by an authorized HYUNDAI
dealer.
[ If the rear corner radars have
been replaced or repaired, have
the vehicle be inspected by an
authorized HYUNDAI dealer.
[ Use only genuine parts to repair the
rear bumper where the rear corner
radar is located.
[ Do not apply license plate frame or
objects, such as a bumper sticker,
film or a bumper guard near the rear
corner radar.
[ Blind-Spot Collision-Avoidance
Assist may not work properly if the
bumper has been replaced, or the
surroundings of the rear corner radar
has been damaged or paint has been
applied.
[ If a trailer, carrier, etc., is installed,
it may adversely affect the
performance of the rear corner radar
or it may not operate.
For more details on the precautions
of the front view camera, refer to
“Forward Collision-Avoidance Assist
(FCA)” section in chapter 7.
Blind-Spot Collision-Avoidance
Assist Settings
Blind-Spot Safety
OTM070096N
With the engine on, select ‘Driver
$ V V L V W D Q F H
Page 408 of 624
Driver assistance system7-28
OTM070097N
When the engine is restarted with Blind-
Spot Collision-Avoidance Assist off,
W K H S % O L Q G 6 S R W 6 D I H W \ 6 \ V W H P L V 2 I IT
message will appear on the cluster.
, I \ R X F K D Q J H W K H V H W W L Q J I U R P S 2 I IT W R
S $ F W L Y H $ V V L V WT R U S : D U Q L Q J 2 Q O \T W K H
warning light on the side view mirror will
blink for three seconds.
In addition, if the engine is turned on,
when Blind-Spot Collision-Avoidance
$ V V L V W L V V H W W R S $ F W L Y H $ V V L V WT R U S : D U Q L Q J
2 Q O \T W K H Z D U Q L Q J O L J K W R Q W K H V L G H Y L H Z
mirror will blink for three seconds.
WARNING
[ If ‘Warning Only’ is selected, braking
is not assisted.
[ If ‘Off’ is selected, the driver should
always be aware of the surroundings
and drive safely.
Information
If the engine is restarted, Blind-Spot
Collision-Avoidance Assist will maintain
the last setting.
Warning Timing
OTM070140N
With the engine on, select ‘Driver
$ V V L V W D Q F H
Page 409 of 624
07
7-29
Warning Volume
OTM070141N
With the engine on, select ‘Driver
$ V V L V W D Q F H
Page 414 of 624
Driver assistance system7-34
Blind-Spot Collision-Avoidance
Assist malfunction and
limitations
Blind-Spot Collision-Avoidance
Assist malfunction
OTM070099N
When Blind-Spot Collision-Avoidance
Assist is not working properly, the ‘Check
% O L Q G 6 S R W 6 D I H W \ V \ V W H P V T Z D U Q L Q J
message will appear on the cluster, and
the function will turn off automatically
or the function will be limited. Have the
vehicle be inspected by an authorized
HYUNDAI dealer.
OTM070100N
When the side view mirror warning
light is not working properly, the ‘Check
V L G H Y L H Z P L U U R U Z D U Q L Q J O L J K WT Z D U Q L Q J
message will appear on the cluster.
Have the vehicle be inspected by an
authorized HYUNDAI dealer.
Blind-Spot Collision-Avoidance
Assist disabled
OTM070098N
When the rear bumper around the rear
corner radar or sensor is covered with
foreign material, such as snow or rain,
or installing a trailer or carrier, it can
reduce the detecting performance and
temporarily limit or disable Blind-Spot
Collision-Avoidance Assist.
If this occurs, the ‘Blind-Spot Safety
V \ V W H P V G L V D E O H G 5 D G D U E O R F N H GT
warning message will appear on the
cluster.
Blind-Spot Collision-Avoidance Assist
will operate normally when such foreign
material or trailer, etc., is removed, and
then the engine is restarted.
If Blind-Spot Collision-Avoidance Assist
does not operate normally after it is
removed, have the vehicle be inspected
by an authorized HYUNDAI dealer.
WARNING
[ Even though the warning message
does not appear on the cluster, Blind-
Spot Collision-Avoidance Assist may
not properly operate.
[ Blind-Spot Collision-Avoidance
Assist may not properly operate in
an area (for example, open terrain)
where any objects are not detected
right after the engine is turned on, or
when the detecting sensor is blocked
with foreign material right after the
engine is turned on.
Page 420 of 624
Driver assistance system7-40
Safe Exit Assist Settings
Safe Exit Assist
OTM070038N
With the engine on, select ‘Driver
$ V V L V W D Q F H
Page 421 of 624
07
7-41
Warning Volume
OTM070141N
With the engine on, select ‘Driver
$ V V L V W D Q F H
Page 423 of 624
07
7-43
[ The driver and passengers are
responsible for accidents that occur
while exiting the vehicle. Always
check the surroundings before you
exit the vehicle.
[ Never deliberately operate Safe Exit
Assist. Doing so may lead to serious
injury or death.
[ Safe Exit Assist does not operate
if there is a problem with Safe Exit
Assist. There may be a problem with
Safe Exit Assist when:
- Safe Exit Assist warning light
appears
- Safe Exit Assist sensor or the
sensor surrounding is polluted or
covered
- Safe Exit Assist fails to warn
passengers or falsely warn
passengers
Information
After the engine is turned off, Safe Exit
Assist operates approximately for 3
minutes, but turns off immediately if the
doors are locked.
Safe Exit Assist malfunction and
Limitations
Safe Exit Assist malfunction
OTM070099N
When Safe Exit Assist is not working
properly, the ‘Check Blind-Spot Safety
V \ V W H P V T Z D U Q L Q J P H V V D J H Z L O O D S S H D U
on the cluster, and the function will turn
off automatically or the function will be
limited. Have the vehicle be inspected by
an authorized HYUNDAI dealer.
Page 424 of 624
Driver assistance system7-44
Safe Exit Assist disabled
OTM070098N
When the rear bumper around the rear
corner radar or sensor is covered with
foreign material, such as snow or rain,
or installing a trailer or carrier, it can
reduce the detecting performance and
temporarily limit or disable Safe Exit
Assist.
If this occurs, the ‘Blind-Spot Safety
V \ V W H P V G L V D E O H G 5 D G D U E O R F N H GT
warning message will appear on the
cluster.
Safe Exit Assist will operate normally
when such foreign material or trailer,
etc., is removed, and then the engine is
restarted.
If Safe Exit Assist does not operate
normally after it is removed, have the
vehicle be inspected by an authorized
HYUNDAI dealer.
WARNING
[ Even though the warning message
does not appear on the cluster, Safe
Exit Assist may not properly operate.
[ Safe Exit Assist may not properly
operate in an area (for example,
open terrain) where any objects are
not detected right after the engine
is turned on, or when the detecting
sensor is blocked with foreign
material right after the engine is
turned on.
CAUTION
Turn off Safe Exit Assist to install a
trailer, carrier, etc., or remove the
trailer, carrier, etc., to use Safe Exit
Assist.
Limitations of Safe Exit Assist
Safe Exit Assist may not operate
normally, or it may operate unexpectedly
under the following circumstances:
[ Getting out of the vehicle where trees
or grass are overgrown
[ Getting out of the vehicle where the
road is wet
[ The approaching vehicle is very fast or
very slow
For more details on the limitations of
the rear corner radar, refer to “Blind-
Spot Collision-Avoidance Assist (BCA)”
section in chapter 7.
WARNING
[ Safe Exit Assist may not operate
normally if interfered by strong
electromagnetic waves.
[ Safe Exit Assist may not operate
for 3 seconds after the vehicle is
started, or the rear corner radars are
initialized.
Page 426 of 624
Driver assistance system7-46
Warning Timing
OTM070140N
With the engine on, select ‘Driver
$ V V L V W D Q F H
Page 427 of 624
07
7-47
[ 7 K H G U L Y H UT V D W W H Q W L R Q O H Y H O L V G L V S O D \ H G on the scale of 1 to 5. The lower the
level is, the more inattentive the driver
is.
[ The level decreases when the driver
does not take a break for a certain
period of time.
Taking a break
OTM070105L
[ 7 K H S & R Q V L G H U W D N L Q J D E U H D NT P H V V D J H will appear on the cluster and an
audible warning will sound to suggest
that the driver take a break, when the
G U L Y H UT V D W W H Q W L R Q O H Y H O L V E H O R Z
[ Driver Attention Warning will not
suggest a break when the total driving
time is shorter than 10 minutes or 10
minutes has not passed after the last
break was suggested.
WARNING
For your safety, only change the
Settings after parking the vehicle at a
safe location.
CAUTION
[ Driver Attention Warning may
suggest a break depending on the
driver’s driving pattern or habits,
even if the driver doesn’t feel
fatigued.
[ Driver Attention Warning is a
supplemental function and may not
be able to determine whether the
driver is inattentive.
[ A driver who feels fatigued should
take a break at a safe location, even
though there is no break suggestion
by Driver Attention Warning.
Information
[ You may change settings from the
instrument cluster (User Settings) or
infotainment system (Vehicle Settings),
whichever option that is provided with
your vehicle. For more details, see
"User Settings" section in chapter 4, or
"Vehicle Settings" section in supplied
Infotainment Manual.
[ Driver Attention Warning will reset the
last break time to 00:00 in the following
situations:
- The engine is turned off
- The driver unfastens the seat belt
and opens the driver’s door
- The vehicle is stopped for more than
10 minutes
[ When the driver resets Driver Attention
Warning, the last break time is set to
00:00 and the driver’s attention level is
set to High.