ECO mode INFINITI QX60 2014 Quick Reference Guide

8
essential information
Tire Pressure Monitoring System (TPMS) with Tire Inflation Indicator
A Tire Pressure Low – Add Air warning message
will appear in the vehicle information display
01
and the low tire pressure warning light 02 will
illuminate when one or more tires are low on
pressure and air is needed.
•
The tire pressures should be checked when the


tires are cold. The tires are considered cold after
the vehicle has been parked for 3 hours or more
or driven less than 1 mi (1.6 km) at
moderate speeds.
When adding air to an under-inflated tire, the TPMS
with Tire Inflation Indicator provides visual and
audible signals to help you inflate the tires to the
recommended COLD tire pressure.
To use the tire inflation indicator:
1.


Move the shift lever to the
P (PARK) position and apply the parking brake.
2.


Place the ignition switch in the
ON position. Do not start the engine.
3.


Add air to the under-inflated tire and within a few seconds, the hazard \
warning lights will
start flashing.
4.


When the designated tire pressure is reached, the horn will beep once an\
d the hazard
warning flashers will stop flashing.
5.


Repeat this procedure for any additional under-inflated tires.
After tire pressures are adjusted, drive the vehicle at speeds above 16 \
MPH (25 km/h).
The Tire Pressure Low – Add Air warning message and low tire pressure warning light
will disappear.
When the low tire pressure warning light flashes for approximately 1 min\
ute and then
remains on, the TPMS is not functioning properly. Have the system checke\
d by an
INFINITI retailer.
Tire pressure rises and falls depending on the heat caused by the vehicl\
e’s operation and
the outside temperature. Low outside temperature can lower the temperatu\
re of the air
inside the tire, which can cause a lower tire inflation pressure. This m\
ay cause the low
tire pressure warning light to illuminate. If the warning light illumina\
tes, check the tire
pressure in your tires.
•
Check

the tire pressure (including the spare tire) often and always prior to long

distance trips.
The Tire and Loading Information label contains valuable information. Pl\
ea se refer to
section 9, “Technical and consumer information” in your Owner’s\
Manual for the location
of the Tire and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
01
02
1591599_14b_Infiniti_QX60_QRG_100913.indd 810/9/13 11:09 AM

11
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock or unlock your
vehicle, open your liftgate and remotely start the engine. It is importa\
nt to
make sure the Intelligent Key is with you (that is, in your pocket or p\
urse).
REMOTE ENGINE START* (if so equipped)
The remote engine start system must be enabled in the vehicle
settings within the vehicle information display.
The remote engine start operating range is approximately 200 ft (60 m)\

from the vehicle. The effective operating range may be shorter due to
environmental conditions or obstacles between you and the vehicle.
For the remote engine start to function, the vehicle must be in
the P (PARK) position with the ignition off, and all the doors closed
and locked.
To start your vehicle remotely:



1.

Press the button
01
2. Within 5 seconds press and hold the remote engine start
button
02 for at least
2 seconds.
The engine will start and the parking lights will turn on.
Automatic climate control will begin heating or cooling the vehicle depe\
nding on the last
used mode.
The engine will run for 10 minutes and then turn off.
Repeat steps 1 and 2 to extend the time for an additional 10 minute peri\
od.

•
After
two remote starts the ignition switch must be cycled before the remote start can be
used again.
To start driving depress the brake pedal and push the ignition switch START/STOP button.
LOCKING AND UNLOCKING THE VEHICLE
The lock and unlock operating range of the
Intelligent Key is within 31.5 in (80 cm) from
each request switch.
To lock the vehicle, push either door handle



request switch 03 once or press the
button
01
on the key fob.
To unlock the vehicle, perform one of the following procedures:

•
Push
either door handle request switch
03 once; the corresponding door will unlock.
Push the door handle request switch again
within 30 seconds; all other doors
will unlock, or
• Press

the
button
04 on the key fob to unlock the driver’s side door. Press the



button

again;

all

other

doors

will

unlock.
*Laws in some communities may restrict the use of remote starters. Check\
local regulations before using this feature.
02
01
04
05
06
03
1591599_14b_Infiniti_QX60_QRG_100913.indd 1110/9/13 11:09 AM

19
Rear Climate Controls
To activate the system:



1.
Press the REAR button

01 on the front control panel until Rear Air-conditioning screen
is displayed.
•

The

indicator

light

will

illuminate.
08 DEFROSTING/DEFOGGING FRONT AND SIDE WINDOWS
Press the defroster control button to turn the system on. The A/C automatically
turns on when the defroster mode is selected. This feature removes humid\
ity from
the air.
To defrost the front and side windows, set the temperature controls 03 and fan
speed controls 07 to their maximum settings.
09 DEFROSTING REAR WINDOW AND OUTSIDE MIRRORS
Push the rear window defroster switch
to turn the system on or off. This function automatically turns off after approximately 15 minutes.
10 REAR AIR CONDITIONER To control the rear automatic air conditioning

system with the front air conditioner control
panel, press the REAR button.
When the rear automatic air conditioning system
is on, the indicator light on the
REAR button will
illuminate and the front display will switch to the
rear air conditioner screen. Use the driver
temperature and fan speed buttons to adjust settings.
To adjust the front air conditioning system, press the REAR button again.
To turn off the rear automatic air conditioning system from the front co\
ntrols, press
the REAR button until the Rear Air-conditioning screen is displayed. Then press the
OFF button.
The rear control buttons will not function when Rear Air-conditioning screen is shown
on the front display.
11 INTAKE AIR CONTROL BUTTON
Press the intake air control button to recirculate interior air inside the vehicle. The
indicator light on the button will illuminate. This system is used to a\
void certain
outside odors and helps to adjust the inside vehicle temperature more ef\
fectively.
The air recirculation mode cannot be activated when the climate control \
sys tem is in the
front defrost mode
or front defrost and foot vent mode
.
Press the intake air control button again to change the air circulation from the
intake air to the outside air. The
indicator light on the button will turn off.
12 OFF BUTTON Press the
OFF button to turn the climate control system off.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
1591599_14b_Infiniti_QX60_QRG_100913.indd 1910/9/13 11:09 AM

first drive features
Intelligent Cruise Control (ICC) System (if so equipped)
VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE
To set Vehicle-To-Vehicle Distance Control mode,



press the
CRUISE ON/OFF button
01 for less than 1.5
seconds. The
CRUISE indicator light
02 will illuminate.
Accelerate to the desired speed.
Push down on the
COAST/SET switch
03 and release
it. Cruise control will be set to the desired speed.
Press the distance button 04 repeatedly to change
the set distance between long, middle, and short.
Wh en a vehicle is not detected ahead of you in



the lane, the set distance and set vehicle speed




indicator lights will illuminate 05 in set mode.
When a vehicle is detected ahead of you in the lane,



the vehicle ahead detection, set distance, and set



vehicle speed indicator lights will illuminate 06 in set mode.
To reset at a faster cruising speed, push and hold the
ACCEL/RES
switch
07. When the vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAST/SET
switch
03. Release the switch when the vehicle slows to the desired speed.
To cancel the preset speed, push the CANCEL switch
08 or tap the brake pedal. The set
vehicle speed indicator 05 will go out.
To turn off cruise control, press the
CRUISE ON/OFF button
01. The CRUISE indicator light

02, in the instrument panel, will turn off.
To set conventional (fixed speed) cruise control mode:
While cruise control is off, press the CRUISE ON/OFF
button 01
and hold it down for more
than 1.5 seconds. The
CRUISE indicator light will illuminate.
Accelerate to the desired speed.
Push down on the COAST/SET switch and release it. The SET indicator light will illuminate.



Cruise control will be set to the desired speed.
To switch between the two cruise control modes:
When one of the two cruise modes is in use, you must turn the system off\
, a nd then turn it
on again to select the other cruise control mode.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
0403
0708
0205
06
To cancel the preset speed, push the CANCEL switch
04.
To turn off cruise control, push the CRUISE
ON/OFF switch
01. Both the
CRUISE indicator
light
and the

SET indicator light in the instrument panel will turn off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
22
1591599_14b_Infiniti_QX60_QRG_100913.indd 2210/9/13 11:09 AM

Vehicle Information Display
The vehicle information display 01 displays such
items as:
Vehicle settings Trip computer information Drive system warnings and settings
(if so equipped)
Cruise Control System Intelligent Cruise Control (ICC) System
(if so equipped) information
Intelligent Key operation information Indicators and warnings Tire pressure information
USING THE VEHICLE INFORMATION DISPLA
y
The vehicle information display modes can be changed


using the
button
02 and ENTER button 03
located
on the steering wheel.
1.


Press
02 to enter the vehicle information menu items.
2.


Press 04 to navigate through the items in vehicle information.
4.


Press

ENTER
03 to change or select an item in the vehicle information display.
5.


Press 05 to go back to the previous menu.
START UP DISPLA y
When the vehicle is placed in the

ON or ACC position the screens that display in the vehicle
information include:
Active system status (if so equipped) Trip computer Tire pressure information Fuel economy Warnings (displays when a warning is present)
RESETTING THE TRIP COMPUTER
1.

Press the
button
02 until you reach the Trip
computer mode 06.
2.


Press the
button again for more than 1.5
seconds to reset average fuel consumption,
average speed, distance to empty and journey time.
01
system guide
03
02
04
05
06
24
1591599_14b_Infiniti_QX60_QRG_100913.indd 2410/9/13 11:09 AM

25
Bluetooth® Hands-free Phone System
A cellular telephone should not be used while driving
so full attention may be given to vehicle operation.*
S
y
STEM OPERATING TIPS
Press the or button to interrupt the voice

prompts at any time and speak a command after
the tone.
The “Help” command can be used to hear a list of
available commands at any time.

Reduce background noise as much as possible by
closing windows and pointing HVAC vents away from
the ceiling.
Speak naturally without long pauses and without
raising your voice.
When speaking phonebook names, please be aware
some phones require the last name to be s
poken
before the first name. For example, “Michael Smith”
may be spoken as “Smith Michael”.
To cancel a Voice Recognition session, say “Cancel” or
“Quit” or press and hold the

or
button for 5 seconds.
To go back to the previous command, say “Go back” or “Correctio\
n”.

If the Voice Recognition system does not recognize your voice commands, \
train the system
using the Speaker Adaptation Mode. See your Owner’s Manual for detail\
ed information.
For more detailed information and instructions, refer to your cellular p\
hone’s Owner’s Manual and
visit ww.InfinitiUSA.com/bluetooth.
*Some jurisdictions prohibit the use of cellular telephones while drivin\
g.
Bluetooth® Controls
Microphone
SETTINGS
The setting mode allows you to change the information displayed in the v\
ehicle
information display:
Driver Assistance (if so equipped)
Main Menu Selection Body Color Maintenance Alarms
Vehicle Settings
Language Unit Welcome Effects
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
1591599_14b_Infiniti_QX60_QRG_100913.indd 2510/9/13 11:09 AM

31
Theater Package (if so equipped)
With this Entertainment System, you can play video
files via a DVD or CD providing images and sound
both from the front and rear display screens.
y ou can also connect auxiliary devices such as
video games, camcorders or portable video players
to the auxiliary jacks
01 located on the back of the
center console. (
y
our device will be controlled
through its own control panel.)
Rear Auxiliary Mode allows rear seat passengers
to independently display different sources on
each screen.
Use the remote controller 02, provided with the
system, to operate the rear display screens.
Use the headphones 03, also provided with the
system, to listen to audio wirelessly and
independently.
y
ou may also connect your own
wired-headphones to the headphone jacks
04
located on the back of the center console.
For optimum performance, select the appropriate
headphone channel
05 that corresponds to the
headrest display being viewed directly in front of you.
To watch or control videos on the front display make
sure the vehicle is in the P (PARK) position and the
parking brake is applied.
To reduce driver distraction, the wireless headphones will not
operate while located in the front seats and movies will not be
shown on the front display while the vehicle is in any drive position.
To access standard DVD controls on the front display while play ing a
DVD on the rear display, press the DISC•AUX button on the audio
control panel while the vehicle is in the P (PARK) position and the
parking brake is applied.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems
(section 4)” of your Owner’s Manual.
09 – Press to switch between the day screen (bright) and the night sc\
reen (dark). Press
and hold the button to turn the display off. Press again to turn the dis\
play on.
10 BACK – Press to return to the previous screen. In a settings screen, this\
button can also
be used to apply the setting. In a character input screen, this button c\
an also delete the
characters that have been entered.
11 VOICE – Press to hear the current voice guidance for a programmed route.
For more information, please refer to your Navigation System Owner’s \
Manual.z
05
04
01
02
03
1591599_14b_Infiniti_QX60_QRG_100913.indd 3110/9/13 11:09 AM