tow INFINITI Q70 2019 Quick Reference Guide

8
Cruise Control
CONVENTIONAL CRUISE CONTROL (if so equipped)
SETTING A CRUISING SPEED
•


Push the CR

UISE ON/OFF switch
to turn on the system.
•


With the

vehicle at the desired speed, push down the switch
2 to COAST/SET to
enable cruise control.
•


The cruising speed c

an be adjusted to a higher or lower speed by pushing the
control switch
2 up or down.
CANCELING THE PRESET SPEED
•


Push the CANCEL switch
3 or tap the brake pedal.
INTELLIGENT CRUISE CONTROL (ICC) (if so equipped)
The ICC system is designed to maintain a selected distance from the vehicle in front of
you and reduce the speed to match a slower vehicle ahead.
•


T

o increase the distance to the vehicle ahead to be maintained by the ICC system,
push the distance switch
4 until the display shows the desired set distance, which
is shown by the number of lines on the set distance indicator
5.
•


When a

vehicle is detected ahead, a car icon will illuminate on the vehicle ahead
detection indicator
6 and your vehicle will reduce the speed to match the
slower vehicle.
To use Conventional (fixed speed) Cruise Control mode (if so equipped):
•


While cruise c

ontrol is off, push and hold the CRUISE ON/OFF switch
for more
than 1.5 seconds. The CRUISE indicator light will illuminate.
•


A

ccelerate to the desired speed.
•


Push the swit

ch
2 down toward COAST/SET and release it. The SET indicator
light will illuminate.
Please see your Owner’s Manual for important safety information, system limitations, and additional operating and
feature information.
INTELLIGENT CRUISE CONTROL (ICC) (if so equipped)

3
2
2

3
4Lo rem ipsu m
56

14
Move the lever up or down to one of
the following positions to operate the
windshield wipers:
MIST One sweep operation
OFF Wipers are OFF
AUTO Rain-sensing automatic wipe
LO Continuous wipe, slow
HI Continuous wipe, fast
To adjust the wiper sensitivity for the AUTO
setting, twist the control ring
2.
Pull the lever
toward you operate the
windshield washer.
To turn the rain-sensing automatic wiper
system off, push up the lever to the OFF
position, or pull down the lever to the LO or
HI position.
Wiper and Washer Switch
SYSTEM OPERATING TIPS
• The interior of the vehicle should be as quiet as possible.
• Speak naturally. Speaking too fast, too slow, too soft, or too loud makes voice recognition more difficult.
• Confirm that the correct voice commands are being used. Glance at the screen to see the currently
available commands.
USING THE VOICE RECOGNITION SYSTEM
• Press the
button on the steering wheel, and a
list of commands will appear on the screen.
• After the tone sounds, speak the command.
• To skip the voice prompt and give the command immediately, press the
button on the steering
wheel to interrupt the system. Speak the next
command after the tone sounds.
• To cancel the command, press and hold the
button
on the steering wheel.
Please see your INFINITI InTouch™ Owner’s Manual for important
safety information, system limitations, and additional operating and
feature information.
Voice Recognition
PULLING UP THE WIPER ARM
The wiper arm should be in the UP
position when replacing the wiper.
• With the shift lever in the P (PARK) position, place
the ignition switch in the
OFF position.
• Within 1 minute, push the wiper switch to the MIST
position twice. The wiper
operation stops in mid-
operation and the wiper arm
can be pulled up.
• To return the wiper arm, place the wiper arm in the DOWN
position and operate the wiper
switch once.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.

2