buttons INFINITI Q60 COUPE 2014 Quick Reference Guide

01
07
06
02
03
04
05
4
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock or
unlock the vehicle, open the trunk and start the engine.
It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
The operating range of the Intelligent Key is within
31.5 in (80 cm) from each request switch.
To lock the vehicle, push either door handle request
switch
01 once or press the
button
02 on the key fob.
To unlock the vehicle, perform one of the following procedures:



•

Push either door handle request switch 01 once; the

corresponding door will unlock. Push the door handle
request switch
01 again within 1 minute; all other doors

will unlock, or



•


Press the
button
03 on the key fob to unlock the driver’s

side door. Press the
button again; all other doors will unlock.
To release the trunk lid, press the hOLD button
04 for more than

1 second. Lift the trunk lid to access the trunk.
To retract the hard top (Convertible models), push and hold the
door handle request switch
01 until the hard top is fully open.
The Intelligent Key can also be used to activate the panic alarm by pres\
sing and holding the

button
05 for more than 1 second. Once activated, the panic alarm and headlights w\
ill
stay on for a period of time.
INFINITI INTELLIGENT KE
y BATTER y DISCHARGE
If the battery in the Intelligent Key is almost
discharged, the guide light
06 of the Intelligent

Key port blinks and the Intelligent Key battery
discharge indicator
07 is displayed in the vehicle

information display.
To start the engine under these circumstances, insert
the Intelligent Key into the key port with the buttons
facing upward and the key ring end toward you until
it latches into place. Then push the ignition switch to
start the engine.
To remove the Intelligent Key from the port, push the
ignition switch to turn the engine off and then pull the
Intelligent Key out of the port.
The Intelligent Key port does not charge the Intelligent Key battery. If\
you see the low battery
indicator
07 , replace the battery in the Intelligent Key.
Do not insert the mechanical key or any other objects into the key port \
because it will

damage the key port.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
1276473_14a_Q60_Convertible_QRG_062113.indd 46/21/13 3:31 PM

21
HomeLink® Universal Transceiver
The HomeLink® system can learn and consolidate the functions of up to 3 different
hand-held transmitters, operating items such as garage doors, property g\
ates, outdoor and
indoor lights or alarm systems.
To program the Homelink® Universal Transceiver:



•


Position the handheld transceiver 1-3 in (26-76 mm) away from the Home\
link® surface,
keeping the Homelink® indicator light in view.



•


Press and hold the desired Homelink® button and the handheld transmitter button
simultaneously until the Homelink® indicator light flashes slowly and then rapidly.



•


Both buttons may be released when the indicator light flashes rapidly.
To verify the programing is complete, press and hold the Homelink® and observe the
indicator light:



•


A solid continuous light indicates the programing is complete and the Ho\
melink®
button will activate your device.



•


A blinking light that turns to a solid continuous light after 2 seconds \
indicates
additional steps are required to complete the programing.
An additional person may make the remaining steps easier. To complete th\
e
programing process:



•

At the receiver of the device that you are programing to the Homelink®, press and
release the “learn” or “smart” button (the name may vary by\
manufacturer but it is
usually located near where the hanging antenna wire is attached to the u\
nit).
y ou have
approximately 30 seconds to initiate the following step.



•


Press and hold the programmed Homelink® button for 2 seconds and release.
Repeat the previous 2 steps up to 3 times to complete the programming pr\
ocess.
Homelink® should now activate your device.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual, the HomeLink® website at
www.homelink.com or call 1-800-355-3515.
HOMELINK®
1276473_14a_Q60_Convertible_QRG_062113.indd 216/21/13 3:32 PM