climate settings INFINITI QX60 2018 Quick Reference Guide

10
Remote Start* (if so equipped)
To start your vehicle remotely, press the
button 1 on the Infiniti Intelligent Key, and
within 5 seconds, press and hold the remote
engine start
button 2 for at least
2 seconds.
• Automatic climate control will begin
heating or cooling the vehicle based
on the temperature inside and outside
the vehicle.
• The engine will run f or 10 minutes and
then turn off. To extend the time for
an additional 10-minute period, repeat
the procedure.
• To start driving, depress the brake pedal
and press the ignition switch START/STOP button.
Remote start can be enabled or disabled through the vehicle
information display.
HEATED STEERING WHEEL (if so equipped)
The heated steering wheel may be activated during remote
engine start when outside and cabin temperatures are low.
During remote start, the heated steering wheel switch will be
inoperable until the ignition switch is turned on.
* State laws may apply; review local laws before using.Please see your Owner’s Manual for important safety information, system limitations,
and additional operating and feature information.
1
2
Two positions for the driver’s seat,
steering column and outside mirrors
can be stored in the automatic
drive positioner memory. To set a
memory position:
1. Place the ignition switch in the
ON or ACC position. (The vehicle
should be stopped while setting
the memory.)
2. Adjust the driver’s seat, steering column and outside mirrors to the
desired positions using the adjusting switches for each feature.
3. Push the SET switch 1, and within 5 seconds, push the memory
switch (1 or 2) 2. The indicator light for the memory switch you select
will illuminate for approximately 5 seconds and a chime will sound
when the memory is stored.
4. Press the unlock button on the key fob to link the memorized position
to your Infiniti Intelligent Key.
The driver’s seat and steering column will automatically move when the
shift lever is in the P (PARK) position to allow the driver to get in and out
of the driver’s seat more easily. “Exit Seat Slide” and “Exit Steering UP” can
be disabled in the vehicle information display under “Vehicle Settings”.
Please see your Owner’s Manual for important safety information, system limitations, and
additional operating and feature information.
Automatic Drive Positioner
(if so equipped)
2 1

11
Heater and Air Conditioner (automatic)
• Press the AUTO button 1 to turn the system on and automatically control the
inside temperature.
• Press the CLIMATE button 2 to adjust the automatic climate controls using
the climate settings on the control panel display screen.
• Use the driver’s side 3 or passenger’s side 4 control buttons (warmer air)
or
(cooler air) to control the desired side’s temperature.
• Press the air flow control button 5 to manually cycle through the available air
flow modes.
• Press the DUAL button 6 to turn the system on and off.
• Press the fan speed control buttons 7 to increase or decrease the fan speed.
• Press the front defroster button 8 to turn the front defroster system on and
off, and use the temperature control buttons 3 to change the temperature.
• To defrost the rear window and outside mirrors, push the rear defroster
switch 9 to turn the system on and off.
• Press the intake air control button 10 to recirculate the air inside the vehicle.
• Press the OFF button 11 to turn the climate control system off.
4
3
5 6
12
REAR CONTROLS
• Press the REAR ON-OFF button 12 to turn the rear
air conditioner on and off.
• Press the OFF button 13 to turn the system off.
• Adjust the fan speed up or down using the control
buttons
14.
• Press the AUTO button 15 to turn on the
automatic mode.
• Adjust the temperature up or down using the TEMP
buttons
16.
Please see your Owner’s Manual for important safety information, system
limitations, and additional operating and feature information.
10
13 14
15
16
1 2 8 9 11 7