instrument panel INFINITI Q60 CONVERTIBLE 2014 Quick Reference Guide

*See your Owner’s Manual for information.
01 INSTRUMENT BRIGHTNESS CONTROL*
02 TRIP COMPUTER SWITCHES
03 HEADLIGHT AND TURN SIGNAL CONTROL
04 LOW TIRE PRESSURE WARNING LIGHT
05 VEHICLE INFORMATION DISPLA y
06 WINDSHIELD WIPER AND WASHER SWITCH
07 TRIP A/B RESET BUTTON*
08 STEERING WHEEL SWITCHES FOR AUDIO* / BLUETOOTH®
09 CRUISE CONTROL
10 PUSH BUTTON IGNITION SWITCH
11 VEHICLE Dy NAMIC CONTROL (VDC) OFF SWITCH*
01
0710
19
18
20
212221
111213
14
040317
12 TRUNK RELEASE SWITCH
13 REAR SONAR S y STEM SWITCH *
14 TILT AND TELESCOPIC STEERING COLUMN*
15 INTELLIGENT KEy PORT
16 HOOD RELEASE*
17 CONTROL PANEL DISPLA y
18 AUDIO Sy STEM
19 AUTOMATIC CLIMATE CONTROLS
20 FRONT PASSENGER AIR BAG STATUS LIGHT*
21 CLIMATE CONTROLLED SEAT SWITCH ES *
22 HARD TOP OPEN / CLOSE SWITCH
(C
ONVERTIBLE MODELS )
0908
Behind
steering wheel
Behind
steering wheel
Behind
steering wheel
Behind
steering wheel
Behind
steering wheel
Behind
steering wheel
05
02
06
15
16
1276473_14a_Q60_Convertible_QRG_062113.indd 36/21/13 3:30 PM

3
Accessing the Front Cup Holders
To open the cup holders, push the lid 01 down

and release.
The flap 02 will fold down when inserting a

large container.
For more information, refer to the “Instruments and controls (section 2)” of
your Owner’s Manual.
Automatic Power Windows
y our power windows have an automatic adjusting
function to ensure windows close completely to help
seal against wind noise and weather leaks.
When the front doors are being opened, the windows
automatically lower slightly to avoid contact between
the windows and the side roof panels.
If your vehicle’s battery is discharged or
disconnected, your power window automatic
function will not operate.
Refer to your Owner’s Manual for information to
initialize your power window system.
If the power window functions do not operate
properly after initializing the system, have your
vehicle checked by an INFINITI retailer.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
01
02
Fuel-Filler Door
The fuel-filler door is located on the passenger’s side of
the vehicle.
Unlock the fuel-filler door using one of the following
operations, then push and release the left side of the
door to open.
•


Push the door handle request switch while

carrying the INFINITI Intelligent Key with you.
•


Press the
UNLOC k button on the Intelligent Key.
•


Push the power door lock switch to the UNLOCK position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
1276473_14a_Q60_Convertible_QRG_062113.indd 36/21/13 3:30 PM

Seat Adjustments
To slide the seat forward or backward, push the
control switch
01 forward or backward.
To recline the seatback, push the switch
02

forward or backward.
SEAT LIFTER
To adjust the angle of the front seat cushion or height
of the seat, push the front or rear end of the switch
01 up or down.
POWER LUMBAR SUPPORT (driver’s seat)

To adjust the seat lumbar support, push the front or back end of the swi\
tch 03 .
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (se\
ction 1)” of your

Owner’s Manual.
01
02
010203
Trunk Lid Release
Use one of the following methods to open the trunk:
Push the trunk open request switch
01 for more

than one second while carrying the INFINITI



Intelligent Key with you.
Press the trunk button hOLD on the Intelligent Key for
more than one second.
Push down on the trunk lid
release switch
02
located on the instrument panel to the left of the




steering wheel.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
5
1276473_14a_Q60_Convertible_QRG_062113.indd 56/21/13 3:31 PM

8
first drive features
Headlight Control Switch
HEADLIGHT CONTROL
Turn the headlight control switch to the
position 01 to turn on the front parking, side

marker, tail, license plate and instrument panel
lights. Turn the switch to the position

02 to turn on
the headlights.
AUTOLIGHT S
y
STEM
The autolight system will automatically turn the headlights on when it i\
s dark and off when
it is light. The system will keep the headlights on for a period of time\
after you turn the
ignition off and all doors are closed.
To activate the autolight system, turn the headlight control switch to t\
he AU t O position
03
then push the ignition switch to ON. To deactivate the autolight system, turn the headlight
control switch to the OFF,
01 or
position
02 .
HIGH BEAM SELECT
Push the headlight control switch forward 04 to
select the high beam function. The blue indicator
light
illuminates in the instrument panel. Pull
the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
Pull and release the headlight control switch 05 to

flash the headlight high beams on and off.
FOG LIGHT SWITCH
The headlights must be in the auto, or the low
beams
selected for the fog lights to operate.
Turn the switch (inside collar) to the
position
06
to turn the fog lights on.
Turn the switch (inside collar) to the
OFF position to
turn the fog lights off.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
03
01
02
04
05
06
1276473_14a_Q60_Convertible_QRG_062113.indd 86/21/13 3:31 PM

12
first drive features
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has
reached 25 mph(40 km/h).
The system will automatically maintain the set speed



until you tap the brake pedal, accelerate, cancel or




turn the system off.

To activate the cruise control, push the ON/OFF
switch
01 . The C r UISE
indicator light in the
instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the desired speed, push the COAS t /
SE
t switch

02 and release. The C r UISE SE t indicator light
in the instrument panel will
illuminate. Take your foot off the accelerator pedal. y our vehicle will maintain the set speed.
To reset at a faster cruising speed, push and hold the ACCEL/ r ES switch
03 . When the

vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAS t /SE t switch
02 . Release the

switch when the vehicle slows to the desired speed.
To cancel the preset speed, tap the brake pedal or push the CANCEL switch
04 .
To turn off cruise control, push the
ON/OFF switch
01 . The C r UISE
indicator light
in the

instrument panel will turn off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
02
0304
USB/iPod® Interface
The USB jack 01 is located in the center console under

the arm rest.
When a compatible USB memory device or iPod®
is plugged into the USB jack, compatible
audio and video files stored on the device
can be played through the vehicle’s audio
system and front display.
For more information, refer to the “Monitor, climate, audio, phone
and voice recognition systems (section 4)” of your Owner’s Manual.
01
1276473_14a_Q60_Convertible_QRG_062113.indd 126/21/13 3:31 PM

13
Intelligent Cruise Control (ICC) System (if so equipped)
VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE
To set Vehicle-To-Vehicle Distance Control mode,
press the ON/OFF button

01 for less than 1.5 seconds.

The C
r
UISE indicator light
02 will illuminate.
Accelerate to the desired speed.
Push down on the
COAS t /SE t switch
03 and release

it. Cruise control will be set to the desired speed.
Press the distance button 04 repeatedly to change

the set distance between long, middle, and short.
When a vehicle is not detected ahead of you in the
lane, the set distance and set vehicle speed indicator
lights will illuminate
05 in set mode.
When a vehicle is detected ahead of you in the lane,

the vehicle ahead detection, set distance, and set
vehicle speed indicator lights will illuminate
06 in

set mode.
To reset at a faster cruising speed, push up and hold the ACCEL/ r ES
switch
07 . When the vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push down and hold the
COAS t /SE t
switch
03 . Release the switch when the vehicle slows to the desired speed.

To cancel the preset speed, push the CANCEL switch
08 or tap the brake pedal. The set
vehicle speed indicator 05 will go out.
To turn off cruise control, press the
ON/OFF button
01 . The C r UISE indicator light
02 ,
in the instrument panel will turn off.
To set conventional (fixed speed) cruise control mode:
While cruise control is off, press the ON/OFF
button
01 and hold it down for more than 1.5
seconds. The C
r
UISE indicator light will illuminate.
Accelerate to the desired speed.
Push down on the
COAS t /SE t switch and release it. The SE t indicator light will illuminate.
Cruise control should be set to the desired speed.
To switch between the two cruise control modes:
When one of the two cruise modes is in use, you must turn the system off\
, and then turn it
on again to select the other cruise control mode.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
04
0807
03
01
0205
06
1276473_14a_Q60_Convertible_QRG_062113.indd 136/21/13 3:31 PM

16
system guide
When speaking Phonebook names, please be aware some phones require the l\
ast name
to be spoken before the first name. For example, “Michael Smith” m\
ay be spoken as
“Smith Michael”.
To cancel a voice recognition session, simply wait 5 seconds, say “C\
ancel” or “Quit”, or
press and hold the
button for 5 seconds.
To increase or decrease the volume of the voice prompts, push the volume\
control switches
or on the steering wheel or turn the VOL/ON•OFF control knob on the audio system
while the system is responding.
If the Voice Recognition system does not recognize your voice commands, \
train the system
using the Speaker Adaptation Mode. See your Owner’s Manual for detail\
ed information.
For more detailed information and instructions, refer to your cellular p\
hone Owner’s Manual
and visit www.InfinitiUSA.com/Bluetooth.
Bluetooth® System with Navigation (if so equipped)
CONNECTING PROCEDURE
The vehicle must be stationary when connecting
the phone.


1.
Press the

P h ONE button on the instrument panel or
the
button on the steering wheel and select the

“Connect Phone” key.
2.


Initiate connecting from the phone.
•


The connecting procedure varies according to each
cellular phone model. For detailed connecting
instructions and a list of compatible phones,
please visit

www.InfinitiUSA.com/bluetooth.
•


When prompted for a PIN code, enter “1234”
from the handset. (The PIN code is assigned
by INFINITI and cannot be changed).


3.

When the connecting is complete, the screen will
return to the Phone menu display.
1276473_14a_Q60_Convertible_QRG_062113.indd 166/21/13 3:32 PM